Interpretation:
Express the given concentration in terms of
Concept Introduction:
In order to express the concentration, many units have been used. One among them is molarity, defined as number of moles of solute divided by number of liters of solution.
Given by,
Parts per million
Expressed as,
Want to see the full answer?
Check out a sample textbook solutionChapter 9 Solutions
Fundamentals of General, Organic, and Biological Chemistry (8th Edition)
- The normal range of the sodium electrolyte in the body is 134 to 145 mEq/L. The term mEq is dependent on the charge of the ion. Since sodium is a +1 ion, 134 mEq/L is the same as 134 mmol/L. An ion that has a greater positive or negative charge; however, will have 1 mEq for each positive or negative charge of the ion for every 1 mmol. For example, for Ca+2, 2mEq/1mmol. If the standard range of Magnesium in the body is 0.70 to 0.95 mmol/L, convert this value into mEq/L for the Mg2+ ion. (Use dimensional analysis to figure this out)arrow_forwardGiven the following data plot of the volume of NaOH vs pH a. what does the values in 1 and 2 indicates: _____ b. Determine the molar mass of the unknown acid: _____ c. choose the identity of the acid from the choices below: _____ acetic acid, MM = 60.05 g/mole formic acid, MM = 40.03 g/mole oxalic acid = 90.03 g/molearrow_forwardHow is Ka defined? Write the equation for Ka for the generalized acid HA.arrow_forward
- In an experiment, what happens to the calculated molar mass after waiting an hour between thawing the frozen cyclohexane and adding the unknown compound, during which time some of the cyclohexane evaporated. Will the molar mass be too large, too small, or unaffected? Explain.|arrow_forwardCreatinine, C4H7N3O, is a by-product of muscle metabolism, and creatinine levels in the body are known to be a fairly reliable indicator of kidney function. The normal level of creatinine in the blood for adults is approximately 1.0 mg per deciliter (dL) of blood. If the density of blood is 1.025 g/mL, calculate the molarity of a normal creatinine level in a 10.0 mL blood sample.arrow_forwardThree buffers are made by combining a 1M solution of acetic acid and a 1M solution of sodium acetate in the ratios shown in the table below. Which of these statements is true regarding the prepared buffers? (Ka= 1.7x10-5) pH of buffer 1 < pH of buffer 2 < pH of buffer 3 pH of buffer 1 = pH of buffer 2 = pH of buffer 3 pH of buffer 1 > pH of buffer 2 > pH of buffer 3 pH of buffer 1 = pH of buffer 2 > pH of buffer 3 pH of buffer 1 > pH of buffer 2 = pH of buffer 3arrow_forward
- Given the equation of the line, y=150x-8.1221 (cells per mL is in 10^8), what is the CFU per mL of the original suspension if the thousand-fold dilution of that suspension has an absorbance of 0.3 at 600nm? * A. 3.7 x 10^12 B. 3.7 x 10^9 C. 3.7 x 10^1 D. None of these is correctarrow_forwardWhat is the molarity of a NaOH solution if 48.0 mLneutralizes 35.0 mL of 0.144 M H2SO4?arrow_forwardBased on the Henderson-Hasselbalch equation (shown below), calculate the pH when half of a solution of acetic acid is dissociated to acetate (the pKa of acetic acid is 4.76). A. 1.00 B. 3.76 C. 4.76 D. 5.76arrow_forward
- Stearic acid is insoluble in water, and sodium stearate (a soap) is soluble. What causes the difference in solubility? Explain.arrow_forwardWhat is the molarity of a 30% solution of NaCIarrow_forwardIf the osmotic pressure of a 7.96×10-2-M aqueous solution of Fe2(SO4)3 was found to be 8.71 atm at 20°C, what would be the "observed" van't Hoff factor? Use the above van't Hoff factor to predict the freezing point of this solution.Note that the corresponding molality would be 8.25×10-2 m, given that the density of the solution is 0.997 g/cm3. °C Use the above van't Hoff factor to predict by how many degrees the boiling point of this solution will be elevated above that for pure water.arrow_forward