Concept explainers
Why are NEMA symbols representing such components as push buttons, limit switches, and float switches not used in a programmable controller schematic?
The reason why the NEMA symbols representing the components like push buttons, limit switches and the float switches are not used in the programmable control switches.
Explanation of Solution
The NEMA symbols are the symbols that are used to represent the electrical components.
Since, the PLC recognize only the closed and the open contacts only and it do not recognize that whether the swtich is connected to a component like push button, float swtich or the limit swtich. This is why the NEMA swtich is used in the programming of PLC.
Thus, to give the idea to PLC about the type of components connected, the NEMA symbols are used.
Want to see more full solutions like this?
Chapter 54 Solutions
Industrial Motor Control
- Why are normally closed components such as STOP push buttons programmed normally open instead of normally closed when entering a program into the memory of a PLC?arrow_forwardName the four basic sections of a programmable logic controller.arrow_forwardWhat is the purpose of the key switch located on the front of the CPU in many programmable logic controllers?arrow_forward
- Block diagram and explanation of the applications of open loop system: Automatic washing machine, Automatic toaster system, Traffic light controller and Furnace without thermostatic control but with timing devicearrow_forward6 Identify the system which is unreliable. a. Open loop and closed loop System b. Open loop System c. None of the above d. Closed loop systemarrow_forwardOutline the advantages of a PLC system over a traditional control system.arrow_forward
- Identify the following elements of the given closed loop control system.(i) Process Element(ii) Feedback Element (iii) Control Element (iv) Correction Elementarrow_forward1. Ward Leonard method is ___________a) Armature control methodb) Field control methodc) Combination of armature control method and field control methodd) Totally different from armature and field control methodarrow_forwardSketch an automatic control system diagram for:1. Hydraulic Control System2. Electric Control System3. Pneumatic Control Systemarrow_forward
- 24- Identify the output device which is connected to a controller in which all the control actions are performed by a microcontroller. a. Strain gauge b. Valve c. LVDT d. Proximity switcharrow_forwardThe graph for on-off control mode operation is............arrow_forwardThere is a CNC system with one sensor and one actuator. Draw a block diagram f. CNC system with a master PC and a PC based controller. Explain the tasks of componentsarrow_forward
- Understanding Motor ControlsMechanical EngineeringISBN:9781337798686Author:Stephen L. HermanPublisher:Delmar Cengage Learning