Concept explainers
A uniform 6.0-m-long ladder of mass 16.0 kg leans against a smooth wall (so the force exerted by the wall,
Want to see the full answer?
Check out a sample textbook solutionChapter 12 Solutions
Modified Mastering Physics With Pearson Etext -- Standalone Access Card -- For Physics For Scientists & Engineers With Modern Physics (5th Edition)
Additional Science Textbook Solutions
Sears And Zemansky's University Physics With Modern Physics
Essential University Physics (3rd Edition)
Tutorials in Introductory Physics
The Cosmic Perspective
Introduction to Electrodynamics
An Introduction to Thermal Physics
- A painter of mass 87.8 kg is 1.45 m from the top of a 6.67-m ladder. The ladder rests against a wall. Friction between the ladder and the wall is negligible. The ladders mass is 5.50 kg. Assume the ladder is set up according to Occupational Safety and Health Administration standards so that it makes a 75.5 angle with the floor. a. What is the minimum coefficient of static friction required for the painters safety? b. Would rubber ladder tips on dry concrete be safe?arrow_forwardA 20.0-kg horizontal plank 4.00 in long rests on two supports, one at the left end and a second 1.00 m from the right end. What is the magnitude of the force exerted on the plank by the support near the right end? (a) 32.0 N (b) 45.2 N (c) 112 N (d) 131 N (e) 98.2 Narrow_forwardA uniform horizontal strut weighs 400.0 N. One end of the strut is attached to a hinged support the wall and the other end of the strut is attached to a sign that weighs 200.0 N The strut is also supported by a cable attached between the end of the strut and the wall. Assuming that the entire weight of the sign is attached at the very end of the s find the tension in the cable and the force at the hinge of the strut.arrow_forward
- A wooden door 2.1 m high and 0.90 m wide is hung by two hinges 1.8 m apart. The lower hinge is 15 cm above the bottom of the door. The center of mass of the door is at its geometric center, and the weight of the door is 260 N, which is supported equally by both hinges. Find the horizontal force exerted by each hinge on the door.arrow_forwardA uniform ladder of mass 35 kg and L=7m long is placed against a vertical wall at an angle of 68 degrees with respect to the floor. The coefficient of friction between the ladder and wall is 0.33 and that between the ladder and the floor is 0.48. Find how high a man of mass 84.5kg can ascend; before the ladder begins to slip.arrow_forwardA 100-N uniform ladder, 8.0 m long, rests against a smooth vertical wall. The coefficient of static friction between ladder and floor is 0.40. What minimum angle can the ladder make with the floor before it slips?arrow_forward
- A ladder of length 12.0 m with a mass of 40.0 kg leans against a smooth wall. The ladder makes a 35.0o angle with the horizontal. Draw an adequate free body diagram of the ladder and determine the minimum coefficient of static friction between the ladder and the ground necessary to prevent the ladder from slipping.arrow_forwardA 1.2-m plank of mass 3 kg rests on two joists. Knowing that the coefficient of static friction between the plank and the joists is 0.30,determine the magnitude of the horizontal force required to move the plank when (a) a= 750 mm, (b) a = 900 mm.arrow_forwardOne end of a uniform meter stick is placed against a vertical wall. The other end is held by a lightweight cord that makes an angle ? with the stick. The coefficient of static friction between the end of the meter stick and the wall is 0.400. A block of the same weight as the meter stick is suspended from the stick, as shown, at a distance ? from the wall. Assume that theta= 15.0o in this problem. What is the minimum value of ? for which the stick will remain in equilibrium?arrow_forward
- One end of a 2.00 m uniform meter stick is placed against a vertical wall. The other end is held by a lightweight cord that makes an angle θ with the stick. The coefficient of static friction between the end of the meter stick and the wall is 0.530. A block of the same weight as the stick is suspended on it at adistance ? from the wall as shown. Assume that θ = 16.5° in this part ofthe problem. What is the minimum value of x for which the stick willremain in equilibrium?arrow_forwardOne end of a uniform meter stick is placed against a vertical wall. The other end is held by a lightweight cord that makes an angle ? with the stick. The coefficient of static friction between the end of the meter stick and the wall is 0.400. When theta = 15.0o , how large must the coefficient of static friction be so that the block can be attached 0.100 [m] from the left end of the stick without causing it to slip?arrow_forwardA 6 m long, uniform ladder leans against a frictionless wall and makes an angle of 71.6° with the floor. The ladder has a mass 26.6 kg. A 69.16 kg man climbs 82% of the way to the top of the ladder when it slips and falls to the floor. What is the coefficient of static friction be- tween the ladder and the floor?arrow_forward
- Physics for Scientists and Engineers: Foundations...PhysicsISBN:9781133939146Author:Katz, Debora M.Publisher:Cengage LearningPrinciples of Physics: A Calculus-Based TextPhysicsISBN:9781133104261Author:Raymond A. Serway, John W. JewettPublisher:Cengage LearningPhysics for Scientists and Engineers, Technology ...PhysicsISBN:9781305116399Author:Raymond A. Serway, John W. JewettPublisher:Cengage Learning
- University Physics Volume 1PhysicsISBN:9781938168277Author:William Moebs, Samuel J. Ling, Jeff SannyPublisher:OpenStax - Rice University