Automotive Technology
7th Edition
ISBN: 9781337794213
Author: ERJAVEC, Jack.
Publisher: Cengage,
expand_more
expand_more
format_list_bulleted
Concept explainers
Videos
Textbook Question
Chapter 34, Problem 6MC
Which of the following exhaust gases is typically not measured during an I/M 240 test?
a. HC
b. O2
c. NOx
d. CO
Expert Solution & Answer
Want to see the full answer?
Check out a sample textbook solution
Students have asked these similar questions
An injector balance test requires an injector pulse tester and a _____ .
The Diesel Opacity (Smoke Meter) Emissions Inspection procedure requires that the Certified Inspector use an approved diesel opacity (smoke meter) tester to check emissions at the tailpipe and that the following must also be hooked up during the test
What are the equipment/apparatus required to conduct performance test of internal combustion engine?
Chapter 34 Solutions
Automotive Technology
Ch. 34 - A rich air-fuel ratio causes HC emissions to...Ch. 34 - What will result from too little EGR flow? And...Ch. 34 - What can result from a charcoal canister that is...Ch. 34 - What happens if a PCV valve is stuck in the open...Ch. 34 - Explain why the I/M 240 and similar tests are...Ch. 34 - How do you test the efficiency of a secondary AIR...Ch. 34 - List five common causes for high HC emissions.Ch. 34 - Describe carbon monoxide (CO) emissions in...Ch. 34 - An EGR valve that does not fully close can cause...Ch. 34 - A restricted catalytic converter can cause all of...
Ch. 34 - Which of the following statements about EVAP...Ch. 34 - As a catalytic converter begins to deteriorate,...Ch. 34 - How much pressure does a typical EVAP pressure...Ch. 34 - Which of the following exhaust gases is typically...Ch. 34 - Prob. 7MCCh. 34 - While discussing the proper way to test a...Ch. 34 - Prob. 2ASRQCh. 34 - While discussing catalytic converter diagnosis:...Ch. 34 - While discussing EGR valve diagnosis: Technician A...Ch. 34 - While discussing EGR valve diagnosis: Technician A...Ch. 34 - When discussing the diagnosis of a positive back...Ch. 34 - While diagnosing a PCV problem: Technician A says...Ch. 34 - Technician A says that the AIR system should pump...Ch. 34 - While discussing PCV system diagnosis: Technician...Ch. 34 - While discussing EVAP testing: Technician A says...
Knowledge Booster
Learn more about
Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.Similar questions
- HC emissions may come from the tailpipe or sources.arrow_forwardWhile diagnosing the cause of air bubbles in the coolant recovery tank: Technician A checks for a bad head gasket. Technician B checks the radiator cap. Who is correct? Technician A Technician B Both A and B Neither A nor Barrow_forwardWhich of the following is not an effective way to determine if an engine has an internal coolant leak? Performing a pressure test on the system Visually inspecting the exhaust, coolant, and engine oil Using a dye penetrant and black light Using a combustion leak testerarrow_forward
- HOW TO PERFORM LEAK TEST ON HVAC DUCTS? Badly needed asap. Brief and clear Explanation. I will rate helpful. Thank you.arrow_forwardWhich beaker best illustrates what happens when the following acids are dissolved in water?a. HNO2b. HNO3c. HC1d. HFe. HC2H3O2arrow_forwardWhat is the first step in turbocharger inspection?a. Check the air cleaner for a dirty element.b. Open the turbine housing at both ends.c. Start the engine and listen to the system.d. Remove the ducting from the air cleaner to theturbo and examine the area.arrow_forward
- A vehicles intake manifold is warped: Technician A says the manifold may need to be replaced. Technician B says the manifold may be able to be resurfaced flat. Who is correct? a. Technician A b. Technician B c. Both A and B d. Neither A nor Barrow_forwardWhat tool is used to test engine manifold vacuum.arrow_forwardName the three types of stress testing used to test for intermittent ignition component problems and list the procedures for conducting each type of test.arrow_forward
- True or False? A compression gauge will show the amount of air leaking through a cylinder as a percentage.arrow_forwardTrue or False? The first step in removing an engine is usually the removal of the intake and exhaust manifolds.arrow_forwardWhat checks can be performed to know if the lubricating oil of an engine has been contaminated?arrow_forward
arrow_back_ios
SEE MORE QUESTIONS
arrow_forward_ios
Recommended textbooks for you
Automotive Technology: A Systems Approach (MindTa...Mechanical EngineeringISBN:9781133612315Author:Jack Erjavec, Rob ThompsonPublisher:Cengage Learning
Automotive Technology: A Systems Approach (MindTa...
Mechanical Engineering
ISBN:9781133612315
Author:Jack Erjavec, Rob Thompson
Publisher:Cengage Learning
General Industrial Safety; Author: Jim Pytel;https://www.youtube.com/watch?v=RXtF_vQRebM;License: Standard youtube license