The mechanical advantage of nail puller.

Question

Want to see the full answer?

Answer 1

Question

Chapter 9, Problem 22PE

To determine

The mechanical advantage of nail puller.

Expert Solution & Answer

Want to see the full answer?

Check out a sample textbook solution

See solution

Students have asked these similar questions

A uniform disk of mass 401 kg and radius 0.24 m is mounted on frictionless bearings so it can rotate freely around a vertical axis through its center (see the following figure). A cord is wrapped around the rim of the disk and pulled with a force of 10 N. 10 N (a) How much work (in 3) has the force done at the instant the disk has completed four revolutions, starting from rest? (b) Determine the torque due to the force. (Enter the magnitude in N-m) N m Calculate the work (in 3) done by this torque at the instant the disk has completed rour violations (c) What is the angular velocity (in rad/s) at that instant? (Enter the magnitude.)

A proffesors office door is 1.3m wide, 2.3m high, 4.0cm thick, has a mass of 25kg, and pivots on friction less hinges. What is the smallest magnitude force that you need to apply to the door to give it an angular acceleration of 2 rad/s.

A wind turbine has 3 blades: each of which measure 38 m long and has a mass of 5216 kg. The three blades are mounted at their ends 120 degrees apart on a hub (assume the hub is so small it can be ignored). a) If the angular velocity is 1.9 rad/s, what is the kinetic energy when it rotates at constant angular velocity? b) How much work did the wind provide when starting the turbine from ω=0 rad/s if the mechanism generates 10% of the kinetic energy as heat in addition to the kinetic energy of the turbines? c) If the mechanism of the wind turbine can convert a max of 75% of the kinetic energy of the turbine to useful work in a minute, what is the power output of the turbine?