Concept explainers
Find the average velocity of the water leaving the tank.
Answer to Problem 39P
The average velocity of the leaving water in
Explanation of Solution
Given data:
Refer to the given Figure Problem 9.38 in the textbook, which shows the tank is filled by water using pipes 1 and 2.
The water level increases in the rate of 0.1 in/s.
The diameter of the tank is
Formula used:
Write the expression for the volume flow rate.
Here,
Calculation:
Consider that the constant water density.
From the given figure, write the volume flow rate expression for inlet and outlet volumetric flow rate expressions.
Re-arrange the equation,
Substitute
The values of
And
Convert the unit of value in equation (1) from
Convert the unit of value in equation (1) from
Conclusion:
Hence, the average velocity of the leaving water in
Want to see more full solutions like this?
Chapter 9 Solutions
ENGINEERING FUNDAMENTALS W/ACCESS
- Solve Problem 8.37 for a situation in which the object is given an initial vertical upward velocity of 1.2 m/s. Again, prepare a table similar to Table 8.3 showing the speed and acceleration of the object and the distance travelled by the object as a function of time.arrow_forwardA plugged dishwasher sink with the dimensions of 60 cm × 50 cm × 30 cm is being filled with water from a faucet with an inner diameter of 2.5 cm. If it takes 40 seconds to fill the sink to its rim, estimate the volumetric flow of water coming out of the faucet. What is the average velocity of water coming out of the faucet?arrow_forwardWater with a velocity of 4.13 m/s flows through a 119 mm diameter pipe. Solve for the volume flow rate in m3/s. Express your answer in 3 decimal places.arrow_forward
- Find how far an airplane will move in landing, if in t seconds after touching the ground its speed in feet per second is given by the equation. v= 180 – 18t. (hint: take v=0, C=0 ).arrow_forwardCalculate the change in the momentum of a car whose speed changes from 100 km/h to 20 km/h. The car has a mass of 1000 kg and is moving along a straight line.arrow_forwardImagine that the water level in Problem 8.34 rises at a rate of 0.1 cm/s. Knowing the diameter of the tank is 15 cm, what is the average velocity of the water leaving the tank?arrow_forward
- Determine the angular velocity of a tire in radian per second if it rotates 16 times for two seconds. The diameter of the tire is 8 inches.arrow_forward) Consider a double - fluid manometer attached to an air pipe shown in Figure. If the specific gravity of one fluid is 13.55, determine the specific gravity of the other fluid for the indicated absolute pressure of air. Take the atmospheric pressure to be 100 kPa. (arrow_forwardA particle travels counterclockwise around a circle of 36m radius so that the distance from a fixed point 0 on the right end of a horizontal diameter is given by s=20t + 2t^2 where s is in meters and t is in seconds. Compute the rectangular components of acceleration at the end of 2 seconds.arrow_forward
- Determine the change in mass moment of inertia of an object that could be modeled as a point mass m when its distance from a center of rotation is doubled.arrow_forwardA student with a mass of 80.0 kg runs up three flights of stairs in 12.0 sec. The student haa gone a vertical distance of 8.0m. Determine the amount of work done by the student to elevate his body to this height. Assume that his speed is constant.arrow_forwardThe equation governing a body travelling in a water channel is given by the following equation and Plot the velocity time graph for the object and determine the final velocity and the time taken toreach this velocityarrow_forward
- Engineering Fundamentals: An Introduction to Engi...Civil EngineeringISBN:9781305084766Author:Saeed MoaveniPublisher:Cengage Learning