Tutorials In Introductory Physics: Homework
1st Edition
ISBN: 9780130662453
Author: Lillian C. McDermott, Peter S. Shaffer
Publisher: PEARSON
expand_more
expand_more
format_list_bulleted
Concept explainers
Question
Chapter 13.1, Problem 3bT
(1)
To determine
The sketch of
(2)
To determine
The ranking is consistent with ideal
(3)
To determine
The possibility for the gas to be in a state in which it has the same volume as in state B and the same temperature as in state A.
Expert Solution & Answer
Want to see the full answer?
Check out a sample textbook solution
Students have asked these similar questions
Consider an ideal gas at 27.0 degrees Celsius and 1.00 atmosphere pressure. Imagine the molecules to be uniformly spaced, with each molecule at the center of a
small cube.
Part A
What is the length L of an edge of each small cube if adjacent cubes touch but don't overlap?
Express your answer numerically in meters.
► View Available Hint(s)
L =
for Parval for PartAddo for Part
Submit
redo for Part A reset for Part A keyboard shortcuts for Part A help for Part A
m
An object was left in a room of unknown surrounding temperature. The temperature of the object was summarized below with respect to the time t (in minutes) the object was initially observed. Predict and complete the information, i.e. determine the temperature in Celsius when t = 30 minutes. Put your answer accurate up to four decimal places. No need to put in the units of measurement.
When t = 0, the temperature of the object is 30 degrees Celsius.
When t = 10 minutes, the temperature of the object is 32 degrees Celsius.
When t = 20 minutes, the temperature of the object is 33.6 degrees Celsius.
When t = 30 minutes, the temperature of the object is unknown.
Assume the system obeys Newton’s Law of Cooling and the surrounding temperature of the room did not change.
The porous catalyst pellet shown in Figure 1 has an overall radius R and a
thermal conductivity k (which may be assumed constant). Because of the chemical
reaction occurring within the porous pellet, heat is generated at a constant rate
of Se cal/em s. Heat is lost at the outer surface of the pellet to a gas stream at a
constant temperature T, by convective heat transfer coefficient h.
Gas
bemperature T,
Figure I. Sphere with internal heat
generation
Answer the following questions
(a) Make a list of assumptions that apply to the above situation.
(b) Set up the differential equation by making a shell energy balance. Show the
units for all variables that are used.
(c) Specify the proper boundary conditions.
(d) Integrate the differential equation with the above boundary conditions to
obtain an expression for the temperature profile, and make a sketch of the
function profile T(r)
(e) What is the limiting form of T(r) when h co?
(f) What is the maximum temperature in the system?
(g)…
Chapter 13 Solutions
Tutorials In Introductory Physics: Homework
Ch. 13.1 - Prob. 1aTCh. 13.1 - In the space provided, draw an arrow to indicate...Ch. 13.1 - Prob. 1cTCh. 13.1 - Prob. 1dTCh. 13.1 - Prob. 1eTCh. 13.1 - Prob. 2aTCh. 13.1 - Prob. 2bTCh. 13.1 - Consider the following student dialogue. Student...Ch. 13.1 - Sketch the process described in section II on the...Ch. 13.1 - Prob. 3bT
Ch. 13.1 - Prob. 4aTCh. 13.1 - A student looks up the molar masses and finds the...Ch. 13.1 - Prob. 4cTCh. 13.2 - Recall the definition of work done on an object by...Ch. 13.2 - Prob. 1bTCh. 13.2 - Prob. 1cTCh. 13.2 - Prob. 2aTCh. 13.2 - Does the internal energy of a gas in an insulated...Ch. 13.2 - Two students are discussing process 1: Student 1:...Ch. 13.2 - Imagine that the cylinder from section II is no...Ch. 13.2 - In process 2, is the heat transfer to the gas...Ch. 13.2 - Prob. 3cTCh. 13.2 - Prob. 4aTCh. 13.2 - In process 1 (section II) you did not need to...Ch. 13.2 - In process 2 (section III) you did not need to...Ch. 13.2 - Prob. 4dTCh. 13.2 - How does the compression in process 3 differ from...Ch. 13.2 - A student is considering process 3: “The...
Knowledge Booster
Learn more about
Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.Similar questions
- A student team places 100 milliliters (mL) of distilled water into each of two graduated cylinders. One is placed in a humid room, and one is placed in a dry room. The team measures the remaining volume of water in each cylinder every 5 minutes. To produce a generally valid conclusion about the relationship between humidity and rate of evaporation, which experimental condition should be true? O Both test cylinders had the same mass. O Both water samples took the same amount of time to evaporate. O Each room used had the same temperature. O Each room used had the same volume.arrow_forwardIn a hypothetical diesel engine the fuel is compressed from 528mL to 39.7 mL. This rasies the temperature of the fuel form 25°C to its ignition temperature of 210°C. If the fuel begins at 1.00atm, what is the pressure of the fuel at its ignition temperature.? Express your answer to 1 decimal place. Be sure to use the proper abbreviation of the UNITSarrow_forwardSome N2 has is mixed with some O2 has and the sketch below shows a representative sample of the mixture. The total pressure of the mixture is measured and found to be 3.00 atm. Calculate the mole fraction and partial pressure of each gas in this mixture. Round your answer to 3 significant digits. You may assume each behave as an ideal gasarrow_forward
- (Figure 1) shows two different processes by which 1.0 g of nitrogen gas moves from state 1 to state 2. The temperature of state 1 is 25°C. Figure 2.0p 1.5p₁ P₁ 0.5p₁ 0 P 0 3 50 100 150 1 of 1 V (cm³) Part A What is the pressure p₁? Express your answer in kilopascals to two significant figures. ► View Available Hint(s) P1 = Submit Part B ΑΣΦ T2, T3, T4= ? What are temperatures (in °C) T2, T3, and T4? Enter your answers in degrees Celsius separated by commas. ► View Available Hint(s) ΑΣΦ kPa ? °Carrow_forwardThe basal metabolism of a resting adult is approximately 100 W. Most of this is provided by the hydrolysis of ATP, which in resting muscle has an estimated energy release of 60 kJ/mol.arrow_forwardConsider a pressure versus volume graph, where the different curves represent different processes done on a gas. Starting at the origin to point 1, the pressure and volume are increased to 2913 Pa and 4.25 m³, respectively. From 1 to 2, the gas expands at constant pressure to a volume of 7.25 m³. From 2 to 3, the pressure rises to 4082 Pa. Finally, from 3 to 4, the gas expands again to 10.85 m³. Rank the curves from the most positive to the most negative amount of work done on the gas. Pressure (Pa) 0 1 3 2 Volume (m³) What is the total work done on the gas? 4 Wo-4 = Most positive work Incorrect 29624.325 23 0 → 1 1 → 2 3→ 4 Most negative work Answer Bankarrow_forward
- The figure(Figure 1) shows the thermal energy of 0.15 mol of gas as a function of temperature. Part A What is Cy for this gas? Express your answer as an integer and include the appropriate units. HẢ ? Cy = Value Units Submit Figure <) 1 of 1 Eth (J) 1892 1492 1092 T (°C) 100 200arrow_forwardA gas at T0 and atmospheric pressure fills a cylinder. The gas is transferred to a new cylinder with three times the volume, after which the pressure is half the original pressure. What is the new temperature of the gas? Express your answer in terms of T0arrow_forwardHeating substances in the sun: The following table shows the temperature after 10.0 grams of four different substances have been in direct sunlight for up to 60 minutes. Time (minutes) O (initial) 15.0 min 30.0 min 45.0 min 60.0 min Temperature (°C) 70 60 50 40 PART I: Experiment 1. Create a line graph for each substance on graph below. (You can use Excel or similar program) Label the substances. Temperature vs Heating Time 30 20 0 Air (°C) 25°C 28.9°C 32.5°C 36.2°C 40°C 10 Water (°C) 25°C 26.2°C 27.5°C 28.8°C 30°C 20 Time (minutes) 30 40 Sand (C) 25°C 30°C 50 35°C 40°C 45°C 60 Metal (°C) 25°C 35°C 45°C 55°C 65°Carrow_forward
- The Table shown gives experimental values of the pressure P of a given mass of gas corresponding to various values of the volume V. According to thermodynamic principles, a relationship having the form PVk = C, where k and C are constants, should exist between the variables. Use the natural log (In) and linear regression to solve the following. 1) Find the value of k. a) 0.74 b) 0.86 c) 0.98 d) 1.33 2) Find the value of C. a) 812 b) 765 c) 880 d) 947 3) Estimate P when V = 100.0 in3 a) 18.9 b) 30.8 c) 24.7 d) 49.5 TABLE V(in3) 54.3 61.8 72.4 88.7 118.6 244.9 P(lb/in?) 61.2 49.5 36.6 28.4 19.2 20.1 Write only the letter corresponding to the correct answer.arrow_forwardA 25-cm-diameter cylinder that is 36 cm long contains 60 g of oxygen gas at 20°C. For general problem-solving tips and strategies for this topic, you may want to view a Video Tutor Solution of Air in warmed tire. Part B How many oxygen molecules are in the cylinder? N = 1.1x1024 molecules Submit ✓ Part C Correct Here we learn how to find the number of molecules in the gas if we know its mass. What is the number density of the oxygen? Express your answer in molecules per meter cubed. n = 6.4x1025 m -3 Previous Answers Submit Previous Answers ✓ Correct Here we learn how to calculate the number density of the gas. Part D What is the reading of a pressure gauge attached to the tank? Express your answer with the appropriate units. Lo Submit μA P= 258467.84 Pa Previous Answers Request Answer ? X Incorrect; Try Again; 5 attempts remainingarrow_forwardYou are modeling the concentration of a drug in a person's blood after they take one pill. We assume that after they take the pill the drug enters their blood effectively instantaneously. The drug has first order elimination kinetics. Complete parts (a) and (b). (a) Explain why the concentration of drug in their blood satisfies a differential equation = - k, c with c(0) = cn. Choose the correct answer below. O A. The differential equation for a drug with first order elimination kinetics is = A(t) - ko. As the drug enters the blood effectively instantaneously. There is no further absorption dc dc = - ko. dt after time t= 0, so A(t) = 0. Thus, О в. The differential equation for a drug with first order elimination kinetics is = A(t) - k, c. As the drug enters the blood effectively instantaneously. There is no further absorption dc after time t=0, so A(t) = 0. Thus = -k,c. dt Oc. The differential equation for a drug with first order elimination kinetics is = A(t) - ko. As the drug enters…arrow_forward
arrow_back_ios
SEE MORE QUESTIONS
arrow_forward_ios
Recommended textbooks for you
Physics for Scientists and Engineers: Foundations...PhysicsISBN:9781133939146Author:Katz, Debora M.Publisher:Cengage Learning
Physics for Scientists and Engineers: Foundations...
Physics
ISBN:9781133939146
Author:Katz, Debora M.
Publisher:Cengage Learning