To prove: The half-cycles during which the diode conducts, conduction begins at an angle θ = sin − 1 ( V D V s ) and terminates at π − θ for the total conduction angle of π − 2 θ .

Question

Want to see the full answer?

Answer 1

Question

Chapter 4.5, Problem 4.19E

(a)

To determine

To prove: The half-cycles during which the diode conducts, conduction begins at an angle θ=sin−1(VDVs) and terminates at π−θ for the total conduction angle of π−2θ .

(b)

To determine

To prove: The average value of the output voltage is Vo≃(1π)Vs−VD2 .

(c)

To determine

To prove: That the peak diode current is (Vs−VD)R .

(d)

To determine

The value of θ , conduction angle, average output voltage, peak current and the peak inverse voltage.

Expert Solution & Answer

Want to see the full answer?

Check out a sample textbook solution

See solution

Students have asked these similar questions

This problem concerns the following three samples of silicon, each of which has a different doping level: sample a : 6.25×10^15" cm" arsenic sample b: 10^16 cm boron, 5x10^15 cm phosphorous sample c : intrinsic (no doping) Complete the table like that shown below for these three samples. Assume that at room temperature the electron mobility He is 1600 cm /.s, the hole mobility H, is 600 cm2/V.s, and the intrinsic carrier concentration n, is (1/352) x10^10 cm.a- Find the resistivity in (Ω.cm) of sample a. b- Find the conductivity in (Ω.cm)-1 of sample bc- find the resistivity in (Ω.cm) of sample c.

a. SketchtheoutputvoanddeterminethedcleveloftheoutputforthenetworkofFig.2.49. Repeat part (a) if the ideal diode is replaced by a silicon diode. Repeat parts (a) and (b) if Vm is increased to 200 V, and compare solutions using Eqs. (2.7) and (2.8).

Given a silicon sample of unknown doping. Hall measurement provides the following information: W = 1000 mm, A = 2.5 × 10-3cm2, I = 2 10-3 A, magnetic field = 500 Gauss, hall voltage of +150 mV. The majority carriers are: Electrons Holes 1000 150

Answer 2

Question

Chapter 4.5, Problem 4.19E

(a)

To determine

To prove: The half-cycles during which the diode conducts, conduction begins at an angle θ=sin−1(VDVs) and terminates at π−θ for the total conduction angle of π−2θ .

(b)

To determine

To prove: The average value of the output voltage is Vo≃(1π)Vs−VD2 .

(c)

To determine

To prove: That the peak diode current is (Vs−VD)R .

(d)

To determine

The value of θ , conduction angle, average output voltage, peak current and the peak inverse voltage.

Expert Solution & Answer

Want to see the full answer?

Check out a sample textbook solution

See solution

Answer 3

Question

Chapter 4.5, Problem 4.19E

(a)

To determine

To prove: The half-cycles during which the diode conducts, conduction begins at an angle θ=sin−1(VDVs) and terminates at π−θ for the total conduction angle of π−2θ .

(b)

To determine

To prove: The average value of the output voltage is Vo≃(1π)Vs−VD2 .

(c)

To determine

To prove: That the peak diode current is (Vs−VD)R .

(d)

To determine

The value of θ , conduction angle, average output voltage, peak current and the peak inverse voltage.

Expert Solution & Answer

Want to see the full answer?

Check out a sample textbook solution

See solution

Answer 4

Question

Chapter 4.5, Problem 4.19E

(a)

To determine

To prove: The half-cycles during which the diode conducts, conduction begins at an angle θ=sin−1(VDVs) and terminates at π−θ for the total conduction angle of π−2θ .

(b)

To determine

To prove: The average value of the output voltage is Vo≃(1π)Vs−VD2 .

(c)

To determine

To prove: That the peak diode current is (Vs−VD)R .

(d)

To determine

The value of θ , conduction angle, average output voltage, peak current and the peak inverse voltage.

Expert Solution & Answer

Want to see the full answer?

Check out a sample textbook solution

See solution

Answer 5

Chapter 4.5, Problem 4.19E

(a)

To determine

To prove: The half-cycles during which the diode conducts, conduction begins at an angle θ=sin−1(VDVs) and terminates at π−θ for the total conduction angle of π−2θ .

(b)

To determine

To prove: The average value of the output voltage is Vo≃(1π)Vs−VD2 .

(c)

To determine

To prove: That the peak diode current is (Vs−VD)R .

(d)

To determine

The value of θ , conduction angle, average output voltage, peak current and the peak inverse voltage.

Answer 6

Chapter 4.5, Problem 4.19E

(a)

To determine

To prove: The half-cycles during which the diode conducts, conduction begins at an angle θ=sin−1(VDVs) and terminates at π−θ for the total conduction angle of π−2θ .

Answer 7

Chapter 4.5, Problem 4.19E

(a)

To determine

To prove: The half-cycles during which the diode conducts, conduction begins at an angle θ=sin−1(VDVs) and terminates at π−θ for the total conduction angle of π−2θ .

Answer 8

(b)

To determine

To prove: The average value of the output voltage is Vo≃(1π)Vs−VD2 .

Answer 9

(b)

To determine

To prove: The average value of the output voltage is Vo≃(1π)Vs−VD2 .

Answer 10

(c)

To determine

To prove: That the peak diode current is (Vs−VD)R .

Answer 11

(c)

To determine

To prove: That the peak diode current is (Vs−VD)R .

Answer 12

(d)

To determine

The value of θ , conduction angle, average output voltage, peak current and the peak inverse voltage.

Answer 13

(d)

To determine

The value of θ , conduction angle, average output voltage, peak current and the peak inverse voltage.

Answer 14

Expert Solution & Answer

Answer 15

Expert Solution & Answer

Answer 16

Want to see the full answer?

Check out a sample textbook solution

See solution

Answer 17

Ch. 4.1 - Prob. 4.1E Ch. 4.1 - Prob. 4.2E Ch. 4.1 - Prob. 4.3E Ch. 4.1 - Prob. 4.4E Ch. 4.1 - Prob. 4.5E Ch. 4.2 - Prob. 4.6E Ch. 4.2 - Prob. 4.7E Ch. 4.2 - Prob. 4.8E Ch. 4.2 - Prob. 4.9E Ch. 4.3 - Prob. 4.10E

To prove: The half-cycles during which the diode conducts, conduction begins at an angle θ = sin − 1 ( V D V s ) and terminates at π − θ for the total conduction angle of π − 2 θ .

Concept explainers

Videos

To prove: The half-cycles during which the diode conducts, conduction begins at an angle θ=sin−1(VDVs) and terminates at π−θ for the total conduction angle of π−2θ .

To prove: The average value of the output voltage is Vo≃(1π)Vs−VD2 .

To prove: That the peak diode current is (Vs−VD)R .

The value of θ , conduction angle, average output voltage, peak current and the peak inverse voltage.

Want to see the full answer?

Chapter 4 Solutions