Concept explainers
Figure 31.12 (Section 31.2) shows a loudspeaker system. Low-frequency sounds are produced by the woofer, which is a speaker with large diameter; the tweeter, a speaker with smaller diameter, produces high-frequency sounds. Use diffraction ideas to explain why the tweeter is more effective for distributing high-frequency sounds uniformly over a room than is the woofer.
Want to see the full answer?
Check out a sample textbook solutionChapter 36 Solutions
University Physics with Modern Physics, Volume 1 (Chs. 1-20) and Mastering Physics with Pearson eText & ValuePack Access Card (14th Edition)
Additional Science Textbook Solutions
Essential University Physics: Volume 1 (3rd Edition)
Essential University Physics: Volume 2 (3rd Edition)
Physics for Scientists and Engineers: A Strategic Approach, Vol. 1 (Chs 1-21) (4th Edition)
The Cosmic Perspective (8th Edition)
Sears And Zemansky's University Physics With Modern Physics
Conceptual Physics (12th Edition)
- Table P35.80 presents data gathered by students performing a double-slit experiment. The distance between the slits is 0.0700 mm, and the distance to the screen is 2.50 m. The intensity of the central maximum is 6.50 106 W/m2. What is the intensity at y = 0.500 cm? TABLE P35.80arrow_forwardA double slit interference experiment uses a laser emitting light of two adjacent frequencies v, and v, (v, < v,). The minimum path difference between the interfering beams for which the interference pattern disappears is 12arrow_forwardProblem 18: Consider a single slit that produces its first minimum at 54° for 590 nm light.Randomized Variablesθ1 = 54 °θ2 = 67 °λ1 = 590 nm Part (a) What is the width of the single slit, w, in nanometers?Numeric : A numeric value is expected and not an expression.w = __________________________________________Part (b) Find the wavelength, in nanometers, of light that has its first minimum at 67°.Numeric : A numeric value is expected and not an expression.λ2 = __________________________________________arrow_forward
- If you hold two fingers very close together and look at a brightlight, you see lines between the fingers. What is happening?(a) You are holding your fingers too close to your eye tobe able to focus on it.(b) You are seeing a diffraction pattern.(c) This is a quantum-mechanical tunneling effect.(d) The brightness of the light is overwhelming your eyearrow_forwardBabinet's principle says that the diffraction pattern observed when light falls on an aperture of any shape is the same as that obtained when light falls on an object that is the complement of such aperture. A laser with a wavelength of 600 nm is incident on a hair, generating a diffraction pattern with a width of the principal maximum of 10 mm on a screen located 1 m away from the hair. What is the diameter of this wire?arrow_forwardQ1/ A/ Consider a resonator consisting of two concave spherical mirrors both with radius of curvature 4 m and separated by a distance of 1 m. Calculate the minimum beam diameter of the TEMy mode at the resonator center and on the mirrors when the laser oscillation is Art laser wavelength 2=514.5 nm. Then, Find if this cavity is stable or not. B/ One of the mirrors in A is replaced by a concave mirror of 1.5m radius of curvature, calculate the position of minimum beam radius. Then calculate the beam waist and radius of curvature at 150 cm from M1.arrow_forward
- When an x-ray beam is scattered off the planes of a crystal, the scattered beam creates an interference pattern. This phenomenon is called Bragg scattering. For an observer to measure an interference maximum, two conditions have to be satisfied: 1. The angle of incidence has to be equal to the angle of reflection. 2. The difference in the beam's path from a source to an observer for neighboring planes has to be equal to an integer multiple of the wavelength; that is, 2d sin(0) = mx for m = 1, 2, .... The path difference 2d sin(0) can be determined from the diagram (Figure 1). The second condition is known as the Bragg condition. Figure 1 of 1 d sine d sine Review nstants Part A An x-ray beam with wavelength 0.260 nm is directed at a crystal. As the angle of incidence increases, you observe the first strong interference maximum at an angle 20.5 °. What is the spacing d between the planes of the crystal? Express your answer in nanometers to four significant figures. VE ΑΣΦ ? d = nm…arrow_forward** 38. Two plastic plates (index of refraction n = 1.3) are separated by an air gap of 0.9 µm. Analyze the reflections of light of wavelength 600 nm and conclude whether it will be brightly reflected or not. 0.9 um gap ** 39. The air gap in the previous problem is now filled with a mineral oil whose index of refraction is n = 1.5. Analyze the reflections of light of wavelength 600 nm and conclude if it will be brightly reflected or not.arrow_forwardThere is a microscope that uses a wavelength of 470 nm and is designed to resolve objects of size 8,373 nm (which is defined by the Rayleigh criterion) and uses an objective lens with a diameter that is 3.90 mm. In mm, what's the max distance between the objective lens and the object that is being magnified?arrow_forward
- Consider a laser light illuminating a vertical thin film of polystyrene (n=1.55) of thickness t= 85 nm The thin film is surrounded by air. What should the wavelength of the laser be to observe a bright interference O lambda=403 nm O lambda=527 nm lambda=566 nm lambda= 75 nm lambda=371 nmarrow_forwardYou are a sonographer, and you want to use the best available single-elementtransducer to image the fetus head which is about 10 cm away from themother’s skin. The optimal transducer diameter to use at frequency 6.15 kHz is:a. 5 mmb. 7 mmc. 10 mmd. 15 mmarrow_forwardLaser light at 600 nm falls on a double-slit apparatus with slit separation 6 μm. Find the separation between the following fringes as seen on a screen 1 m from the slits. (a) The first and second bright fringes. (b) The third and fourth bright fringes.arrow_forward
- Physics for Scientists and Engineers: Foundations...PhysicsISBN:9781133939146Author:Katz, Debora M.Publisher:Cengage LearningPrinciples of Physics: A Calculus-Based TextPhysicsISBN:9781133104261Author:Raymond A. Serway, John W. JewettPublisher:Cengage Learning