Industrial Motor Control
7th Edition
ISBN: 9781133691808
Author: Stephen Herman
Publisher: Cengage Learning
expand_more
expand_more
format_list_bulleted
Concept explainers
Textbook Question
Chapter 47, Problem 13RQ
If dual-element time-delay fuses are to be used as the short-circuit protective device, what size fuses should be used to protect the circuit in question 12?
Expert Solution & Answer
Want to see the full answer?
Check out a sample textbook solutionStudents have asked these similar questions
26-
Identify the device which requires external electrical energy source.
a.
Thermocouple
b.
Thermistor
c.
Piezoelectric accelerometer
d.
None of the above
11-
Identify the position of plunger in a LVDT in which emf induced in upper secondary coil is lesser than emf induced in lower secondary coil.
a.
Middle position
b.
None of the above
c.
Upper side position
d.
Lower side position
To protect electronic circuits, some voltage regulatorshave a __ circuit built into them.
Chapter 47 Solutions
Industrial Motor Control
Knowledge Booster
Learn more about
Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.Similar questions
- If dual-element time delay fuses are to be used as the short circuit protective device, what size fuses should be used to protect the circuit in question #12? Five 5 HP, three-phase motors with NEMA code B are connected to a 240-volt line. The conductors are copper with type THWN insulation. What size conductor should be used to supply all of these motors?arrow_forwardThe secondary of the transformer in question #3 has a rated voltage of 2400 volts. What size fuse should be used to provide branch circuit protection?arrow_forwardPower-consuming devices are wired in _____(series orparallel).arrow_forward
- A 10 kVA transformer has a primary voltage of 208 volts and a secondary voltage of 120 volts. What size circuit breaker should be used to protect the primary winding?arrow_forwardWhat size conductor should be used to connect the primary of the transformer described in question #6? Assume the conductor to be copper with type THW insulation.arrow_forwardAn inductor has an inductance of 0.025 H and a wire resistance of 3 Ω. How long will it take the current to reach its full Ohm’s law value?arrow_forward
- What size overcurrent device should be used to protect the primary of a 480/120 volt 15 kVA transformer?arrow_forwardRefer to the circuit shown in Figure 1123. What is the function of resistor R3 in the circuit?arrow_forwardThe short-circuit protective device supplying the motors in question #10 is an inverse-time circuit breaker. What size circuit breaker should be used?arrow_forward
- There is an ambient temperature of 65°C with a temperature rating of the conductor as 75°C. What is the ambient temperature correction factor based on 86°F?arrow_forwardWhy is shielded wire used for signal runs?arrow_forwardAn 11-pin control relay contains three sets of single-pole double throw contacts. List the pin numbers by pairs that can be used as normally open contacts.arrow_forward
arrow_back_ios
arrow_forward_ios
Recommended textbooks for you
- Electrical Transformers and Rotating MachinesMechanical EngineeringISBN:9781305494817Author:Stephen L. HermanPublisher:Cengage LearningUnderstanding Motor ControlsMechanical EngineeringISBN:9781337798686Author:Stephen L. HermanPublisher:Delmar Cengage LearningRefrigeration and Air Conditioning Technology (Mi...Mechanical EngineeringISBN:9781305578296Author:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill JohnsonPublisher:Cengage Learning
Electrical Transformers and Rotating Machines
Mechanical Engineering
ISBN:9781305494817
Author:Stephen L. Herman
Publisher:Cengage Learning
Understanding Motor Controls
Mechanical Engineering
ISBN:9781337798686
Author:Stephen L. Herman
Publisher:Delmar Cengage Learning
Refrigeration and Air Conditioning Technology (Mi...
Mechanical Engineering
ISBN:9781305578296
Author:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson
Publisher:Cengage Learning
General Industrial Safety; Author: Jim Pytel;https://www.youtube.com/watch?v=RXtF_vQRebM;License: Standard youtube license