8. The flash point of an engine oil is 363°F. What is the absolute flash-point temperature in K and R?

Answered: Image /qna-images/answer/e4f011d3-be82-481c-ac81-d2df7edc8269.jpg

Answered: e absolute flash-point temperature in K…

Science

Chemistry

e absolute flash-point temperature in K and R?

Chemical Principles in the Laboratory

11th Edition

ISBN:9781305264434

Author:Emil Slowinski, Wayne C. Wolsey, Robert Rossi

Publisher:Emil Slowinski, Wayne C. Wolsey, Robert Rossi

Chapter2: Resolution Of Matter Into Pure Substances, I.paper Chromatography

Section: Chapter Questions

Problem 2ASA

See similar textbooks

Related questions

Q: For samples with broad boiling points components in GC separations, it is important to establish…

A: The solution is given below -

Q: What is difference between end and equivalence point? What Is the relationship of conductance with…

A: Difference between equivalence point and endpoint = The equivalence point is the point at which the…

Q: .A. Name 2 parameters must be controlled in a sampled current polarographic experiment to ensure…

A: The solutions in which the amount of the solute present in a solvent volume is pressed by the term…

Q: Why is gradient elution used

A: In this elution process, mobile phase strength is changed during the separation process.

Q: The following are the basic components of XRD except-* Source Primary optics Sample Holder…

A: XRD is used to determine the crystal structure of a sample, It is the important characterization…

Q: The following data were obtained for four compounds separated on a 20-m capillary column. t, (min) w…

Q: 1. Discuss briefly the specifications and test parameters for system suitability for HPLC analysis.

A: Important Parameters used in HPLC analysis are as follows: 1). Retention time (tR): It is the time…

Q: 1.13 Which of the following is a parameter that cannọt be obtained by a typical DLS experiment? O…

A: Please find your solution below : Dynamic light scattering (DLS) also known as Photon correlation…

Q: Complete this table for H,O: T, "F P, psia u, Btu/lbm Phase description 300 782 40 Saturated liquid…

A: Solution - According to the question - Given - The given problem is solved using steam tables by…

Q: Give short information about the column types used in gas chromatograpy.

A: There are two types of column used in gas chromatography they are 1 ) packed column 2 ) Capillary…

Q: An open tubular column with an inner diameter of 0.25 mm had a volumetric flow rate of 0.95 min-1 .…

Q: Q1- Brine mixing is a process involved in: a)- Multistage flash evaporation process b)-…

A: Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: ewavelength of a

Q: If the concentration in a bulk solution adjacent to a fibrous medium is at a concentration cA…

A: The relation to calculate the partition coefficient is shown below. K=CSCM Here, CM is the…

Q: Compare the diffusion coefficients of carbon in BCC and FCC iron at the allotropic transformation…

A: The relation to calculate the diffusion coefficient of carbon in BCC or in FCC using Arrhenius type…

Q: What is the actual or real-life application of electrogravimetric analysis? Include the specific…

A: Answer - Electrogravimetric analysis - Electrogravimetry is a method used to separate and quantify…

Q: The next two questions pertain to the situation described below. Calcium atoms (mass = 6.66x10-26…

A: Given, mass of calcium atom , m =6.66×10-26 kgvelocity = 4msseparation between the slits , d=50…

Q: 3-23 Complete this table for H,O: T, °C P, kPa v, m³/kg Phase description 140 0.05 550 Saturated…

A: 3-23 Ans; a) T = 140 °C, v = 0.05 m3/k From Table A-4, Saturated water, Temperature tabl Psat @T =…

Q: Find the weighted adjacency matrix of the following direted graph and represent that as a CSR-marix.

A: Weighted Adjacency Matrix: It is 2-D array which represents a data structure which can say that…

Q: Is standardization against primary standard required for controlled potential coulometry ?

A: Controlled potential coulometry, as the name suggests, is a coulometry method that measures the…

Q: If the radius of column 0.25 cm, the linear.3 velocity of mobile phase 10.0 cm/min, and the fraction…

Q: Why does the glass transition for a polymer yield no exothermic or endothermic peak?

A: The glass transition for a polymer yield no exothermic or endothermic peak.

Q: a) The relationship between permeate weight and time with fabrics. b) The characteristic of fabrics…

Q: What was the most important parameter change that lead to the development of modern HPLC? A.…

A: answer- What was the most important parameter change that lead to the development of modern HPLC -…

Q: When the distribution coefficient increases, the extraction efficiency increases or decreases

A: Distribution coefficient is the ration of concentration of solute in organic phase over…

Q: Point out TWO (2) strategies to increase selectivity in solid phase extractions.

A: A question based on analytical separations that is to be accomplished.

Q: Separation of the single phase solid from single phase liquid line region is done by

A: A phase diagram is a visual representation to depict the substance's physical state under distinct…

Q: What are the benefits of decreasing the column internal diameter? O Increased sample capacity O…

A: Answer - The correct option is (c) Increased resolution Explanation - As we lower the internal…

Q: 2.A leyes of 20g of Suciose spread uniformly over 5cm2 Surface of and COvered 5. water to a depth of…

A: Given data Molar mass of Sucrose = 342.3 g per mole Mass of sucrose spread at Surface = 20 g No of…

Q: In lab two dikferent mobile phase compositions were used for column Chromatoghaphy. DiSCUSShow the…

A: The solution of the answer is given below:

Q: Phosphorous is predeposited at 4.5 x 10^20 atoms/cm^3 on a silicon wafer with an initial…

A: Answer is explained below.

Q: ship between Compour e on a TLC plate if v

A: The figure as,

Q: 16 14 12 10 4 2 10 20 30 Minutes 40 50 60 70

A: From retention time and width of two peaks,Resolution for the given chromatogram can be determined.…

Q: GCMS is running at high temperatures to achieve compounds vaporization and separation. Describe why…

A: Interpretation- To describe why the transfer line temperature and filament are usually set similar…

Q: Define Gas Chromatography and HPLC and state their differences in principle and uses. (maximum of…

A: Introduction: Chromatography is a technique used to separate the mixture if solution. There are two…

Q: A dry-wet-dry oxidation cycle of 20 min – 80 min – 20 min is performed at 1100 °C. (a) What is the…

A: <100>Silicon wafer:

Q: Choose the appropriate techniques for degassing the mobile phase of HPLC. I. Ultrasonic II. Boiling…

Q: Sketch a graph of the van Deemter equation (plate height versus flow rate). What would the curve…

A: The van Deemter equation is a relationship between the height of the plate during the flow of mobile…

Q: Estimate the mixing ratio of NO in the following condition: NOx 30 ppb, 03 = 100 ppb, [M] = 2.5x1019…

Q: Compare gradient and isocratic mode in HPLC.

A: Gradient and isocratic mode in HPLC are the two different modes of operating condition in HPLC.

Q: what is the difference between linear voltammetry, cyclic voltammetry and differential anodic…

A: Voltammetry is an electroanalytical technique where the information about an analyte is obtained by…

Q: Air displacement pipettes is ALWAYS MORE accurate than Mohr and serological pipettes because…

A: To determine whether the given statement is true or false and if false, determine the word that…

Q: C. A cube of dimensions 10 cm x 10 cm x 10 cm has mass of 1.90 Kg a water content w = 15%. The…

A: This question has multiple parts . As per the guidelines we are allowed to provide solution of…

Q: What could be the effect of trapped bubbles in the viscometer during the run on (a) the measured…

A: Type of problem depending upon size of bubbles: A small amount of very small bubbles has no effect.…

Q: What are the disadvantages of using a non- ideal linear velocity on the chromatographic separation…

Q: Indicate the order of elution of the following compounds from a normal-phase packed HPLC column a.…

A: Several compounds mixed in any particular solution mainly separated by utilizing the technique…

Q: -forming density gradients in respect of the following: I. Type of gradient material used. II. The…

A: Rate-zonal separation and isopycnic separation will be the two primary forms of density gradient…

Q: According to given TLC plate below which of the following statement(s) is/ are false ? |- Rf value…

A: It is given a TLC plate in which the solvent travels a distance of 0.75 (approximately), and…

Question

8. The flash point of an engine oil is 363°F. What is the absolute flash-point temperature in K and R?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, chemistry and related others by exploring similar questions and additional content below.

Similar questions

What are the functions of the graduated cylinder and distillate in a distillation set-up?
What is the simplest CGS unit for "poise"?
A good sample of benzoic acid melts at 121-122˚C. However, a student had a sample that melted over a range of 114 to 118 ˚C. What did the student conclude about this sample?
Which technique is based on the stronger attractionsome components have for the stationary phasecompared to the mobile phase? A. filtration D. chromatographyB. distillation E. sublimationC. crystallization
Is 10 ppm 400% less than 50 ppm?
Use a chemical dictionary, chemical text or encyclopedia to find a specific definition of "chromatography." List a few mobile and stationary phases.
These organic solvents are used to clean compact discs:(a) If a 15.00-mL sample of CD cleaner weighs 11.775 g at 20C, which solvent is most likely to be present?(b) The chemist analyzing the cleaner calibrates her equipment and finds that the pipet is accurate to 0.02 mL, and the balance is accurate to 0.003 g. Is this equipment precise enough to dis-tinguish between ethanol and isopropanol?
List the do's and dont's in a science laboratory
Two methods measured the Cdse content (g/L) of six different samples of nano-crystals. Do the two methods differ significantly at the 95% confidence level
Pure aspirin has a melting point of 135-136 °C. Before the melting point was determined - if the sample contains water by absorbing moisture in the air - what effect could this have on the observed melting point from the sample?
Filtration of samples A, B, and C show no residue left. After letting them dry in different beakers, SAmple A remains no residues. Sample B shows crystal leftovers, and sample C show brown film on the beaker walls. This means that: a. Two or more samples are heterogenous b. Two or more samples are homogenous c. all sample have 2 or more phases d. all samples are pure
A student dissolves a Jefferson nickel to make 100.00 mL of solution in a volumetric flask. The student takes a 5.00 mL5.00 mL aliquot of the first solution and dilutes it to make 100.00 mL100.00 mL of a second solution. The student places a sample of the second solution in a cuvette for analysis using spectrophotometry. The molarity of the copper solution in the cuvette was determined by spectrophotometric analysis to be 2.90×10−2 M Cu.2.90×10−2 M Cu. Calculate the mass of copper in the Jefferson nickel used to make the first solution.