Earth Is the Lords
5th Edition
ISBN: 9781121660069
Author: Caldwell, Taylor
Publisher: MCG/CREATE
expand_more
expand_more
format_list_bulleted
Concept explainers
Question
Chapter 3, Problem 3.8P
To determine
The direction of the induced torque in the given machine also, find whether the machine is acting as a motor or generator.
Expert Solution & Answer
Want to see the full answer?
Check out a sample textbook solution
Students have asked these similar questions
Justify why an electrostatic motor cannot be operated from dc supply.Derive the expression of average torque of this motor when it is suppliedfrom ac source
A self-excited DC generator has lost its residual magnetism and therefore cannot work (cannot build-up voltage), How would you restore this residual magnetism and make it work again?
The armature of a 8 pole DC motor carries 314 conductors which are lap connected . For an armature current of 20 A, the torque produced has to be 50N-m. Determine the required flux per pole
Chapter 3 Solutions
Earth Is the Lords
Ch. 3 - What is the principal difference between a...Ch. 3 - Prob. 3.2QCh. 3 - Prob. 3.3QCh. 3 - What is the equation for the induced torque in an...Ch. 3 - The simple loop rotating in a uniform magnetic...Ch. 3 - Prob. 3.2PCh. 3 - The first ac power system in the United States ran...Ch. 3 - A three-phase, Y-connected, four-pole winding is...Ch. 3 - A three-phase, -connected, six-pole winding is...Ch. 3 - A three-phase, Y-connected, 60 Hz, two-pole...
Knowledge Booster
Learn more about
Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.Similar questions
- What is the ratio of the fixed self-power E1 to the rotor electromotive force E2 by the effective winding cost of the stator and the rotor when the rotor is rotating at the slip s?arrow_forward(TRUE OR FALSE) - Lenz’s law rule is used to determine the direction of rotation of dcmachines. - Compound dc motor at no-load it regulates highest speed. - The direction of this force is perpendicular to both the wire and themagnetic field in DC motor.arrow_forwardAn 8-pole DC machine has a simplex wave-wound armature containing 200 coils of 10 turns each. The resistance of each turn is 0.01 Ω. The flux per pole is 0.004 Wb. What is the internal resistance of the armature in ohms? What is the current absorbed by this machine in amperes at the instant it's connected to a 100 Vdc source? What is the internally generated torque produced by the armature of this machine in N-m at the instant it's connected to the 100 Vdc source? With the DC machine connected to the 100 Vdc source, what is the steady state angular speed of the machine in rpm? What is the internally generated voltage of the armature of this machine at steady state in volts?arrow_forward
- Write an Introduction about DC Motors.arrow_forwardA 6-pole lap wound dc shunt motor has 60 conductors. The armature and shunt fields resistance are 0.06Ω and 20 Ω respectively. Find the speed of the dc motor if takes 110 A from a d.c supply of 100 V. (given flux per poles is 0.02 wb)arrow_forwardWhich part of a DC Machine that produces the magnetic flux when the field winding is excited? a. Yoke b. Pole c Armature Winding d. Armature corearrow_forward
- A 250 V DC shunt generator has a constant loss of 1250 W. Find the load current for maximum efficiency. Also find the value of maximum efficiency and output power times maximum efficiency. The armature resistance is 0.1ohm.arrow_forwardThe armature of a dc motor has 648 conductors, 65 % of which are directly under the pole where the flux density is 48,000 lines per in2. If the core diameter is 7 inches and its length is 4 inches and the current in each conductor is 20 A. What is the torque exerted in the armature in N-m?arrow_forwardTwo DC generators are running in parallel. One of the generators may run as a motor, what is the main reason such conditions occur? Explain your answer with the use of a calculation.arrow_forward
- The armature of a dc machine running at 1200 rpm carries 45 A in current. If the induced armature voltage is 130 V, what is the torque developed by the armature?arrow_forwardQ3. B. what are the features of Lap winding of DC machine?arrow_forwardA separately excited dc generator when running at 1200 rpm supplies 200 A at 125 V to a circuit of constant resistance. Armature circuit resistance is 0.10 ohm. Determine the terminal voltage when the speed is dropped to 1000 rpm. Assume that the field current is unaltered.arrow_forward
arrow_back_ios
SEE MORE QUESTIONS
arrow_forward_ios
Recommended textbooks for you
