Student Workbook for College Physics: A Strategic Approach
4th Edition
ISBN: 9780134609898
Author: Knight (Professor Emeritus), Randall D.; Jones, Brian; Field, Stuart
Publisher: PEARSON
expand_more
expand_more
format_list_bulleted
Question
Chapter 8, Problem 3P
To determine
To find: The distance that the man can stand close to the right edge of the picnic table without the table tipping over.
Expert Solution & Answer
Trending nowThis is a popular solution!
Students have asked these similar questions
Figure P8.29 shows a uniformbeam of mass m pivoted atits lower end, with a horizontalspring attached between its topend and a vertical wall. Thebeam makes an angle θ with thehorizontal. Find expressions for(a) the distance d the spring isstretched from equilibrium and(b) the components of the forceexerted by the pivot on thebeam.
The chewing muscle, the masseter, is one of the strongest in the human body. It isattached to the mandible (lower jawbone) as shown in Figure P8.33a. The jawbone ispivoted about a socket just in front of the auditory canal. The forces acting on the jawboneare equivalent to those acting on the curved bar in Figure P8.33b.
Find the x - and y -coordinates of the center of gravity for the boomerang in Figure P8.12a. modeling the boomerang as in Figure P8.12b, where each uniform leg of the model has a length of 0.300 m and a mass of0.250 kg. (Note: Treat the legs like thin rods.)
Chapter 8 Solutions
Student Workbook for College Physics: A Strategic Approach
Ch. 8 - Prob. 1CQCh. 8 - Could a ladder on a level floor lean against a...Ch. 8 - Prob. 3CQCh. 8 - Prob. 4CQCh. 8 - Prob. 5CQCh. 8 - Prob. 6CQCh. 8 - Prob. 7CQCh. 8 - A spring exerts a 10 N force after being stretched...Ch. 8 - Prob. 9CQCh. 8 - A typical mattress has a network of springs that...
Ch. 8 - Take a spring and cut it in half to make two...Ch. 8 - A wire is stretched right to its breaking point by...Ch. 8 - Prob. 13CQCh. 8 - Prob. 14CQCh. 8 - Steel nails are rigid and unbending. Steel wool is...Ch. 8 - Two children hold opposite ends of a lightweight,...Ch. 8 - Prob. 19MCQCh. 8 - Prob. 20MCQCh. 8 - Prob. 21MCQCh. 8 - Prob. 22MCQCh. 8 - Prob. 23MCQCh. 8 - Prob. 24MCQCh. 8 - Prob. 25MCQCh. 8 - Prob. 26MCQCh. 8 - You have a heavy piece of equipment hanging from a...Ch. 8 - Prob. 1PCh. 8 - Prob. 2PCh. 8 - Prob. 3PCh. 8 - Prob. 4PCh. 8 - Youre carrying a 3.6-m-long, 25 kg pole to a...Ch. 8 - Prob. 6PCh. 8 - Prob. 7PCh. 8 - Prob. 9PCh. 8 - Prob. 11PCh. 8 - Prob. 13PCh. 8 - Prob. 14PCh. 8 - Prob. 15PCh. 8 - The stability of a vehicle is often rated by the...Ch. 8 - Prob. 18PCh. 8 - A car manufacturer claims that you can drive its...Ch. 8 - Prob. 20PCh. 8 - An orthodontic spring, connected between the upper...Ch. 8 - Prob. 22PCh. 8 - Experiments using optical tweezers measure the...Ch. 8 - Prob. 24PCh. 8 - One end of a 10-cm-long spring is attached to the...Ch. 8 - Prob. 26PCh. 8 - A spring has an unstretched length of 10 cm. It...Ch. 8 - A spring stretches 5.0 cm when a 0.20 kg block is...Ch. 8 - You need to make a spring scale to measure the...Ch. 8 - Prob. 30PCh. 8 - A force stretches a wire by 1.0 mm. a. A second...Ch. 8 - Prob. 32PCh. 8 - What hanging mass will stretch a 2.0-m-long,...Ch. 8 - An 80-cm-long, 1.0-mm-diameter steel guitar string...Ch. 8 - A mineshaft has an ore elevator hung from a single...Ch. 8 - The normal force of the ground on the foot can...Ch. 8 - A three-legged wooden bar stool made out of solid...Ch. 8 - Prob. 38PCh. 8 - Prob. 39PCh. 8 - Prob. 40PCh. 8 - A glass optical fiber in a communications system...Ch. 8 - The Achilles tendon connects the muscles in your...Ch. 8 - Prob. 44PCh. 8 - Prob. 47PCh. 8 - Prob. 48PCh. 8 - Prob. 49PCh. 8 - Prob. 51GPCh. 8 - Prob. 52GPCh. 8 - Prob. 53GPCh. 8 - Prob. 55GPCh. 8 - Two identical, side-by-side springs with spring...Ch. 8 - Prob. 57GPCh. 8 - Prob. 58GPCh. 8 - Prob. 59GPCh. 8 - A 25 kg child bounces on a pogo stick. The pogo...Ch. 8 - Prob. 61GPCh. 8 - In the hammer throw, an athlete spins a heavy mass...Ch. 8 - There is a disk of cartilage between each pair of...Ch. 8 - Orb spiders make silk with a typical diameter of...Ch. 8 - Larger animals have sturdier bones than smaller...Ch. 8 - Prob. 67GPCh. 8 - Prob. 68GPCh. 8 - Prob. 69MSPPCh. 8 - Prob. 70MSPPCh. 8 - Prob. 71MSPPCh. 8 - Prob. 72MSPP
Knowledge Booster
Similar questions
- Torque and the Two Conditions for Equilibrium 17. The arm in Figure P8.17 weighs 41.5 N. The force of gravity acting on the arm acts through point A. Determine the magnitudes of the tension force Ft, in the deltoid muscle and the force Fs exerted by the shoulder on the humerus (upper-arm bone) to hold the arm in the position shown. Figure P8.17arrow_forwardThe Iron Cross When a gymnast weighing 750 N executes the iron cross as in Figure lN.91a, the primary muscles involved in supporting this position are the latissimus dorsi (lats") and the pectoralis major (pecs"). The rings exert an upward force on the aims and support the weight of the gymnast. The force exerted by the shoulder joint on the arm is labeled Fs, while the two muscles exert a total force Fw on the arm. Estimate the magnitude of the force Fw. Note that one ring supports half the weight of the gymnast, which is 375 N as indicated in Figure P8.91b. Assume that the force Fw acts at an angle of 45 below the horizontal at a distance of 4.0 cm from the shoulder joint In your estimate, take the distance from the shoulder joint to the hand to be L = 70 cm and ignore the weight of the arm.arrow_forwardBIO When a gymnast performing on the rings executes the iron cross, he maintains the position at rest shown in Figure P10.85a. In this maneuver, the gymnasts feet (not shown) are off the floor. The primary muscles involved in supporting this position are the latissimus dorsi (lats) and the pectoralis major (pecs). One of the rings exerts an upward fore Fh on a hand as shown in Figure P10.85b. The force Fs is exerted by the shoulder joint on the arm. The latissimus dorsi and pectoralis major muscles exert a total force Fm on the arm. (a) Using the information in the figure, find the magnitude of the force Fm. (b) Suppose an athlete in training cannot perform the iron cross but can hold a position similar to the figure in which the arms make a 45 angle with the horizontal rather than being horizontal. Why is this position easier for the athlete? Figure P10.85arrow_forward
- A cook holds a 2.00-kg carton of milk at arm's length P8.19). What force FB must be exerted by the biceps muscle? (Ignore the weight of the forearm.) Figure P8.19arrow_forwardQ8 A meter stick balances horizontally on a knife-edge at the 50.0 cm mark. With two 3.62 g coins stacked over the 30.9 cm mark, the stick is found to balance at the 38.4 cm mark. What is the mass of the meter stick?arrow_forwardLuc, who is 1.80 m tall and weighs 950 N, is standing at the center of a playground merry-go-round with his arms extended, holding a 4.0 kg dumbbell in each hand. The merry-go-round can be modeled as a 4.0-m-diameter disk with a weight of 1500 N. Luc's body can be modeled as a uniform 40-cm-diameter cylinder with massless arms extending to hands that are 85 cm from his center. The merry-go-round is coasting at a steady 35 rpm when Luc brings his hands in to his chest. Afterward, what is the angular velocity, in rpm, of the merry-go-round?arrow_forward
- An 82.0 kg-diver stands at the edge of a light 5.00-m diving board, which is supported by two narrow pillars 1.60 m apart, as shown in the figure. Q1) Why is the direction of the force exerted on the diving board by pillar A upward? Q2) Why is the direction of the force exerted on the diving board by pillar B downward?arrow_forwardThe board sandwiched between two other boards in Figure P4.91 weighs 95.5 N. If the coefficient of friction between the boards is 0.663, what must be the magnitude of the compression forces (assumed to be horizontal) acting on both sides of the center board to keep it from slipping? Figure P4.91arrow_forwardWhen a person stands on tiptoe (a strenuous position), the position of the foot is as shown in Figure P8.24a. The total gravitational force on the body, Fg, is supported by the force n exerted by the floor on the toes of one foot. A mechanical model of the situation is shown in Figure P8.24b, where T is the force exerted by the Achilles tendon on the foot and R is the force exerted by the tibia on the foot. Find the values of T, R, and when Fg = n = 700. N. Figure P8.24arrow_forward
- A crane of mass m1 = 3 000 kg supports a load of mass m2 = 10 000 kg as shown in Figure P10.36. The crane is pivoted with a frictionless pin at A and rests against a smooth support at B. Find the reaction forces at (a) point A and (b) point B. Figure P10.36arrow_forwardFigure P10.31 shows a claw hammer being used to pull a nail out of a horizontal board. The mass of the hammer is 1.00 kg. A force of 150 N is exerted horizontally as shown, and the nail does not yet move relative to the board. Find (a) the force exerted by the hammer claws on the nail and (b) the force exerted by the surface on the point of contact with the hammer head. Assume the force the hammer exerts on the nail is parallel to the nail. Figure P10.31arrow_forward
arrow_back_ios
arrow_forward_ios
Recommended textbooks for you
College PhysicsPhysicsISBN:9781305952300Author:Raymond A. Serway, Chris VuillePublisher:Cengage Learning
Principles of Physics: A Calculus-Based TextPhysicsISBN:9781133104261Author:Raymond A. Serway, John W. JewettPublisher:Cengage Learning
College PhysicsPhysicsISBN:9781285737027Author:Raymond A. Serway, Chris VuillePublisher:Cengage Learning
College Physics
Physics
ISBN:9781305952300
Author:Raymond A. Serway, Chris Vuille
Publisher:Cengage Learning
Principles of Physics: A Calculus-Based Text
Physics
ISBN:9781133104261
Author:Raymond A. Serway, John W. Jewett
Publisher:Cengage Learning
College Physics
Physics
ISBN:9781285737027
Author:Raymond A. Serway, Chris Vuille
Publisher:Cengage Learning