Schaum's Outline of College Physics, Twelfth Edition (Schaum's Outlines)
12th Edition
ISBN: 9781259587399
Author: Eugene Hecht
Publisher: McGraw-Hill Education
expand_more
expand_more
format_list_bulleted
Question
Chapter 10, Problem 38SP
!!
To determine
The moment of inertia about a horizontal axis perpendicular to the plane of the rods and located at the upper vertical end if a pendulum made up of two rods form an upside-down letter T, each having length
Expert Solution & Answer
Want to see the full answer?
Check out a sample textbook solutionStudents have asked these similar questions
A uniform sphere of mass m and radius R rolls without slipping down a plane at an angle θ from thehorizontal. Show that the acceleration along the slope of the center of mass is aCM = (5/7)g sin θ and that the force of static friction needed is fs = (2/7)mg sin θ. What minimum coefcient of friction µs is needed to satisfythe conditions of the problem?
The angular moomentum of a point with a mass of m, a velocity v, and position r is: L = mr x v. Prove that the rate of change of L, dL/dt is equal to the torque (T = r x F). F is the force on the point.
How much torque must be applied to a 6.0 kg flywheel with a diameter of 30 cm, that is in a shape of a solid circular plate, to change its frequency from 1000 min-1 to 2500 min-1?
Chapter 10 Solutions
Schaum's Outline of College Physics, Twelfth Edition (Schaum's Outlines)
Ch. 10 - 29. A homogeneous cylinder of radius R and mass m...Ch. 10 - 30. A uniform homogeneous solid disk lies in a...Ch. 10 - 31. A uniform homogeneous solid disk having a...Ch. 10 - 32. Picture a rigid rod of length L having...Ch. 10 - 33. Suppose we put a third tiny sphere of mass m...Ch. 10 - 34. Consider the arrangement in the previous...Ch. 10 - 10.35 [I] A flat uniform homogeneous disk is...Ch. 10 - 10.36 [II] A uniform homogeneous rod of length L...Ch. 10 - 10.37 [II] A uniform homogeneous rod of length L...Ch. 10 - Prob. 38SP
Ch. 10 - 10.39 [I] A force of 200 N acts tangentially on...Ch. 10 - 10.40 [I] An 8.0-kg wheel has a radius of gyration...Ch. 10 - 10.41 [II] Determine the constant torque that must...Ch. 10 - 10.42 [II] A 4.0-kg wheel of 20-cm radius of...Ch. 10 - 10.43 [II] Compute the rotational KE of a 25-kg...Ch. 10 - 10.44 [II] A cord 3.0 m long is wrapped around the...Ch. 10 - 45. A 500-g wheel that has a moment of inertia of...Ch. 10 - 46. When 100 J of work is done on a stationary...Ch. 10 - 47. A 5.0-kg wheel with a radius of gyration of 20...Ch. 10 - 48. An electric motor runs at 900 rpm and delivers...Ch. 10 - 49. The driving side of a belt has a tension of...Ch. 10 - 10.50 [III] A 25-kg wheel has a radius of 40 cm...Ch. 10 - 10.51 [III] A wheel and axle having a total moment...Ch. 10 - 52. A solid uniform homogeneous disk of radius r...Ch. 10 - 53. A 20-kg solid disk (I = Mr2) rolls on a...Ch. 10 - 10.54 [II] A 6.0-kg bowling ball starts from rest...Ch. 10 - 10.55 [II] A tiny solid ball rolls without...Ch. 10 - 10.56 [I] Compute the radius of gyration of a...Ch. 10 - 10.57 [I] Figure 10-13 shows four masses that are...Ch. 10 - 10.58 [I] Determine the moment of inertia (a) of a...Ch. 10 - 10.59 [II] Rod OA in Fig. 10-14 is a meterstick....Ch. 10 - Prob. 60SPCh. 10 - 10.61 [II] A large horizontal disk is rotating on...Ch. 10 - 10.63 [II] A 90-kg person stands at the edge of a...
Knowledge Booster
Similar questions
- A small ball of mass 0.5 kg is attached to one end of a 1.8-m-long massless rod, and the other end of the rod is hung from a pivot. When the resulting pendulum is 40◦ from the vertical, what is the magnitude of thegravitational torque calculated about the pivot?arrow_forwardA cylinder of mass M and radius R is pulled by a constant force of magnitude Fapplied at the top horizontally. The cylinder rolls smoothly on the horizontal surface. Assume that M=10 kg, R=0.10 m, F=12 N, and note that the rotational inertia of the cylinder about its axis is 1/2MR^2 (a) Find the magnitude of the acceleration of thic center of mass of the cylinder (please input the numerical value in unit of m/s) (b) Find the magnitude of the angular acceleration of the contact point between the cylinder and the surface about the axis of the cylinder (please input the numerical value in unit of rad/s). (c) Find the magnitude of the frictional force acting on the cylinder (please input the numerical value in unit of N).arrow_forwardA yo-yo is constructed of two brass disks whose thickness b is 8.5mm and whose radius R is 3.5cm, joined by a short axle whose radius Ro is 3.2mm. A. What is the rotational inertia about its central axis? Neglect rotational inertia of the axle. The density p is 8400kg/m^3. B. A string of length l=1.1m and of negligible thickness is wound on the axle. What is the linear acceleration of the yo-yo as it rolls down the string from the rest?arrow_forward
- Consider a “round” rigid body with moment of inertia I = BMR2, where M is the body’s mass, R is the body’s radius, and B (beta) is a constant depending on the type of the body. The center of the “round” rigid body is attached to a spring of force constant k, and then the body is made to roll without slipping on a rough horizontal surface. Due to the spring, it is expected the body will oscillate by rolling back and forth from its resting position. A. Determine the angular frequency and the period for small oscillations of the round rigid body. Express your answers in terms of B (beta). B. Among the four “round” rigid bodies shown at the table, for the same masses and radii, which among them will have the most number of cycles per second.arrow_forwardConsider a “round” rigid body with moment of inertia I = BMR2, where M is the body’s mass, R is the body’s radius, and B is a constant depending on the type of the body. The center of the “round” rigid body is attached to a spring of force constant k, and then the body is made to roll without slipping on a rough horizontal surface. Due to the spring, it is expected the body will oscillate by rolling back and forth from its resting position. A. Determine the angular frequency and the period for small oscillations of the round rigid body. Express your answer in terms of B. B. Among the four “round” rigid bodies shown at the table, for the same masses and radii, which among them will have the most number of cycles per second.arrow_forwardConsider a “round” rigid body with moment of inertia I = BMR2, where M is the body’s mass, R is the body’s radius, and B is a constant depending on the type of the body. The center of the “round” rigid body is attached to a spring of force constant k, and then the body is made to roll without slipping on a rough horizontal surface. Due to the spring, it is expected the body will oscillate by rolling back and forth from its resting position. A. Determine the angular frequency and the period for small oscillations of the round rigid body. Express your answer in terms of B.arrow_forward
- In the assembly below the system can rotate around the vertical axis. The left part is a square where R = 0.1 meters, and the mass of each of the four thin bars is uniform and is 0.1 kg. On the left is a massive sphere of radius R = 0.2 meters and Mass M = 0.3 kg. Assume that the system rotates with constant period T = 2.0 s, when, without any external action, as three leftmost bars detach from the system, leaving only the right vertical bar (on the axis) and sphere . What will be the new period of system revolution? Note: Note that in this case there is no difference between angular velocity and frequency.arrow_forwardA solid sphere of uniform density has a mass of 2.42 kg and a radius of 0.432 meters. A force of 13.2 Newtons is applied tangentially to the equator of the sphere. If the sphere is free to rotate without friction about an axis perpendicular to the equator to which the 13.2 Newton force is applied, what is the angular acceleration α of the sphere caused by the applied force? It may be useful to bear in mind that the moment of inertia I for a solid sphere of uniform density is I = (2/5)MR^2 where M is the mass of the sphere and R is the radius of the sphere. Also, bear in mind in this case that the torque τ is τ = RF since the force F is applied tangentially to the equator. A. 15.3 rad/s^2 B. 31.5 rad/s^2 C. 50.3 rad/s^2 D. 68.5 rad/s^2arrow_forwardA 255-lbf block is suspended from an inextensible cable which is wrapped around a drum of 1.75-ft radius rigidly attached to a flywheel. The drum and flywheel have a combined centroidal moment of inertiaI̅= 12 lb . ft . s 2 . At the instant shown, the velocity of the block is unknown directed downward. Knowing that the bearing at A is poorly lubricated and that the bearing friction is equivalent to a couple M of magnitude 65 lb .ft, determine the velocity of the block before it has moved 3.5 ft downward if at S2 speed is 13.5ft/s. (The final answer should be in two decimal places with correct units)arrow_forward
- If the angular acceleration of a rigid body is zero, what is the functional form of the angular velocity?arrow_forwardA rigid, massless rod has three particles with equal masses attached to it as shown. The rod is free to rotate in a vertical plane about a frictionless axle perpendicular to the rod through the point P and is released from rest in the horizontal position at t = 0. Assuming m and d are known, find (a) the moment of inertia of the system of three particles about the pivot, (b) the torque acting on the system at t = 0, (c) the angular acceleration of the system at t = 0, (d) the linear acceleration of the particle labeled 3 at t = 0, (e) the maximum kinetic energy of the system, (f) the maximum angular speed reached by the rod, (g) the maximum angular momentum of the system, and (h) the maximum speed reached by the particle labeled 2.arrow_forwardA uniform steel rod of length 0.8 m and mass 1.5 kg has two point masses of 1.9 kg each at the two ends. Calculate the moment of inertia of the system about an axis perpendicular to the rod, and passing through its center.arrow_forward
arrow_back_ios
SEE MORE QUESTIONS
arrow_forward_ios
Recommended textbooks for you
- Classical Dynamics of Particles and SystemsPhysicsISBN:9780534408961Author:Stephen T. Thornton, Jerry B. MarionPublisher:Cengage LearningUniversity Physics Volume 1PhysicsISBN:9781938168277Author:William Moebs, Samuel J. Ling, Jeff SannyPublisher:OpenStax - Rice University
Classical Dynamics of Particles and Systems
Physics
ISBN:9780534408961
Author:Stephen T. Thornton, Jerry B. Marion
Publisher:Cengage Learning
University Physics Volume 1
Physics
ISBN:9781938168277
Author:William Moebs, Samuel J. Ling, Jeff Sanny
Publisher:OpenStax - Rice University