* Consider again the turntable described in the last problem. Determine the magnitudes of the rotational acceleration in each of the following situations. Indicate the assumptions you made for each case. (a) When on and rotating at 33 rpm, it is turned off and slows and stops in 60 s. (b) When off and you push the play button, the tumtable attains a speed of 33 rpm in 15 s. (c) You switch the turntable from 33 rpm to 45 rpm, and it takes about 2.0 s for the speed to change. (d) In the situation in part (c), what is the magnitude of the average tangential acceleration of a point on the turntable that is 15 cm from the axis to rotation?
Want to see the full answer?
Check out a sample textbook solutionChapter 9 Solutions
College Physics
Additional Science Textbook Solutions
Sears And Zemansky's University Physics With Modern Physics
Conceptual Physics (12th Edition)
Life in the Universe (4th Edition)
Conceptual Physical Science (6th Edition)
- As shown in Figure OQ10.7, a cord is wrapped onto a cylindrical reel mounted on a fixed, friction less, horizontal axle. When does the reel have a greater magnitude of angular acceleration? (a) When the cord is pulled down with a constant force of 50 N. (b) When an object of weight 50 X is hung from the cord and released, (c) The angular accelerations in parts (a) and (b) are equal, (d) It is impossible to determine.arrow_forwardA uniform cylindrical grindstion has a mass of 10 kg and a radius of 12 cm. (a) What is the rotational kinetic energy of the grindstone when it is rotating at 1.5103rev/min ? (b) After the grindstone’s motor is turned off, a knife blade is pressed against the outer edge coefficient of kinetic friction between the grindstone and the blade is 0.80. Use the work energy theorem to determine how many turns the grindstone makes before it stops.arrow_forwardA competitive diver leaves the diving board and falls toward the water with her body straight and rotating slowly. She pulls her arms and legs into a tight tuck position. What happens to her rotational kinetic energy? (a) It increases. (b) It decreases. (c) It stays the same. (d) It is impossible to determine.arrow_forward
- While punting a football, a kicker rotates his leg about the hip joint. The moment of inertia of the leg is 3.75kg-m2 and its rotational kinetic energy is 175 J. (a) What is the angular velocity of the leg? (b) What is the velocity of tip of the punter's shoe if it is 1.05 m from the hip joint? (c) Explain how the football can be given a velocity greater than the tip of the shoe (necessary for a decent kick distance).arrow_forwardReview. A piece of putty is initially located at point A on the rim of a grinding wheel rotating at constant angular speed about a horizontal axis. The putty is dislodged from point A when the diameter through A is horizontal. It then rises vertically and returns to A at the instant the wheel completes one revolution. From this information, we wish to find the speed v of the putty when it leaves the wheel and the force holding it to the wheel. (a) What analysis model is appropriate for the motion of the putty as it rises and falls? (b) Use this model to find a symbolic expression for the time interval between when the putty leaves point A and when it arrives back at A, in terms of v and g. (c) What is the appropriate analysis model to describe point A on the wheel? (d) Find the period of the motion of point A in terms of the tangential speed v and the radius R of the wheel. (e) Set the time interval from part (b) equal to the period from part (d) and solve for the speed v of the putty as it leaves the wheel. (f) If the mass of the putty is m, what is the magnitude of the force that held it to the wheel before it was released?arrow_forwardIn softball, the pitcher throws with the arm fully extended (straight at the elbow). In a fast pitch the ball leaves the hand with a speed of 139 km/h. (a) Find the rotational kinetic energy of the pitcher's arm given its moment of inertia is 0.720kg-m2 and the ball leaves the hand at a distance of 0.600 m from the pivot at the shoulder. (b) What force did the muscles exert to cause the arm to rotate if their effective perpendicular lever arm is 4.00 cm and the ball is 0.156 kg?arrow_forward
- Additional Problems A typical propeller of a turbine used to generate electricity from the wind consists of three blades as in Figure P8.75. Each blade has a length of L = 35 in and a mass of m = 420 kg. The propeller rotates at the rate of 25 rev/min. (a) Convert the angular speed of the propeller to units of rad/s. Find (b) the moment of inertia of the propeller about the axis of rotation and (c) the total kinetic, energy of the propeller. Figure P8.75arrow_forwardTwo children are playing with a roll of paper towels. One child holds the roll between the index fingers of her hands so that it is free to rotate, and the second child pulls at constant speed on the free end of the paper towels. As the child pulls the paper towels, the radius of the roll of remaining towels decreases. (a) How does the torque on the roll change with time? (b) How does the angular speed of the roll change in time? (c) If the child suddenly jerks the end paper towel with a large force, is the towel more likely to break from the others when it is being pulled from a nearly full roll or from a nearly empty roll?arrow_forwardThe moment of inertia of a long rod spun around an axis through one end perpendicular to its length is ML2/3 Why is this moment of inertia greater than it would be if you spun a point mass M at the location of the center of mass of the rod (at L/2)? (That would be ML2/4.)arrow_forward
- A car is designed to get its energy from a rotating solid-disk flywheel with a radius of 2.00 m and a mass of 5.00 102 kg. Before a trip, the flywheel is attached to an electric motor, which brings the flywheels rotational speed up to 5.00 103 rev/min. (a) Find the kinetic energy stored in the flywheel, (b) If the fly-wheel is to supply energy to the car as a 10.0-hp motor would, find the length of time the car could run before the flywheel would have to be brought back up to speed.arrow_forwardWhile punting a football, a kicker rotates his leg about the hip joint. The moment of inertia of the leg is 3.75kgm2 and its rotational kinetic energy is 175 J. (a) What is the angular velocity of the leg? (b) What is the velocity of tip of the punter’s shoe if it is 1.05 m from the hip joint?arrow_forwardThis problem considers energy and work aspects of Example 10.7—use data from that example as needed. (a) Calculate the rotational kinetic energy in the merry-go-round plus child when they have an angular velocity of 20.0 rpm. (b) Using energy considerations, find the number of revolutions the father will have to push to achieve this angular velocity starting from rest. (c) Again, using energy considerations, calculate the force the father must exert to stop the merry-go- round in revolutionsarrow_forward
- Physics for Scientists and Engineers: Foundations...PhysicsISBN:9781133939146Author:Katz, Debora M.Publisher:Cengage LearningUniversity Physics Volume 1PhysicsISBN:9781938168277Author:William Moebs, Samuel J. Ling, Jeff SannyPublisher:OpenStax - Rice UniversityCollege PhysicsPhysicsISBN:9781938168000Author:Paul Peter Urone, Roger HinrichsPublisher:OpenStax College
- Physics for Scientists and Engineers, Technology ...PhysicsISBN:9781305116399Author:Raymond A. Serway, John W. JewettPublisher:Cengage LearningPrinciples of Physics: A Calculus-Based TextPhysicsISBN:9781133104261Author:Raymond A. Serway, John W. JewettPublisher:Cengage LearningCollege PhysicsPhysicsISBN:9781305952300Author:Raymond A. Serway, Chris VuillePublisher:Cengage Learning