Interpretation:
The molarity and normality of solution prepared by dissolving 25 g of citric acid to
Concept Introduction:
Moles: One mole is equivalent to the mass of the substance consists of same number of units equal to the atoms present in
Normality: It generally expresses the concentration of acid or base as equivalents of acid or base present in one liter of the solution.
Molarity: The concentration for solutions is expressed in terms of molarity as follows,
The normality for any acid or base equals the molarity times of the number of
Equivalent of Acid: Generally, 1 equivalent of ion is the number of ions which has charge of one mole.
Triprotic acid: Acids with 3 acidic protons are termed as triprotic acid.
Want to see the full answer?
Check out a sample textbook solutionChapter 10 Solutions
Pearson eText Fundamentals of General, Organic, and Biological Chemistry -- Instant Access (Pearson+)
- what is the molar concentration of 80g of glucose dissolved in sufficient water to make two liters of solution.arrow_forwardWhat is the pH of an aqueous solution with {H3O+} = 6x10-12arrow_forwardYou have been observing an insect that defends itself from enemies by secreting a caustic liquid. Analysis of the liquid shows it to have a total concentration of formate plus formic acid (K₁ = 1.8 x 10-4) of 1.45 M. Further analysis reveals that the concentration of formate ion is 0.015 M. What is the pH of the secretion? pH =arrow_forward
- what is the ph of 1.0 M with the concentration of acetic acid (pKa=4.75)?arrow_forwardWhich lipid sample (butter/oil is soluble or miscible in water? Explain.arrow_forwardHow much water must be added to 300 mL of an aqueous solution of 0.2 M acetic acid in order to double the degree of ionization? Take the acid ionization constant of acetic acid to be 1.8 x 10-5.arrow_forward
- If you added three proteins (Protein A, pI 5.0; Protein B, pI 6.0; Protein C, pI 7.0) to an anion exchange column equilibrated with bicine buffer, pH 8.5, in what order would these protein be expected to elute as the column was loaded, washed, and then increasing amounts of NaCl were added?arrow_forwardI want to make a buffer solution containing 1 M glycene pH = 10 (Na+), 1 mM ZnCl2 , 1 mM MgCl2. I have the stock solutions 1 M glycene, 1 M MgCl2, 1 M ZnCl2, and 10 M NaOH. My final volume of buffer solution needs to be 250ml. how much (in ml) of each solution should i put into my buffer?arrow_forwardPrepare 100mL of a 2M MgO (magnesium oxide) solution. i) what is the molarity wanted? ii) what is the total volume of solution wanted (in LITERS)? iii) What is the molar mass of MgO? iv) What is the mass of MgO (solute) needed? v) What is the volume of water (solvent) needed?arrow_forward
- Biology (MindTap Course List)BiologyISBN:9781337392938Author:Eldra Solomon, Charles Martin, Diana W. Martin, Linda R. BergPublisher:Cengage Learning