Concept explainers
One round face of a 3.25-m, solid, cylindrical plastic-pipe is covered with a thin black coating that completely blocks light. The opposite face is covered with a fluorescent coating that glows when it is struck by light. Two straight, thin, parallel scratches, 0.225 mm apart, are made in the center of the black face. When laser light of wavelength 632.8 nm shines through the slits perpendicular to the black lace, you find that the central bright fringe on the opposite face is 5.82 mm wide, measured between the dark fringes that border it on either side. What is the index of refraction of the plastic?
Want to see the full answer?
Check out a sample textbook solutionChapter 35 Solutions
UNIVERSITY PHYSICS V.2 W/ACCESS >IC<
Additional Science Textbook Solutions
Physics for Scientists and Engineers with Modern Physics
Modern Physics
College Physics: A Strategic Approach (4th Edition)
An Introduction to Thermal Physics
College Physics: A Strategic Approach (3rd Edition)
Physics (5th Edition)
- In a Newtons-rings experiment, a plano-convex glass (n = 1.52) lens having radius r = 5.00 cm is placed on a flat plate as shown in Figure P36.37. When light of wavelength = 650 nm is incident normally, 55 bright rings are observed, with the last one precisely on the edge of the lens. (a) What is the radius R of curvature of the convex surface of the lens? (b) What is the focal length of the lens? Figure P36.37arrow_forwardInterference fringes are produced using Lloyds mirror and a source S of wavelength = 606 nm as shown in Figure P36.41. Fringes separated by y = 1.20 mm are formed on a screen a distance L = 2.00 m from the source. Find the vertical distance h of the source above the reflecting surface. Figure P36.41arrow_forwardA beam of 580-nm light passes through two closely spaced glass plates at close to normal incidence as shown in Figure P27.23. For what minimum nonzero value of the plate separation d is the transmitted light bright?arrow_forward
- A Fraunhofer diffraction pattern is produced on a screen located 1.00 m from a single slit. If a light source of wavelength 5.00 107 m is used and the distance from the center of the central bright fringe to the first dark fringe is 5.00 103 m, what is the slit width? (a) 0.010 0 mm (b) 0.100 mm (c) 0.200 mm (d) 1.00 mm (e) 0.005 00 mmarrow_forwardA thin layer of liquid methylene iodide (n = 1.756) is sandwiched between two flat, parallel plates of glass (n = 1.50). What is the minimum thickness of the liquid layer if normally incident light with λ = 6.00 × 102 nm in air is to be strongly reflected?arrow_forwardA thin layer of liquid methylene iodide (n = 1.76) is sandwiched between two flat, parallel plates of glass (n = 1.42). What is the minimum thickness of the liquid layer if normally incident light with λ= 550 nm in air is to be strongly reflected? 63.0 nm 99.2 nm 78.1 nm 126.0 nmarrow_forward
- Two flat plates of glass with parallel faces are on a table, one plate on the other. Each plate is 11.0 cm long and has a refractive index of 1.55. A very thin sheet of metal foil is inserted under the end of the upper plate to raise it slightly at that end. When you view the glass plates from above with reflected white light, you observe that, at 1.15 mm from the line where the sheets are in contact, the violet light of wavelength 400.0 nm is enhanced in this reflected light, but no visible light is enhanced closer to the line of contact. (a) How far from the line of contact will green light (of wavelength 550.0 nm) and orange light (of wavelength 600.0 nm) first be enhanced? (b) How far from the line of contact will the violet, green, and orange light again be enhanced in the reflected light? (c) How thick is the metal foil holding the ends of the plates apart?arrow_forwardTwo slits spaced 0.250 mm apart are 0.930 m from a screen and illuminated by coherent light of wavelength 630 nm. The intensity at the center of the central maximum is I0. (A) what is the distance on the screen from the center of the central maximum to the first minimum? (B) what is the distance on the screen from the center of the central maximum to the point where the intensity has fallen to I0/2?arrow_forwardLaser light of wavelength 460 nmnm is traveling in air and shines at normal incidence onto the flat end of a transparent plastic rod that has nn = 1.30. The end of the rod has a thin coating of a transparent material that has refractive index 1.75. a)What is the minimum (nonzero) thickness of the coating for which there is maximum transmission of the light into the rod? b)What is the minimum (nonzero) thickness of the coating for which transmission into the rod is minimized?arrow_forward
- A thin film of glycerin (n = 1.473) of thickness 486 nm with air on both sides is illuminated with white light at near normal incidence. What wavelengths will be strongly reflected in the range 300 nm to 700 nm? nm (smallest value) nm nm (largest value)arrow_forwardA 0.45-mm-diameter (circular) hole is illuminated by light that has a wavelength of 550nm. What is the width of the central maximum on a screen 2.0 m behind this hole?arrow_forward
- Principles of Physics: A Calculus-Based TextPhysicsISBN:9781133104261Author:Raymond A. Serway, John W. JewettPublisher:Cengage LearningPhysics for Scientists and EngineersPhysicsISBN:9781337553278Author:Raymond A. Serway, John W. JewettPublisher:Cengage LearningPhysics for Scientists and Engineers with Modern ...PhysicsISBN:9781337553292Author:Raymond A. Serway, John W. JewettPublisher:Cengage Learning