Concept explainers
If you are using a wrench to loosen a very stubborn nut, you can make the job easier by using a “cheater pipe.” This is a piece of pipe that slides over the handle of the wrench, as shown in Figure Q7.4, making it effectively much longer. Explain why this would help you loosen the nut.
Figure Q7.4
Want to see the full answer?
Check out a sample textbook solutionChapter 7 Solutions
College Physics: A Strategic Approach Technology Update, Books a la Carte Plus Mastering Physics with Pearson eText -- Access Card Package (3rd Edition)
Additional Science Textbook Solutions
University Physics with Modern Physics (14th Edition)
Applied Physics (11th Edition)
Physics for Scientists and Engineers: A Strategic Approach with Modern Physics (4th Edition)
Conceptual Physical Science (6th Edition)
Essential University Physics: Volume 1 (3rd Edition)
Sears And Zemansky's University Physics With Modern Physics
- A crane of mass m1 = 3 000 kg supports a load of mass m2 = 10 000 kg as shown in Figure P10.36. The crane is pivoted with a frictionless pin at A and rests against a smooth support at B. Find the reaction forces at (a) point A and (b) point B. Figure P10.36arrow_forwardA propeller consists of two blades each 3.0 m in length and mass 120 kg each. The propeller can be approximated by a single rod rotating about its center of mass. The propeller starts from rest and rotates up to 1200 rpm in 30 seconds at a constant rate. (a) What is the angular momentum of the propeller at t=10s ; t=20s ? (b) What is the torque on the propeller?arrow_forwardIf the system shown in Figure P8.37 is set in rotation about each of the axes mentioned in Problem 37, find the torque that will produce an angular acceleration of 1.50 rad/s2 in each case. Figure P8.37 Problems 37 and 38.arrow_forward
- Four objects are held in position at the corners of a rectangle by light rods as shown in Figure P8.37. Find the moment of inertia of the system about (a) the x-axis, (b) they-axis, and (c) an axis through O and perpendicular to the page.arrow_forwardFour objects are held in position at the corners of a rectangle by light rods as shown in Figure P8.37. Find the moment of inertia of the system about (a) the x-axis, (b) they-axis, and (c) an axis through O and perpendicular to the page.arrow_forwardA cylinder with moment of inertia I1 rotates with angular velocity 0 about a frictionless vertical axle. A second cylinder, with moment of inertia I2, initially not. rotating, drops onto the first cylinder (Fig. P8.73). Because the surfaces are rough, the two cylinders eventually reach the same angular speed . (a) Calculate . (b) Show that kinetic energy is lost in this situation, and calculate the ratio of the final lo the initial kinetic energy. Figure P8.73arrow_forward
- A discus thrower rotates with a discus in his hand before letting it go. (a) How does his moment of inertia change after releasing the discus? (b) What would be a good approximation to use in calculating the moment of inertia of the discus thrower and discus?arrow_forwardFigure OQ10.6 shows a system of four particles joined by light, rigid rods. Assume a = b and M is larger than m. About which of the coordinate axes does the system have (i) the smallest and (ii) the largest moment of inertia? (a) the x axis (b) the y axis (c) the z axis, (d) The moment of inertia is the same small value for two axes, (e) The moment of inertia is the same for all three axes.arrow_forwardHeading straight toward the summit of Pikes Peak, an airplane of mass 12 000 kg flies over the plains of Kansas at nearly constant altitude 4.30 km with constant velocity 175 m/s west. (a) What is the airplanes vector angular momentum relative to a wheat farmer on the ground directly below the airplane? (b) Does this value change as the airplane continues its motion along a straight line? (c) What If? What is its angular momentum relative to the summit of Pikes Peak?arrow_forward
- As shown in Figure OQ10.7, a cord is wrapped onto a cylindrical reel mounted on a fixed, friction less, horizontal axle. When does the reel have a greater magnitude of angular acceleration? (a) When the cord is pulled down with a constant force of 50 N. (b) When an object of weight 50 X is hung from the cord and released, (c) The angular accelerations in parts (a) and (b) are equal, (d) It is impossible to determine.arrow_forwardBIO The arm in Figure P10.35 weighs 41.5 N. The gravitational force on the arm acts through point A. Determine the magnitudes of the tension force F1 in the deltoid muscle and the force Fs exerted by the shoulder on the humerus (upper-arm bone) to hold the arm in the position shown. Figure P10.35arrow_forwardUnreasonable Results You are told that a basketball player spins the ball with an angular acceleration of 100 rad/s2. (a) What is the ball's final angular velocity if the ball stairs from rest and the acceleration lasts 2.00 s? (b) What is unreasonable about the result? (c) Which premises are unreasonable or inconsistent?arrow_forward
- College PhysicsPhysicsISBN:9781305952300Author:Raymond A. Serway, Chris VuillePublisher:Cengage LearningPrinciples of Physics: A Calculus-Based TextPhysicsISBN:9781133104261Author:Raymond A. Serway, John W. JewettPublisher:Cengage LearningPhysics for Scientists and Engineers, Technology ...PhysicsISBN:9781305116399Author:Raymond A. Serway, John W. JewettPublisher:Cengage Learning
- College PhysicsPhysicsISBN:9781285737027Author:Raymond A. Serway, Chris VuillePublisher:Cengage LearningPhysics for Scientists and Engineers with Modern ...PhysicsISBN:9781337553292Author:Raymond A. Serway, John W. JewettPublisher:Cengage LearningPhysics for Scientists and EngineersPhysicsISBN:9781337553278Author:Raymond A. Serway, John W. JewettPublisher:Cengage Learning