4 of 15 Abs 2.0 1.5 1.0 0.5 0.25 0.2 0.4 0.6 Concentration (M) With reference to the UV-Vis calibration curve reported above, calculate the concentration (Molar) of a sample whose Absorbance is 1.0. Report your answer with two significant figures.

4 of 15 Abs 2.0 1.5 1.0 0.5 0.25 0.2 0.4 0.6 Concentration (M) With reference to the UV-Vis calibration curve reported above, calculate the concentration (Molar) of a sample whose Absorbance is 1.0. Report your answer with two significant figures.

Principles of Modern Chemistry

8th Edition

ISBN:9781305079113

Author:David W. Oxtoby, H. Pat Gillis, Laurie J. Butler

Publisher:David W. Oxtoby, H. Pat Gillis, Laurie J. Butler

Chapter20: Molecular Spectroscopy And Photochemistry

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: Assuming that the sample optical path length is 1 cm, find the molar absorptivity at wavelength 1…

A: We know that Absorbance (A)=€Cl ,where €=molar absorptivity C=concentration l=length of the cell…

Q: Suppose that a solution has an absorbance of 0.226 at a wavelength of 450 nm. If the concentration…

A: Given the absorbance of the solution, A = 0.226 Concentration of the solution, C = 24 μM path…

Q: A solution of a dye with an absorptivity coefficient (ε) of 3.75 x 102 M-1cm-1 had an absorbance of…

A: Given : ε= 3.75 x 102 M-1cm-1 A = 0.039 l = 1.00 cm

Q: 7. Describe the effects that are responsible for the three different absorbance profiles in Figure…

A: 7) Magnesium (Mg) exhibits a maximum in absorbance at the middle of the flame (around 2 cm). The…

Q: Calculate the concentration of Cu in the sample by calibration curve using the following data…

Q: Atomic absorption analysis of Zn gave a calibration best fit line of A=0.670(ppm Zn) The detection…

A: Given: Standard deviation of the absorbances for 11 samples of the solution =1.560 x 10-3 Slope of…

Q: A standard 1 mL cuvette is three-quarters filled with a 1 in 6 dilution of 24 μmol.L-1…

A: In the presence of a live yeast suspension, the absorbance is measured to be 0.6, which is 0.35…

Q: The data in the table below were obtained during a determination of lead in lake water by atomic…

A: To find the equation of line, first input data in excel sheet then make a scatter plot for that data…

Q: 1. To determine the concentrations (mol/L) of Co(NO3)2 (A) and Cr(NO3)3 (B) in an unknown sample,…

A: Solution - According to the question - Given data - Absorbance of 0.15 M Co(NO3)2 at 510nm = =…

Q: The equation of the line for an Abs vs. [FESCN^2+] plot was determined to be y=4462.2x - 0.00329.…

A: Given that, Abs vs [FeSCN2+] plot y=4462.2x - 0.00329 And absorbance for unknown concentration was…

Q: Monomer-dimer formation can affect the absorbance measurements using Beer’s law, it is an example…

A: The Beer's Law for absorbance is A = ∈c l where A is the absorbance ∈ is molar absorption…

Q: A student wanted to determine the level of lead in amoxicillin powder, so he transferred 148 mg of…

A: Given the absorbance of the diluted solution, Y = 0.48 Calibration equation is: Y = 12.25X - 0.05…

Q: Net Absorbance (595 nm) Which protein standard curve would you use to read off the protein…

A: Option 1 is the correct choice. Determination of concentration of an unknown sample using standard…

Q: What is the molar concentration for a solution with a measured absorbance of 0.212 based on this…

A: According to Beer-Lambert’s law, the absorbance of solution can be expressed as:

Q: A solution has an absorbance reading of 0.238 AU. Using the calibration curve below, determine the…

Q: fill in the column thats empty by finding the standard deviation for each average absorbance, with…

A: Concentration of Dye Average Absorbance of replicate Standard division 1mg/L 0.269 0.731…

Q: To quantify the Cadmium content in a water sample, 5 aliquots of 10 mL were taken, adding to each…

A: The amount of concentration in the sample can be calculated using the following formula. In this…

Q: What is the concentration (in M) of a FeSCN2+ solution that has an absorbance of 0.217? trendline…

A: y = (4.2 x 103)x + 0.023 Where, Y = absorbance and x = concentration

Q: The standard curve was made by spectrophotographic analysis of equilibrated iron(III) thiocyanate…

A: Given the linear regression equation for the analysis of the standard solution is Y =…

Q: 1-proteins-lab-manual?module_item_id=44333 A= abc Where "A" is absorbance, "a" is molar…

A: First question had been answered. Absorbance of a solution can be calculated using Beer Lambert law.

Q: For part 2 of the procedure 5 different volumes were prepared of 0.0040 M KMnO4. Table 2- Data for…

Q: In the Spectrophotometric determination of Iron experiment, the calibration curve is plotted as…

Q: 10. The following buffered solutions of weak acid (FHA spectrophotometrically in 2.00 cm cells 1.00…

A: The indicator (absorbing species equilibrium) can be written as: HA+H2O↔H3O++A-…

Q: Briefly explain why it is NOT accurate to calculate the concentration of a sample whose absorbance…

A: The concentration of the sample is determined as shown below.…

Q: A solution prepared by dissolving 25.8 mg of benzene (C6H6, FM 78.11) in hexane and diluting to…

A: The molar absorptivity of benzene is to be determined from the given data. Given: Mass of benzene =…

Q: Concentration of Manganese in Red Wine 0.6 y = 0.1373x + 0.122 R2 = 0.9986 0.5 0.4 0.3 0.2 0.1 0.5 1…

A: The linear regression equation for the Absorbance versus manganese concentration (ppm) graph is Y =…

Q: Exactly 5.00 mL aliquots of a solution containing analyte X were transferred into 50.00-mL…

Q: A student prepared a calibration curve by measuring of the absorbance of five standard solutions of…

A: path length is 5 cm slope of the curve is 300 L/mol graph is drawn " Absorbance vs Concentration…

Q: Determining the concentration of unknown solution using uv-vis spectroscopy. The absorbance vs…

Q: Below is the procedure described for determination of paracetamol according to BP: "Weigh and powder…

A: Here the question describes the procedure to analyze the paracetamol content in a tablet.…

Q: ased on the data on the table, show the calibration curve and determine the concentration of the…

A: Given the absorbance of the unknown water sample = 0.121 The calibration curve is drawn by taking…

Q: Assuming that the sample optical path length is 1 cm, find the molar absorptivity at wavelength 1…

A: In this question a sample consists of hmr and Mr which show respective absorbance values. Together a…

Q: How do I calculate the standard deviation of background (baseline) on the UV-Vis absorbance…

Q: A student prepared four standard solutions of (NH4)2Fe(SO4)2 and measured their absorbance at 505…

A: According to Beer's law absorbance is directly proportional to the concentration Absorbance Vs…

Q: Assuming that the path length of your cuvette is exactly 1.00 cm, calculate the molar absorptivity…

A: We are given ,the spectroscopic data of absorption of KMnO4 at wavelength of520 nm Tube 8.0×10-2…

Q: Please complete Table 2 and show the calculations for protein concentration and the concentration of…

A: A question based on tools in analytical chemistry that is to be accomplished.

Q: A student made a calibration curve for iron (III) using the above procedure with a slope of 70…

A: For finding concnetration two or more steps should follow 1. Substarct intercept from the absorbance…

Q: alculate the molar extinction coefficient of a biomolecule with a MW of 300 if a 5.0 mM solution in…

Q: You obtained the following raw data when setting up a Bradford standard curve: BSA (mg/ml)…

A: Bradford protein assay is a method which is used for determining the concentration of unknown…

Q: What is the concentration (in Molar) of a 1.00 cm (path length) sample that has an absorbance of…

A: If a light falls with intensity lo on a cuvette which contains a sample with concentration 'c'…

Q: A chemist received a report from an analysis involving the iron-phenanthroline method, containing…

A: A question based on tools in analytical chemistry that is to be accomplished.

Q: Following AAS analysis, a graph of absorbance versus ppm nickel standard gave a best-fit line y =…

A: AAS is a spectroscopic technique by which a quantitative estimation of atoms can be determined. In a…

Q: What are the equilibrium concentrations of [Fe3+] and [SCN-]?

A: The reaction of iron (III) with thiocyanate to yield the colored product, iron (III) thiocyanate,…

Q: undiluted 0.715 1:4 dilution ratio 0.447 1:9 dilution ratio 0.321 a. Calculate the slope,…

A: First plot the graph of absorbance vs concentration . Then find the equation for graph using Excel.

Q: What is the molar absorptivity of a 2.50 x 10-4 M solution if its absorbance at 550 nm is 0.500? The…

Q: This expresses the direct proportionality between absorbance and concentration. (A) Beer-Lambert's…

Q: An ethanol solution of 3.5 mg/100 ml of compound Y (150.0 g/mol) in a 1.00 cm quartz cell has an…

A: Interpretation - To determine the molar extinction coefficient when an ethanol solution of…

Q: A 0,0138 gram sample of brass was dissolved in a approximately 1 ml of nitric acid and then diluted…

A: A numerical problem based on qualitative analysis, which is to be accomplished.

Q: 3) The gold content of a concentrated sea water sample was determined using atomic-absorption…

A: Solution - According to the question - Given - Conc. of Analyte added : [S]f = [S]i * ( Vs /V) We…

Q: You obtained the following raw data when setting up a Bradford standard curve: BSA (mg/ml)…

A: A question based on tools in analytical chemistry that is to be accomplished.

Question

4 of 15
Abs
2.0
1.5
1.0
0.5
0.25
0.
0.2
0.4
0.6
Concentration (M)
With reference to the UV-Vis calibration curve reported above, calculate the concentration (Molar) of a sample whose Absorbance is 1.0. Report your answer with two significant figures.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, chemistry and related others by exploring similar questions and additional content below.

Similar questions

Use the data in Figure 4.8 to estimate the ratio of radiation intensity at 10,000 Å (infrared) to that at 5000 Å (visible) from a blackbody at 5000 K. How will this ratio change with increasing temperature? Explain how this change occurs.
Potassium dichromate and potassium permanganate have overlapping absorptionspectra in 1M H2SO4 . K2Cr2O7 has an absorption maxima at 440 nm, and KMnO 4 has a band at 545nm (the maximum is actually at 525 nm, but the longer wavelength is generally used whereinterference from K2C2O7 is less). A mixture is analyzed by measuring the absorbance at these twowavelengths with the following results: A 440 =0.405, A 545 =0.712 in a 1-cm cell. The absorbances ofpure solutions of K2Cr2O7 (1x10 -3 M) and KMnO 4 (2.00x10 -4 M) in 1 M H 2 SO 4 , using the same cell gavethe following results: A Cr,440 = 0.374, A Cr,545 = 0.009, A Mn,440 =0.019, A Mn,545 = 0.475. Calculate theconcentrations of dichromate and permanganate in the sample solution.
Given the following parameters, what is the expected absorbance?c = 250 mmol/Ll = 0.5 cmε = 10 M-1 cm-1 a. 0.5 b. 1.0 c. 1.5 d. 1.25
How can you use Uv-visible spectroscopy in qualitative and quantitive analysis of drugs? Please answer shorty at your own words. Answer should be to the point.
Among the following analytical methods, select all methods that candetermine the concentration and describe how each method candetermine the concentration. - Raman spectrometry- IR spectrometry- UV/vis spectrometry- Mass spectrometry- Atomic emission spectroscopy- Atomic absorption spectroscopy
An aqueous solution of a triphosphate derivative of molar mass 502 g mol-1, was prepared by dissolving 17.2 mg in enough water to make 500 cm3 of solution and a sample was transferred to a cell of length 1.00 em. The absorbance was measured as 1.011. Calculate (a) the molar absorption coefficient;(b) the transmittance. expressed as a percentage.for a solution of twice the concentration.
In general, we want to have absorptions less than or equal to 1. What percentage of the incident light is transmitted when absorption is 1? Report your answer to the nearest whole number. Do not include the percent sign in your answer.