The Michaelis-Menten constantcan be determined using the Lineweaver-Burk plot and is equal to twice theVmax.can be determined using the Lineweaver-Burk plot and is equal to the substrateconcentration at Vmax/2.can be determined using the Lineweaver-Burk plot.O is equal to the substrate concentration at Vmax/2.O is equal to twice the Vmax

Mechaelis-Menten Constant: - Km is used in the enzyme kinetics, it plays very important role in the…

aelis-Menten constant an be determined using the Lineweaver-Burk plot and is equal to twice the "max. an be determined using the Lineweaver-Burk plot and is equal to the substrate oncentration at Vmax/2. an be determined using the Lineweaver-Burk plot. equal to the substrate concentration at Vmax/2. sequal to twice the Vmax

aelis-Menten constant an be determined using the Lineweaver-Burk plot and is equal to twice the "max. an be determined using the Lineweaver-Burk plot and is equal to the substrate oncentration at Vmax/2. an be determined using the Lineweaver-Burk plot. equal to the substrate concentration at Vmax/2. sequal to twice the Vmax

Curren'S Math For Meds: Dosages & Sol

11th Edition

ISBN:9781305143531

Author:CURREN

Publisher:CURREN

Chapter9: Parenteral Medication Labels And Dosage Calculation

Section: Chapter Questions

Problem 4.4P

See similar textbooks

Similar questions

Determine the fraction of Vmax that would be obtained when the substrate concentration, [S], is 0.5Km. Vmax fraction: .769
Using a P-1000 micropipette, you transfer 800 microliter of ddH2O to a beaker and measure its weight. It turns out to be only 780 milligram; what is the percent error of this micropipette?
fill in the volumes required to make the various dilutions of Coomassie Blue and their respective concentrations. show sample calculations.
The growth of a bacterium follows the Monod model with μmax=0.3 h-1, Ks=2.5 g/l and Yx/s=0.20gx/gs. Calculate the number of continuous mixing tank type bioreactors in series, with 10 L of useful capacity each, necessary for the limiting substrate conversion to be greater than 98%, considering that the system is fed with a flow rate of 2.5 L/ h and the substrate concentration in the feed is 30 g/L.
The graph is of initial velocity versus substrate concentration. Estimate Vmax from the direct graph of v versus [S] using the plot. Estimate KM from the direct graph of v versus [S] using the plot, also.
Derive a general expression for the minimum filter area requirement per a sterility assurance limit (SAL) in terms of(a) concentration of microorganisms in the feed; (b) volume per unit parenteral dose; (c) sterility assurance limit; and (d) filter capacity.
3 mL of a 45 mM stock solution of a substrate is added to 8 mL of water. Calculate the following values. The substrate molecular weight is 125 g/mol. Calculate the following values: Substrate Volume in mL Dilution Factor Substrate number of moles Substrate concentration for the diluted solution in mM Substrate concentration for the diluted solution in mole/L Substrate concentration for the diluted solution in mg/mL
Given the parameters below:1. u(max) = 1.0/ h Ks = 10 uM2. u(max) = 0.7/h Ks = 2 uM) a. sketch the comparative Substrate Concentration vs.u(max) graphs for 1. b. sketch the comparative Substrate Concentration vs.u(max) graphs for 2. (answer a and b)
For the following problem indicate the values for each part of the equation and solve for the unknownvalue:Peter adds 200 μL of bacteria to a tube containing 2 mLs of nutrient broth and then adds 300 μL of acertain disinfectant. The final concentration of the disinfectant in this tube after adding it is 5%.C1=C2=V1=V2=
During cell couting, when the data are plotted in an ordinary graph or on a cross-section paper, why is the log value of the cell concentration used?
What are the characteristics of an effective indicator organism? Write down some examples. Suppose you filtered a sample and found the Fecal Coliform count to be 20 CFU/100ml but the Total Coliform count was 0 CFU/100ml, do you think this result is correct? If so, why/why not?
Each plot has its own limitations. Match the plot with the correct statement on limitations. 1.Hanes-Woolf 2.Michaelis Menten 3.Lineweaver-Burk limitations: A. This plot appears to allow for more accurate calculation of these parameters, but is prone to error, as the y-axis takes the reciprocal of the rate of reaction –this increases any small errors in measurement at low substrate concentration, where they are most likely to occur. B.The advantage of this plot is that it does not not overemphasizing the data obtained at low [S]. The disadvantage is that any inaccurate measures of substrate concentration will be exaggerated as [S] is used on both axes. C.It is difficult to obtain a meaningful value of Km from this plot because of the high substrate concentrations needed to reach Vmax. Vmax has to be estimated by extrapolation- which is partly subjective and introduces error. D.The advantage of this plot is that it overcomes uneven spacing of points, and undue weight of a…