Concept explainers
(a)
Interpretation : The partial pressure of the oxygen gas needs to be determined.
Concept Introduction : The ideal gas equation helps to calculate the pressure, volume, temperature of ideal gas as follows:
If a gas is collected over water, the total pressure always represents the sum of gas pressure and vapour pressure of water.
Hence;
Gas pressure = Total pressure - vapour pressure
(b)
Interpretation : The number of moles oxygen gas produced needs to be calculated.
Concept Introduction : The ideal gas equation helps to calculate the pressure, volume, temperature of ideal gas as follows:
If a gas is collected over water, the total pressure always represents the sum of gas pressure and vapour pressure of water.
Hence;
Gas pressure = Total pressure - vapour pressure
Want to see the full answer?
Check out a sample textbook solutionChapter 11 Solutions
EBK BASIC CHEMISTRY
- A study of climbers who reached the summit of Mount Everest without supplemental oxygen showed that the partial pressures of O2 and CO2 in their lungs were 35 mm Mg and 7.5 mm Hg, respectively. The barometric pressure at the summit was 253 mm Hg. Assume the lung gases are saturated with moisture at a body temperature of 37 C [which means the partial pressure of water vapor in the lungs is P(H2O) = 47.1 mm Hg]. If you assume the lung gases consist of only O2, N2, CO2, and H2O, what is the partial pressure of N2?arrow_forwardIf equal masses of O2 and N2 are placed in separate containers of equal volume at the same temperature, which of the following statements is true? If false, explain why it is false. (a) The pressure in the flask containing N2 is greater than that in the flask containing O2. (b) There are more molecules in the flask containing O2 than in the flask containing N2.arrow_forwardHow does hydraulic fracturing differ from previously used techniques for the recovery of natural gas from the earth?arrow_forward
- Nitroglycerin decomposes into four different gases when detonated: 4 C3H5(NO3)3() 6 N2(g) + O2(g) + 12 CO2(g) + 10 H2O(g) The detonation of a small quantity of nitroglycerin produces a total pressure of 4.2 atm at a temperature of 450 C. (a) What is the partial pressure of N2? (b) If the gases occupy a volume of 1.5 L, what mass of nitroglycerin was detonated?arrow_forward5.19 A sample of CO2 gas has a pressure of 56.5 mm Hg in a 125-mL flask. The sample is transferred to a new flask, where it has a pressure of 62.3 mm Hg at the same temperature. What is the volume of the new flask?arrow_forwardThe hydrocarbon octane (C8H18) bums to give CO2 and water vapor: 2 C8H18(g) + 25 O2(g) 16 CO2(g) + 18 H2O(g) If a 0.048-g sample of octane burns completely in O2, what will be the pressure of water vapor in a 4.75-L flask at 30.0 C? If the O2 gas needed for complete combustion was contained in a 4.75-L flask at 22 C, what would its pressure be?arrow_forward
- A cylinder of compressed gas is labeled Composition (mole %): 4.5% H2S, 3.0% CO2, balance N2. The pressure gauge attached to the cylinder reads 46 atm. Calculate the partial pressure of each gas, in atmospheres, in the cylinder.arrow_forwardNitrogen trifluoride is prepared by the reaction of ammonia and fluorine. 4 NH3(g) + 3 F2(g) 3 NH4F(s) + NF3(g) If you mix NH3 with F2 in the correct stoichiometric ratio, and if the total pressure of the mixture is 120 mm Hg, what are the partial pressures of NH3 and F2? When the reactants have been completely consumed, what is the total pressure in the flask? (Assume T is constant.)arrow_forwardDiborane reacts with O2 to give boric oxide and water vapor. B2H6(g) + 3 O2(g) → B2O3(s) + 3 H2O(g) 1. What mass of O2 gas is required to react completely with 1.5 L of B2H6 at 25 °C and 0.15 atm? 0.29 g 0.59 g 0.44 g 0.88 garrow_forward
- 93 The complete combustion of octane can be used as a model for the burning of gasoline: 2C8H18+25O216CO2+18H2O Assuming that this equation provides a reasonable model of the actual combustion process, what volume of air at 1.0 atm and 25°C must be taken into an engine to burn 1 gallon of gasoline? (The partial pressure of oxygen in air is 0.21 atm and the density of liquid octane is 0.70 g/mL.)arrow_forwardYou have a 550.-mL tank of gas with a pressure of 1.56 atm at 24 C. You thought the gas was pure carbon monoxide gas, CO, but you later found it was contaminated by small quantities of gaseous CO2 and O2. Analysis shows that the tank pressure is 1.34 atm (at 24 C) if the CO2 is removed. Another experiment shows that 0.0870 g of O2 can be removed chemically. What are the masses of CO and CO2 in the tank, and what is the partial pressure of each of the three gases at 25 C?arrow_forwardButyl mercaptan, C4H9SH, has a very bad odor and is among the compounds added to natural gas to help detect a leak of otherwise odorless natural gas. In an experiment, you burn 95.0 mg of C4H9SH and collect the product gases (SO2, CO2, and H2O) in a 5.25-L flask at 25 C. What is the total gas pressure in the flask, and what is the partial pressure of each of the product gases?arrow_forward
- Chemistry: Matter and ChangeChemistryISBN:9780078746376Author:Dinah Zike, Laurel Dingrando, Nicholas Hainen, Cheryl WistromPublisher:Glencoe/McGraw-Hill School Pub CoChemistry & Chemical ReactivityChemistryISBN:9781337399074Author:John C. Kotz, Paul M. Treichel, John Townsend, David TreichelPublisher:Cengage LearningChemistry & Chemical ReactivityChemistryISBN:9781133949640Author:John C. Kotz, Paul M. Treichel, John Townsend, David TreichelPublisher:Cengage Learning
- Principles of Modern ChemistryChemistryISBN:9781305079113Author:David W. Oxtoby, H. Pat Gillis, Laurie J. ButlerPublisher:Cengage LearningChemistry: Principles and ReactionsChemistryISBN:9781305079373Author:William L. Masterton, Cecile N. HurleyPublisher:Cengage LearningChemistryChemistryISBN:9781305957404Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCostePublisher:Cengage Learning