Answered: An open tubular column with an inner…

An open tubular column with an inner diameter of 0.25 mm had a volumetric flow rate of 0.95 min-1 . What is the linear flow velocity in cms at the column outlet?

Fundamentals Of Analytical Chemistry

9th Edition

ISBN:9781285640686

Author:Skoog

Publisher:Skoog

Chapter31: Introduction To Analytical Separations

Section: Chapter Questions

Problem 31.22QAP

See similar textbooks

Related questions

Q: sely proportional to the column efficiency irectly proportional to the selectivity factor not…

A: B option is correct. Inversely proportional to column efficiency. Band-broadening is a general term…

Q: columns of equal length. The void time, tM, is equal to 1.75 min on each column. A tm Column 1…

Q: Smaller particles affect HPLC column efficiency in what ways? A)increase the mass transfer term.…

A: High performance liquid chromatography or HPLC is an analytical technique used to identify and…

Q: What other method besides conductivity can be used to determine CMC (critical micelle…

A: Critical micelle concentration (CMC) can be determined by conductometric titration.

Q: in the separation of these 8 organic herbicides using HPLC in two different modes: Isocratic elution…

A: Solution: i) part Comparison of isocratic elution and gradient elution in this experiment: Isocratic…

Q: The performance of the supercritical fluid chromatography could be improved by all of the above a O…

A: Supercritical fluid chromatography is an analytical technique for separation and identification of…

Q: What is the purpose of the internal calibration mass at the upper left in the electronic balance

A: In chemistry the accurate measurement of mass is needed for performing titrations, reactions. For…

Q: Dye 1 Dye 2 Run 1 Run 2 Run 3 Run 1 Run 2 Run 3 Start of Band (mL} 1.1 1.1 1.2 2.2 2.2 2.3 End of…

A: Retention Volume : It is the volume of the mobile phase which is required to elute out a particular…

Q: The osmosis rate in these set-ups will slow down over time. Why?

A: Osmosis is the process of diffusion (movement of particles or molecules) of water across a…

Q: If you have a compound that elutes from an LC column at 8.2 mins, what are the mobile phase…

A: As the ramp is 15 percent per min on between 5 to 10 minute. The difference in the time is 5 minute…

Q: If the concentration in a bulk solution adjacent to a fibrous medium is at a concentration cA…

A: The relation to calculate the partition coefficient is shown below. K=CSCM Here, CM is the…

Q: Suppose that after delivery several drops of water cling to the inner wall of the pipet (because the…

A: Density is physical quantity that can be determined with the help of mass and volume of the given…

Q: The cool plasma tail needs to be removed in regular ICP-OES analysis using the axial view. Provide…

A: A question about spectroscopy, which is to be accomplished.

Q: a) In any gas chromatographic analysis, exceeding a column's maximum temperature limit will usually…

A: Gas chromatography

Q: A hollow fiber membrane filtration module has a hydraulic permeability of Lp %3D 10-13 m S'Pa The…

Q: Which of the following is the correct flow of the mobile phase in HPLC? Solvent degasser>Guard…

A: The mobile phase in HPLC is used to transport the sample via seperation column and there by detector…

Q: What is the HETP of a column that is 200mm with a retention time of 5mins. The (effective)…

A: To calculate HETP and separation factor, α

Q: If the radius of column 0.25 cm, the linear.3 velocity of mobile phase 10.0 cm/min, and the fraction…

Q: Suppose that the sample size was 3.0 mg, the column dimensions were 1.00 m length 3 4.0 mm diameter,…

Q: a) The relationship between permeate weight and time with fabrics. b) The characteristic of fabrics…

Q: What was the most important parameter change that lead to the development of modern HPLC? A.…

A: answer- What was the most important parameter change that lead to the development of modern HPLC -…

Q: What are the benefits of decreasing the column internal diameter? O Increased sample capacity O…

A: Answer - The correct option is (c) Increased resolution Explanation - As we lower the internal…

Q: 1- The mass flux for dilute naphthalene from the surface 2- Then find the partial pressure of…

A: Radius of the naphthalene sphere r=1.5 mm =(1.5×10-3) m=0.0015 m Temperature T = 320 K Pressure P =…

Q: (C) Determine the concentration of unknown K3FE(CN)6 solution from the cyclic voltammograms at…

A: Generally, Cyclic voltammetry is often performed in an electrochemical study of a compound,…

Q: Small explanation needed. In reverse-phased separations, _______ column volume(S) of initial…

A: When two or more substances are mixed in a definite proportion, it yields the mixture. The…

Q: HW1: For diffusion flame if mixture fraction governing equation is given as: az = D at ax2 a2z az +…

A: 1. As per the given differential equation,

Q: Please show your own work. 2. For a flow rate 0.8 m'.s' how many rapid filter sand boxes of…

Q: 16 14 12 10 4 2 10 20 30 Minutes 40 50 60 70

A: From retention time and width of two peaks,Resolution for the given chromatogram can be determined.…

Q: A dry-wet-dry oxidation cycle of 20 min – 80 min – 20 min is performed at 1100 °C. (a) What is the…

A: <100>Silicon wafer:

Q: which of the four binary mobile phase compositions (mixing ratio 1: 1) shown below will have the…

A: The polar and non-polar compounds are: Non-polar - Pentane, toluene. Polar - Methanol, acetone,…

Q: Sketch a graph of the van Deemter equation (plate height versus flow rate). What would the curve…

A: The van Deemter equation is a relationship between the height of the plate during the flow of mobile…

Q: Compare gradient and isocratic mode in HPLC.

A: Gradient and isocratic mode in HPLC are the two different modes of operating condition in HPLC.

Q: (C) Determine the concentration of unknowWn K3FE(CN)6 solution from the cyclic voltammograms at…

Q: How GC retention time can be affected by the mobile phase flow rate and the temperature of the…

Q: Air displacement pipettes is ALWAYS MORE accurate than Mohr and serological pipettes because…

A: To determine whether the given statement is true or false and if false, determine the word that…

Q: Give clear handwritten Solution: Pressure of 50.0 psi is used to drive hexane through a 4.00 m…

A: Length of capillary = 4.00m Diameter of capillary = 7.50 um

Q: pt: The analyte component interacting most strongly with the stationary phase faster than those with…

A: Part A: We know that, the components that adhere more strongly to the stationary phase travel more…

Q: Consider the TLC plates below Solvent Front 00 Solvent System 1 00 Solvent System 2 0. Solvent…

A: The experimental data given is,

Q: e absolute flash-point temperature in K and R?

Q: DO R O a blackboard.uob.edu.bh View Assessment Given below is the diagram of Process of…

A: The unmarked component is detector. It is placed at the bottom of the column. It responds to solute…

Q: A disk type centrifuge with disks at 450 angle is used to clarify a suspension of E.coli cells with…

A: Centrifugation is a mechanical process which involves use of centrifugal force to separate particles…

Q: f the dwell time is 3.5 min for a solvent gradient of 5% B to to 60% B over 20 mi what is the % B…

A: Solution- Given data- Dwell time is 3.5 min. Solvent gradient of 5% B to 60% B in 20 min. To find-…

Q: What are the disadvantages of using a non- ideal linear velocity on the chromatographic separation…

Q: Should you increase the diameter or length of the chromatography colum for increasing throughput?

Q: A silver-30%gold alloy sample (cylindrical with 1 cm diameter and 0.3 cm height) is subjected to a…

A: The time can be calculated by Faraday's law, m = EitFm: mass of silveri: current (Ampere)F:…

Q: Given below is the block diagram of gas chromatography. Identify the unmarked component Column Gas…

A: The chromatographic method used for separating and analyzing compounds that can be vaporized without…

Question

100%

An open tubular column with an inner diameter of 0.25 mm had a volumetric flow rate of
0.95 min-1
. What is the linear flow velocity in cms at the column outlet?

Expert Solution

Step 1

Step 2

Step 3

Step by step

Solved in 6 steps with 6 images

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, chemistry and related others by exploring similar questions and additional content below.

Similar questions

If the radius of column 0.25 cm, the linear.3 velocity of mobile phase 10.0 cm/min, and the fraction of the column accessible to the mobile phase 0.50, then the flow rate of the mobile phase ??
Sketch a graph of the van Deemter equation (plate height versus flow rate). What would the curve look like if the multiple path term were 0? If longitudinal diffusion were 0? If the finite equilibration time were 0?
Column length: 25.0 cm Column diameter: 0.46 cm Stationary phase: C-18 Mobile phase: 80% methanol in water Flow rate: 1.0 mL/min Dead time: 5 min Peak width at base, WA = 20 Peak width at base, WB = 24
Chemistry Column 25 m length and 0.2 mm I.D. has efficiency is 100,000 theoretical plates; Flow rate is 1 mL/min. Calculate the peak width for component with retention factor 2. Which data acquisition sampling rate should be used for proper quantification of this component? Explain. (For accurate integration peak should have at least
What effect will the following have on plate height (H). Make sure to explain your full and complete reasoning. Increasing stationary phase thickness. Reducing the rate of sample injection. Increasing mobile phase flow rate. Decreasing temperature. Reducing stationary phase particle size.
A fly ash aerosol of monodisperse particles with a density of 2.0 g/mL and particle diameter of 10.0 mm has a concentration of 1000.0 mg/m3. Calculate the settling velocity in cm/s and the settling rate in g/m2-s. Please answer very soon will give rating surely
Suppose that after delivery several drops of water cling to the inner wall of the pipet (because the pipet wall is dirty). Will this technique error increase, decrease, or have no effect on the reported density of the water? Explain.
Give clear handwritten Solution: Pressure of 50.0 psi is used to drive hexane through a 4.00 m length of capillary of 7.50 um diameter. Calculate the average flow velocity (v).
Suppose that the sample size was 3.0 mg, the column dimensions were 1.00 m length 3 4.0 mm diameter, and the flow rate was 7.0 mL/min. What size column and what flow rate should be used to obtain the same quality of separation of 27.0 mg of sample?
A dry-wet-dry oxidation cycle of 20 min – 80 min – 20 min is performed at 1100 °C. (a) What is the final oxide thickness for a <100> silicon wafer? (b) What is the final oxide thickness for a <111> silicon wafer?
Hello, can someone please help me? I have already hand graphed 1 and 2 and found the v max, however I cannot find the Km value. I am confused because the plots on the linear weaver burk plot do not extend past the values that make up the line. So how am I supposed to estimate the value for the y-intercept in order to find the Km value
What is gradient elution? a. Variation of the column temperature during elution b. Variation of the stationary phase composition during elution c. Variation of the mobile phase composition during elution d. Variation of the mobile phase flow rate during elution