I need help finding the signals, chemical shifts and splliting for the IR structure and C13 NMR structure. inclexhycrogendiffiunyC8 Hg NOI HD= 2C+2-HChemical Formula: C8H5NO1= 2(6)+ 2 -510213ミ6、5(エHD)2350030002500200015001000500Wavelength (cm-1)IR2720015010050б (ppm)C13 NMR31/02.2.06.4210841H NMR: 6 7.84 (2H, d, J = 8.5 Hz), 7.98 (2H, d, J = 8.5 Hz), 10.03 (1H, s).IRTransmittance (%)OTHstretch

IR: infrared spectroscopy tells about the functional groups present in the structure with the strong…

inclex hycrogen diffiuny c8 Hg NO I HD - 2C +2-H Chemical Formula: C8H5NO 1 = 2 (6)+ 2 -5 10 2 = 13 = 6.5 (IHC 2 3500 3000 2500 Wavelength (cm-1) 2000 1500 1000 500 IR (2 200 150 100 50 5 (ppm) C13 NMR 3 1|0 2.0.0 10 8 6 4 1H NMR: 6 7.84 (2H, d, J = 8.5 Hz), 7.98 (2H, d, J= 8.5 Hz), 10.03 (1H, s). IR Transmittance (%)

inclex hycrogen diffiuny c8 Hg NO I HD - 2C +2-H Chemical Formula: C8H5NO 1 = 2 (6)+ 2 -5 10 2 = 13 = 6.5 (IHC 2 3500 3000 2500 Wavelength (cm-1) 2000 1500 1000 500 IR (2 200 150 100 50 5 (ppm) C13 NMR 3 1|0 2.0.0 10 8 6 4 1H NMR: 6 7.84 (2H, d, J = 8.5 Hz), 7.98 (2H, d, J= 8.5 Hz), 10.03 (1H, s). IR Transmittance (%)

Principles of Instrumental Analysis

7th Edition

ISBN:9781305577213

Author:Douglas A. Skoog, F. James Holler, Stanley R. Crouch

Publisher:Douglas A. Skoog, F. James Holler, Stanley R. Crouch

Chapter20: Molecular Mass Spectrometry

Section: Chapter Questions

Problem 20.11QAP

See similar textbooks

Similar questions

The Ksp of PbF2 is 3.3 x 10^-8
Calculate the concentration of a solution of peptide AWSME, in mM if the absorbance at 280 nm for the solution is 0.6 absorbance units, and a 0.2-cm cuvette is used. For the extinction coefficient, take into account that e280(Trp) = 5690 M-1 cm-1 and e280(Tyr) = 1280 M-1 cm-1. Round your answer to two decimals.
Find the [FeSCN^2+]eq ε=4.0×10^3 M-1 cm^-1 at 447 nm
Record your absorbance data for the YELLOW and RED dyes below. Calculate the dye concentration in mM for each cuvette using M1V2 = M2v2 . Remember the concentration of stock solutions (100^ % dye) is 0.020 mM(mM= millimolar =mm /L). Data for YELLOW: peak absorbance used on spectrophotometer =420nm Cuvette 1 - 100% dye = 0.680 absorption Cuvette 2 - 75% dye = 0.510 absorption Cuvette 3 - 50% dye = 0.340 absorption Cuvette 4 - 25% dye = 0.170 absorption Data for RED - peak absorption used on spectrophotometer = 500nm Cuvette 1 - 100% dye: 0.621 absorption Cuvette 2 - 75%: 0.466 absorption Cuvette 3 - 50% dye: 0.311 absorption Cuvette 4 - 25% dye: 0.1555 absorption
Mass spectral measurements were made on 10 replicate low concentration Cd-EDTA samples: 181.5, 148.5, 158.5, 173.5, 142.5, 211.9, 163.5, 168.1, 157.5, and 175.1 counts. Ten measurements of a blank had a mean measurement of 42.1 counts. A sample containing 2.00 µM Cd-EDTA gave a measurement of 1827 counts. Estimate the signal and concentration detection limits for Cd-EDTA. signal detection limit: counts concentration detection limit: µM
You obtained the following raw data when setting up a Bradford standard curve: BSA (mg/ml) Absorbancy 595nm 0 0.225 1 0.310 2 0.420 3 0.510 4 0.610 5 0.720 6 0.810 7 0.915 8 0.950 9 0.980 10 0.990 After blanking against a bradford-dH2O sample, the protein concentration of an unknown sample was determined using the same method and an absorbancy of 0.523 was obtained. Set up a standard curve, excluding outliers (experimental and statistical) and determine the protein concentration in the unknown sample in mg / ml (up to 3 significant figures).
Exactly 10.00-mL aliquots of a solution containing phenobarbital were measured into 50.00-mL volumetric flasks and made basic with KOH. The following volumes of a standard solution of phenobarbital containing 2.000μg/mL of phenobarbital were then introduced into each flask and the mixture was diluted to volume: 0.000, 0.500, 1.00, 1.50, 2.00 mL. The fluorescence of each of these solutions was measured with a fluorimeter, which gave values of 3.26, 4.80, 6.41, 8.02, 9.56, respectively. a. plot the data. b. derive a least squares equation for the data plotted in (a). c. find the concentration of phenobarbital from the equation in (b). d. calculate a standard deviation for the concentration obtained in (c).
Iam stuck on how to start this problem. Youo are presented with a sample of freshly squeezed carrot juice and are asked to determine how much beta-carotene is presented in the juice. A beer's Law plots is constructed from the absorbances at 451 nm for six standard solutions of beta-carotene, with concentrations ranging from 0.75-7.5 µM. Linear regressions data: y=0.1431x-0.0078(R2=0.9998) a)The carrot juice is diluted by one-fourth, and the absorbance at 451 nm of this solutions is measured to be 0.676. Based on this information, what is molor concentration of beta-corotene in the original(undilited) sample of carrot juice? b) If the original sample of carrot juice was 312 mL, calculated the mass(g) of beta-carotene presented
Calculate the resolution required to resolve the following peaks; i) CH3N+ (MW = 28.0187) and N2+ (MW = 28.0061) ii) C2H4+ (MW = 28.0313) and CO+ (MW = 27.9949) iii) C3H7N3+ (MW = 85.0641) and C5H9O+ (MW = 85.0653) iv) 116Sn+ (At W = 115.90219) and 232Th2+ (At W = 232.03800)
Based on the chromatograms, Symmetry C18 (top) is less selective than Symmetry Shield RP18 (bottom) for the analytes given, true or false?
Using a 60 MHz spectrometer, a chemist observes the following peak: doublet, J = 7 Hz, at 2.50 ppm What would be the chemical shift of this same peak as measured by a 300 MHz spectrometer? (Include units.)
You obtained the following raw data when setting up a Biuret standard curve: BSA (mg/ml) Absorbancy 540nm 0 0.158 1 0.210 2 0.260 3 0.305 4 0.360 5 0.410 6 0.455 7 0.510 8 0.530 9 0.550 10 0.554 After blanking against a biuret-dH2O sample, the protein concentration of an unknown sample was determined using the same method and an absorbancy of 0.251 was obtained. Set up a standard curve, excluding outliers (experimental and statistical) and determine the protein concentration in the unknown sample in mg / ml (up to 3 significant figures).