Answered: Use the information provided below to…

Use the information provided below to determine the formula for the unknown compound. Intensity of Base 57.7% Peak 118 (M1+) 119 3.85 120 2.62

Introductory Chemistry: An Active Learning Approach

6th Edition

ISBN:9781305079250

Author:Mark S. Cracolice, Ed Peters

Publisher:Mark S. Cracolice, Ed Peters

Chapter22: Biochemistry

Section: Chapter Questions

Problem 7E

See similar textbooks

Related questions

Q: 3. Which of the following statements best describes a non-specific assay? directly measures the…

A: Which of the following statements best describes a non-specific assay? directly measures the…

Q: Use the simulation lab to obtain the distance for the solvent front and the distance for each spot…

Q: Given the following values, use the absorbance formula to find the hemoglobin concentration of…

A: #1: Given the absorbance of standard solution, As = 0.600 concentration of the standard solution,…

Q: 0.3872g of an unknown weak acid with general formula HY, was dissolved in water and made up to a…

A: Since HY has 1 replaceable H, it is a monoprotic acid. Equation for the association of HY is: HY(aq)…

Q: Acetone is the compound used to measure tM- : Write down the order of polarity of the compounds from…

A: Polarity is determined by Number of Polar group present in the molecule.

Q: The compound eluted last and retained more in Normal phase Chromatography are: A. Polar compounds B.…

A: In normal phase chromatography, the stationary phase is Polar

Q: 15. Rank the order you would expect the following samples to elute during SEC: 4 Phosphatidylcholine…

A: We know Smaller-sized molecules have more pores that are accessible to them and therefore spend more…

Q: Find (M) for [FeSCN^2+] using the following info: 0.200 M (Iron (III) nitrate) Fe(NO3)3 (mL) = 17.98…

A: The volume of 0.200 M Fe(NO3)3 solution is 17.98 mL. The volume of 0.200 M KSCN solution is 1.97 mL.

Q: You obtained the following raw data when setting up a Biuret standard curve: Absorbancy 540nm BSA…

A: A question based on tools in analytical chemistry that is to be accomplished.

Q: Tou were tasked to check if the liquid sample you have is a substance or a mixture Which among these…

A: NOTE: Since you have asked multiple questions, we will solve the first question for you. If you want…

Q: En la titulación de 25.00 mL del ácido diprótico ácido butírico (Illamémosle H2B) 0.100 M con KOH…

Q: An unknown compound is suspected to be acetanilide (mp 113.5-114). What would happen to the melting…

A: Given information: The unknown compound is estimated to be acetanilide. The melting point of the…

Q: Calculate Kb for a 0.1 M solution of acetate ion, given that Ka for acetic acid is 1.8 x 10−5.

A: Given : Ka = 1.8 x 10-5

Q: SCI2 8. What do you notice about the compounds under Cl2 -1 the melting point column that have…

A: MELTING POINT : This is the temperature at which a solid become a liquid. When we increase the…

Q: Compound X was dissolved in a 5-mL volumetric flask. A 1.00-mL aliquot of the compound was placed in…

A: Given, Absorbance = 0.427 Cuvette length = 1.00 cm Molar absorptivity = 6130 M-1 cm-1 Molecular…

Q: A student tested water with 2% NaCl as a possible solvent for the separation of a mixture that could…

A: 2% of NaCl is the possible solvent for the separation of a mixtures G3 Y5 R3 B1. a) The distance…

Q: Pre-Lab Questions 1. Define a protein, and describe one important function of proteins in the human…

A: Hello. Since you have posted multiple questions and not specified which question needs to be solved,…

Q: This is an output from an HPLC experiment. The column was packed with extremely hydrophobic grains.…

A: HPLC High performance liquid chromatography . This technique is based on the adsorption by which the…

Q: 7. Fill the absorbance value below; Path length % T 0.2 0.4 0.6 0.8 1.0 25 12.5 6.25 3.125 100 50…

A: The objective of the question is to fill the table with the correct absorbance values for the given…

Q: Coven Caluim Chloride Soluleitity 8 0.45g/100m2 of Solution Find the ksp of CaCl₂ ? (il 4.9x10-5…

A: solubility = 0.45 g/100 mL We need to find Ksp. ]

Q: 6) You are given a mixture of organic compounds suspected of containing various amines (e. g.…

A: Solvent extraction- It is a technique used to separate compounds based on their relative solubility…

Q: Please choose an appropriate technique(s) to separate following compounds (it can be one, more than…

A: Column chromatography is a technique in which we can separately get components on the basis of…

Q: Analysis of Percent Organic Matter of * a soil sample was conducted and the data are shown below.…

Q: Biuret Assay accurately quantify protein concentration within the range of 5-150 mg/mL. JUSTIFY THE…

Q: Given the following alpha fraction plot, what is the pK31 of the polyprotic acid? 1.0000 0.8000…

Q: How would you change the mobile phase to decrease the Rf for both spots? If you started with 1:10…

A: Given Rfa = 0.70 and Rfb = 0.20. Solvent System 1:10 ethyl acetate to hexane

Q: During an assay of paracetamol by UV an analyst prepares a series of calibration solutions…

A: The concentration of a solution is calculated by the formula: Concentration=Number of molesVolume of…

Q: 3) 3-Methylbutyramide 100 CHINO 101 R28888 CH₂N relative intensity relative abundance 4)…

Q: Determining the concentration of unknown solution using uv-vis spectroscopy. The absorbance vs…

Q: Below is the procedure described for determination of paracetamol according to BP: "Weigh and powder…

A: Here the question describes the procedure to analyze the paracetamol content in a tablet.…

Q: A health care provider ordered sulfasalazine (Azulfidine) Oral Susp 500 mg q 6 hr; Directions for…

A: Drug formulation is the mixture containing active component along with inert components. The dosage…

Q: Use the simulation lab to obtain the distance for the solvent front and the distance for each spot…

A: Rf value can be calculated using the expression: Rf=Distance travelled by the componentDistance…

Q: Given the following concentrations of aqueous ions as well as their atomic weight or molecular…

Q: 1)What is the concentration of the final diluted solution in mcg/mL?(1 decimal) 2) What volume of…

A: Mass of paracetamol = 140.1 mg Volume of solution = 200 mL Concentration = 140.1…

Q: 5. (1) (ii) Ibuprofen (206.3 g/mol) absorbs at 255 nm and shows a molar absorptivity of 3010…

Q: Given the following alpha plot of fractional compositions shown below, the compound is Analytical…

A: The alpha plot of fractional composition shown above is -

Q: concentration iron(II) nitrate 0.00400 0.00400 0.00400 0.00400 0.00400 (Fe(NO3)3l (M) Concentration…

A: Balanced Chemical Reaction is as follows : Fe +3. + SCN- ----> FeSCN2+

Q: Lab Data Verify your concentration value. Did you report your data to the correct number of…

A: The given data is: Solution Dye concentration Absorbance 1 30.20 0.800 2 15.10 0.441 3 7.56…

Q: During an assay of paracetamol by UV an analyst prepares a series of calibration solutions…

A: Dilution equation is C1V1=C2V2 where C1 and C2 are concentration of stock and diluted solution while…

Q: Explain the reactions involved in separation separation of benzoic acid from mixture contain…

A: Extraction It is the separation technique in which the desired compound is extracted using two…

Q: QUESTION 1 You obtained the following raw data when setting up a Biuret standard curve: BSA (mg/ml)…

A: Given: absorbance of unknown sample = 0.284 To find: Set up a standard curve, determine the protein…

Q: What is the structure of the compound which gives rise to this data? Explain your reasoning. 3. C7…

A: Given molecular formula is C7H7NO3

Q: A student tested water with 2% NaCl as a possible solvent for the separation of a mixture that could…

A: 4 a) The distance of the solvent front can be measured by a ruler. For this, match zero on your…

Q: Name Melting point (°C) Unknown 121-122 Mandelic acid 120 Benzoic acid 123 Unknown + Benzoic acid…

A: Melting point of a substance is used to determine the purity of a substance. Melting points of…

Q: PART 2. DETERMINATION OF THE CONCENTRATION OF A STRONG ACID SOLUTION EXPERIMENTAL DATA The total…

A: Given:

Q: Relative Intensity 100 60 40 8 / Find out the functional group 10 20 50 40 50 60 70 1860 my 2000 Wer

Q: 3. A standard lactose solution contained 0.45 mg/mL of lactose and 2 mL were used for the…

Q: To 4-5 drops of an unknown alcohol, 1 mL of Lucas reagent (ZnCl2 + HCl) is mixed. No cloudiness or…

A: Lucas reagent is made up of ZnCl2 mixed with HCl. When Lucas reagent is mixed with an primary…

Q: Identify the parent and propose a structure for the base peak in the massspectrum of butan-1-amine.

A: Mass spectrometry is used to detect the mass-to-charge ratio of the molecular ion. A plot of…

Concept explainers

Micelles and Biological Membrane

Micelles are the type of lipid molecules that organize themselves in spherical shape in aqueous solutions. The production of the micelle is a reply to the amphipathic behavior of fatty acids. It means that they consist of both hydrophobic regions and hydrophilic regions. In micelles, polar head groups (hydrophilic groups) produce an outer layer associated with water whereas nonpolar tails (hydrophobic groups) are organized in the interior.

Question

100%

please help with the question

Question 13
Use the information provided below to determine the formula for the unknown compound.
Рeak
Intensity of Base
118 (м1+)
57.7%
119
3.85
120
2.62

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1 : Given

VIEW

Step 2 : Calculations

VIEW

Step 3 : Result

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 3 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, chemistry and related others by exploring similar questions and additional content below.

Similar questions

Question: Why are we using this materials in the experiment is there any reason why we using it? Quantification of Total Protein in Serum Experiment; Materials: Fatty acid free beef albuminl solution: 100 g / L Reagent Ⅰ Sodium potassium tartrate 9g / LSodium hydroxide 0.2 mol / L Potassium iodide 5 g / L Reagent Ⅱ Serum from blood Copper sulphate solution: 150 g / L Working solution: 5 ml of reagent copper sulphate solution is prepared by mixing into 1 L of reagent Ⅱ. This reagent is stable for 6 months at 2-8 ° C Procedure: *Three test tubes are taken. These are marked as blank, standard and sample tubes.*Only 5 ml of working solution is put into the blank tube.*0.1 ml reagent I and 5 ml working solution are put into the standard tube.*0.1 ml of serum and 5 ml of working solution are put into the sample tube.*After mixing each tube separately, it is waited for 30 minutes at room temperature and measured at 545 nm in the spectrophotometer.*Color permanence is…
1.) The word trans in trans-fatty acids came from the functional group of ________. a.) aldehyde b.) alkenes c.) ester d.) carboxylic acid 2.)Which of the following functional groups are always present in amino acid? (Select all answers that are appplicable) a.) amines b.) aldehydes c.) alkene d.) carboxylic acid e.) thoils
EXPLAIN AND ANSWER CORRECTLY
The toxin in rhubarb leaves is oxalic acid, H2C204. What is the potassium salt's name? Media and eTextbooks Save for a later date
formula of Betamethasone cream
The property of water solutions to conduct electric current is possible for all of the 20 standard amino acids. True or False?
Please just give answer no need explanation
Neonatal bilirubin samples are especially vulnerable to UV light degradation due to their small sample volume. Question 9 options: True False
what is the concentration of the unknown protein in nanometers? use the information below! protein length: 82 amino acids molecular mass of amino acid: 118g/mol concentration of protein in sample (unknown protein): 1.2mg/ml
QUESTION 9 The following diagram attached shows 2 molecular structures of amino acids, alanine (Ala) and threonine (Thr). Based on the structures, draw the dipeptides of Thr-Ala and circle the peptide linkage.
Solution Concentration of FeSCN2+ (M) Absorbance1 0.0000491 0.3112 0.0000818 0.5763 0.000115 0.7554 0.000152 0.9075 0.000196 1.185 Solution Concentration of FeSCN2+ (M) Absorbance 1 0.0000491 0.311 2 0.0000818 0.576 3 0.000115 0.755 4 0.000152 0.907 5 0.000196 1.185 A series of aqueous solutions of FeSCN2+ of different concentrations were prepared, and the absorbance of each was measured at a wavelength of 455 nm. Use Excel or Google Sheets to prepare a useful graph of the data (given below) that could be used to determine the concentration of an unknown solution from its absorbance. Ensure your graph is properly formatted and labeled. Click the…
What test will identify this lipid? (Please refer to image)