Concept explainers
(a)
The new amplitude of the vibration system after collision.
(a)
Answer to Problem 63P
The new amplitude of the vibration system after collision is
Explanation of Solution
Section 1:
To determine: The angular frequency of the system.
Answer: The angular frequency of the system is
Given information: The mass of the particle is
The formula for the angular frequency is,
Substitute
Section 2:
To determine: The maximum speed of the system.
Answer: The maximum speed of the system is
Given information: The mass of the particle is
The formula to calculate maximum speed is,
Substitute
Section 3:
To determine: The speed of the system when the objects stick together after the collision.
Answer: The speed of the system when the objects stick together after the collision is
Given information: The mass of the particle is
The formula to calculate speed after the collision is,
Substitute
Section 4:
To determine: The new amplitude of the vibration system after collision.
Answer: The new amplitude of the vibration system after collision is
Given info: The mass of the particle is
The law of conservation of energy is,
Rearrange the above equation for
Substitute
Conclusion:
Therefore, the new amplitude of the vibration system after collision is
(b)
The factor by which the period of system changed.
(b)
Answer to Problem 63P
The factor by which the period of system changed is
Explanation of Solution
Section 1:
To determine: The initial period of system.
Answer: The initial period of system is
Given info: The mass of the particle is
The formula for the period of the system before collision is,
Substitute
Section 2:
To determine: The final period of system.
Answer: The final period of system is
Given info: The mass of the particle is
The formula for the period of the system after collision is,
Substitute
Section 3:
To determine: The factor by which the period of system changed.
Answer: The factor by which the period of system changed is
Given info: The mass of the particle is
The factor by which period is changed calculated as,
Substitute
Conclusion:
Therefore, the factor by which the period of system changed is
(c)
The energy changed of the system after the collision.
(c)
Answer to Problem 63P
The energy of the system after the collision is decreased by factor
Explanation of Solution
Given info: The mass of the particle is
The formula for the energy of the system before collision is,
The formula for the energy of the system after collision is,
The chance in the energy is calculated as,
Substitute
Substitute
Conclusion:
Therefore, the energy of the system after the collision is decreased by factor
(d)
To explain: The change in the energy.
(d)
Explanation of Solution
The energy of the system is defined as the capacity to do any work. The energy is the sum of potential and the kinetic energy of the system.
The type of the collision of the system is inelastic due to this the kinetic energy does not remains conserved. The mechanical energy of the system is transformed into the internal energy. So there are energy losses due to conversion of energy.
Conclusion:
Therefore, the mechanical energy of the system is transformed into the internal energy in the perfectly inelastic collision.
Want to see more full solutions like this?
Chapter 12 Solutions
Principles of Physics
- A spherical bob of mass m and radius R is suspended from a fixed point by a rigid rod of negligible mass whose length from the point of support to the center of the bob is L (Fig. P16.75). Find the period of small oscillation. N The frequency of a physical pendulum comprising a nonuniform rod of mass 1.25 kg pivoted at one end is observed to be 0.667 Hz. The center of mass of the rod is 40.0 cm below the pivot point. What is the rotational inertia of the pendulum around its pivot point?arrow_forwardA block of unknown mass is attached to a spring with a spring constant of 6.50 N/m and undergoes simple harmonic motion with an amplitude of 10.0 cm. When the block is halfway between its equilibrium position and the end point, its speed is measured to be 30.0 cm/s. Calculate (a) the mass of the block, (b) the period of the motion, and (c) the maximum acceleration of the block.arrow_forwardA 200-g block is attached to a horizontal spring and executes simple harmonic motion with a period of 0.250 s. The total energy of the system is 2.00 J. Find (a) the force constant of the spring and (b) the amplitude of the motion.arrow_forward
- When a block of mass M, connected to the end of a spring of mass ms = 7.40 g and force constant k, is set into simple harmonic motion, the period of its motion is T=2M+(ms/3)k A two-part experiment is conducted with the use of blocks of various masses suspended vertically from the spring as shown in Figure P15.76. (a) Static extensions of 17.0, 29.3, 35.3, 41.3, 47.1, and 49.3 cm are measured for M values of 20.0, 40.0, 50.0, 60.0, 70.0, and 80.0 g, respectively. Construct a graph of Mg versus x and perform a linear least-squares fit to the data. (b) From the slope of your graph, determine a value for k for this spring. (c) The system is now set into simple harmonic motion, and periods are measured with a stopwatch. With M = 80.0 g, the total time interval required for ten oscillations is measured to be 13.41 s. The experiment is repeated with M values of 70.0, 60.0, 50.0, 40.0, and 20.0 g, with corresponding time intervals for ten oscillations of 12.52, 11.67, 10.67, 9.62, and 7.03 s. Make a table of these masses and times. (d) Compute the experimental value for T from each of these measurements. (e) Plot a graph of T2 versus M and (f) determine a value for k from the slope of the linear least-squares fit through the data points. (g) Compare this value of k with that obtained in part (b). (h) Obtain a value for ms from your graph and compare it with the given value of 7.40 g.arrow_forwardA block of mass m is connected to two springs of force constants k1 and k2 in two ways as shown in Figure P12.56. In both cases, the block moves on a frictionless table after it is displaced from equilibrium and released. Show that in the two cases the block exhibits simple harmonic motion with periods (a) T=2m(k1+k2)k1k2 and (b) T=2mk1+k2 Figure P12.56arrow_forwardA block of mass m rests on a frictionless, horizontal surface and is attached to two springs with spring constants k1 and k2 (Fig. P16.22). It is displaced to the right and released. Find an expression for the angular frequency of oscillation of the resulting simple harmonic motion. FIGURE P16.22 Problems 22 and 81.arrow_forward
- A 500-kg object attached to a spring with a force constant of 8.00 N/m vibrates in simple harmonic motion with an amplitude of 10.0 cm. Calculate the maximum value of its (a) speed and (b) acceleration, (c) the speed and (d) the acceleration when the object is 6.00 cm from the equilibrium position, and (e) the time interval required for the object to move from x = 0 to x = 8.00 cm.arrow_forwardA block of mass M is connected to a spring of mass m and oscillates in simple harmonic motion on a frictionless, horizontal track (Fig. P12.69). The force constant of the spring is k, and the equilibrium length is . Assume all portions of the spring oscillate in phase and the velocity of a segment of the spring of length dx is proportional to the distance x from the fixed end; that is, vx = (x/) v. Also, notice that the mass of a segment of the spring is dm = (m/) dx. Find (a) the kinetic energy of the system when the block has a speed v and (b) the period of oscillation. Figure P12.69arrow_forward
- Principles of Physics: A Calculus-Based TextPhysicsISBN:9781133104261Author:Raymond A. Serway, John W. JewettPublisher:Cengage LearningPhysics for Scientists and Engineers with Modern ...PhysicsISBN:9781337553292Author:Raymond A. Serway, John W. JewettPublisher:Cengage LearningPhysics for Scientists and EngineersPhysicsISBN:9781337553278Author:Raymond A. Serway, John W. JewettPublisher:Cengage Learning
- Physics for Scientists and Engineers: Foundations...PhysicsISBN:9781133939146Author:Katz, Debora M.Publisher:Cengage LearningPhysics for Scientists and Engineers, Technology ...PhysicsISBN:9781305116399Author:Raymond A. Serway, John W. JewettPublisher:Cengage Learning