Concept explainers
Doorway Diffraction. Sound of frequency 1250 Hz leaves a room through a 1.00-m-wide doorway (see Exercise 36.5). At which angles relative to the centerline perpendicular to the doorway will someone outside the room hear no sound? Use 344 m/s for the speed of sound in air and assume that the source and listener are both far enough from the doorway for Fraunhofer diffraction to apply. You can ignore effects of reflections.
Want to see the full answer?
Check out a sample textbook solutionChapter 36 Solutions
University Physics with Modern Physics, Volume 1 (Chs. 1-20) and Mastering Physics with Pearson eText & ValuePack Access Card (14th Edition)
Additional Science Textbook Solutions
College Physics
Conceptual Physical Science (6th Edition)
Applied Physics (11th Edition)
Physics for Scientists and Engineers: A Strategic Approach, Vol. 1 (Chs 1-21) (4th Edition)
Physics for Scientists and Engineers with Modern Physics
- A riverside warehouse has several small doors facing the river. Two of these doors are open as shown in Figure P27.17. The walls of the warehouse are lined with sound-absorbing material. Two people stand at a distance L = 150 in from the wall with the open doors. Person A stands along a line passing through the midpoint between the open doors, and person B stands a distance y = 20 m to his side. A boat o the river sounds its horn. To person A, the sound is loud and clear. To person B, the sound is barely audible. The principal wavelength of the sound waves is 5.00 m. Assuming person B is at the position of the first minimum, determine the distance d between the doors, center to center.arrow_forwardFigure P36.35 shows a radio-wave transmitter and a receiver separated by a distance d = 50.0 m and both a distance h = 35.0 m above the ground. The receiver can receive signals both directly from the transmitter and indirectly from signals that reflect from the ground. Assume the ground is level between the transmitter and receiver and a 180 phase shift occurs upon reflection. Determine the longest wavelengths that interfere (a) constructively and (b) destructively. Figure P36.35 Problems 35 and 36.arrow_forwardFigure P24.69 shows a radio-wave transmitter and a receiver, both h = 50.0 m above the ground and d = 6.00 102 m apart. The receiver can receive signals directly from the transmitter and indirectly from signals that bounce off the ground. If the ground is level between the transmitter and receiver and a /2 phase shift occurs upon reflection, determine the longest wavelengths that interior (a) constructively and (b) destructively. Figure P24.69arrow_forward
- Table P35.80 presents data gathered by students performing a double-slit experiment. The distance between the slits is 0.0700 mm, and the distance to the screen is 2.50 m. The intensity of the central maximum is 6.50 106 W/m2. What is the intensity at y = 0.500 cm? TABLE P35.80arrow_forwardThe analysis of any two-point source interference pattern and a successful determination of wavelength demands an ability to sort through the measured information and equating the values with the symbols in Young's equation. Apply your understanding by interpreting the following statements and identifying the values of y, d, m and L. Finally, perform some conversions of the given information such that all information share the same unit. Two sources separated by 0.500 mm produce an interference pattern 525 cm away. The fifth and the second antinodal line on the same side of the pattern are separated by 98 mm. y= ________ d=________ m=_______ L=________arrow_forwardAt the metal fabrication company where you work, you are asked to measure the diameter D of a very small circular hole in a thin, vertical metal plate. To do so, you pass coherent monochromatic light with wavelength 562 nm through the hole and observe the diffraction pattern on a screen that is a distance x from the hole. You measure the radius r of the first dark ring in the diffraction pattern. You make the measurements for four values of x. Your results are given in the table. (a) Use each set of measurements to calculate D. Because the measurements contain some error, calculate the average of the four values of D and take that to be your reported result. (b) For x = 1.00 m, what are the radii of the second and third dark rings in the diffraction pattern?arrow_forward
- the thickness of human hair is to be measured using the interference pattern produced by an air wedge. red light with a wavelength of 638nm is used on an air wedge that is 25.0cm long. If 10 bright fringes are counted across 1.06cm in the air wedge, what is the thickness of the hairarrow_forwardLaser light of wavelength 627.0 nm passes through a double-slit arrangement at the front of a lecture room, reflects off a mirror 29.2 m away at the back of the room, and then produces an interference pattern on a screen at the front of the room. The distance between adjacent bright fringes is 9.52 cm. What is the slit separation in meters? Number i 0.000192 Units marrow_forwardIn your summer internship at an optical products company, you need to measure the wavelength λ of the light that is produced by a laser. To do this, you pass the light from the laser through two narrow slits that are separated by a distance d. You observe the interference pattern on a screen that is 0.900 m from the slits and measure the separation Δy between the adjacent bright bangs in the part of the picture that is near the center of the screen Using a microscope, you measure d. However, both Δy and d are small and difficult to measure accurately, so you repeat the measurements for several pairs of slits, each with a different value of d. Your results appear in Figure P35.52, where you have plotted Δy as a function of 1/d. The line on the graph is the best straight line for the data. (a)Explain why data points drawn in this way are close to a straight line. (b) Use Figure P35.52 to calculate λ.arrow_forward
- In your summer job at an optics company, you are asked to measure the wavelength λ of the light that is produced by a laser. To do so, you pass the laser light through two narrow slits that are separated by a distance d. You observe the interference pattern on a screen that is 0.900 m from the slits and measure the separation ∆y between adjacent bright fringes in the portion of the pattern that is near the center of the screen. Using a microscope, you measure d. But both ∆y and d are small and difficult to measure accurately, so you repeat the measurements for several pairs of slits, each with a different value of d. Your results are shown in Fig. P35.50, where you have plotted ∆y versus 1/d. The line in the graph is the best-fit straight line for the data. (a) Explain why the data points plotted this way fall close to a straight line. (b) Use Fig. to calculate λ.arrow_forwardPlease explain each step....You shine monochromatic light with wavelength 720 nm through a slit that has a width of 0.750 mm and observe a diffraction pattern on a screen that is 3.60 m from the slit. The intensity at the center of the central maximum is Io = 7.80 W/m2. What is the intensity of the light at a point on the pattern that is halfway between the center of the central maximum and the first minimum of interference? The purple line in the figure shows the points that are halfway between the center of the central max. and the first min.arrow_forwardAnti-reflective coatings on camera lenses and glasses work by utilizing thin-film interference to greatly reduce reflected light. (Ever wondered why your glasses have a bluish/magenta tint when they reflect light? It's from that thin film!)We wish to coat flat glass (n=1.50) with a transparent material (n=1.25), so that reflection of light at wavelength 402.375nm is eliminated by interference. What is the minimum thickness (nm) of the coating that will work for our purposes?arrow_forward
- Principles of Physics: A Calculus-Based TextPhysicsISBN:9781133104261Author:Raymond A. Serway, John W. JewettPublisher:Cengage LearningPhysics for Scientists and EngineersPhysicsISBN:9781337553278Author:Raymond A. Serway, John W. JewettPublisher:Cengage LearningPhysics for Scientists and Engineers with Modern ...PhysicsISBN:9781337553292Author:Raymond A. Serway, John W. JewettPublisher:Cengage Learning
- Physics for Scientists and Engineers: Foundations...PhysicsISBN:9781133939146Author:Katz, Debora M.Publisher:Cengage LearningCollege PhysicsPhysicsISBN:9781305952300Author:Raymond A. Serway, Chris VuillePublisher:Cengage Learning