Answered: GCMS is running at high temperatures to…

GCMS is running at high temperatures to achieve compounds vaporization and separation. Describe why the transfer line temperature and filament are usually set similar or higher than the column

Principles of Instrumental Analysis

7th Edition

ISBN:9781305577213

Author:Douglas A. Skoog, F. James Holler, Stanley R. Crouch

Publisher:Douglas A. Skoog, F. James Holler, Stanley R. Crouch

Chapter27: Gas Chromatography

Section: Chapter Questions

Problem 27.27QAP

See similar textbooks

Related questions

Q: For samples with broad boiling points components in GC separations, it is important to establish…

A: The solution is given below -

Q: Smaller particles affect HPLC column efficiency in what ways? A)increase the mass transfer term.…

A: High performance liquid chromatography or HPLC is an analytical technique used to identify and…

Q: The following are the basic components of XRD except-* Source Primary optics Sample Holder…

A: XRD is used to determine the crystal structure of a sample, It is the important characterization…

Q: plalh the difference between the split and splitless mode of operation in a GO jector. Consider…

Q: Mention one disadvantage of a capillary column as compared to a packed column

A: Please find your solution below : Capillary and packed columns are the two types of columns that are…

Q: What is Low-excess-air firing (LEA)?

A: Given: Low-excess-air firing (LEA)

Q: What is the purpose of the internal calibration mass at the upper left in the electronic balance

A: In chemistry the accurate measurement of mass is needed for performing titrations, reactions. For…

Q: An open tubular column with an inner diameter of 0.25 mm had a volumetric flow rate of 0.95 min-1 .…

Q: type sensor includes SnO2 layer which changes its resistance with respect to reducing gas…

A: MOS sensors: They detect concentration of different types of gases by measuring the resistance…

Q: Briefly compare and contrast flash-photolysis with shock-tube method.

A: Flash-photolysis and shock-tube method are used to study kinetics of fast reactions.

Q: polarography 3. (a). Write down the principle of polarography and deduce Ilkovic equation for the…

A: The answers are given below.

Q: Define the following terms used in HPLC: (a) gradient elution (b)…

A: Given terms, (a) gradient elution (b) isocratic elution (c) reversed-phase packing

Q: The cool plasma tail needs to be removed in regular ICP-OES analysis using the axial view. Provide…

A: A question about spectroscopy, which is to be accomplished.

Q: The next two questions pertain to the situation described below. Calcium atoms (mass = 6.66x10-26…

A: Given, mass of calcium atom , m =6.66×10-26 kgvelocity = 4msseparation between the slits , d=50…

Q: Find the weighted adjacency matrix of the following direted graph and represent that as a CSR-marix.

A: Weighted Adjacency Matrix: It is 2-D array which represents a data structure which can say that…

Q: If the radius of column 0.25 cm, the linear.3 velocity of mobile phase 10.0 cm/min, and the fraction…

Q: Polarographic cells are used to measure the partial pressure of gases only in static gas monitoring…

A: Please see explanation

Q: What type of instrument is shown in the diagram? Reference cell Po 0. Amplifier Grid Source hv…

A: The light beam in single beam instruments passes through the sample without splitting, but the beam…

Q: Describe the mechanisms of strength at the peak hardness of a precipitation hardened alloy when both…

Q: a) The relationship between permeate weight and time with fabrics. b) The characteristic of fabrics…

Q: What was the most important parameter change that lead to the development of modern HPLC? A.…

A: answer- What was the most important parameter change that lead to the development of modern HPLC -…

Q: Point out TWO (2) strategies to increase selectivity in solid phase extractions.

A: A question based on analytical separations that is to be accomplished.

Q: What are the benefits of decreasing the column internal diameter? O Increased sample capacity O…

A: Answer - The correct option is (c) Increased resolution Explanation - As we lower the internal…

Q: For bulk crystalline sample which technique is best ? Give me handwritten answer with explaination?

Q: why is an electro thermal atomizer more sensitive than flame atomizer?

A: The oldest technique used in Atomic absorption spectroscopy is the Flame atomizer.

Q: Phosphorous is predeposited at 4.5 x 10^20 atoms/cm^3 on a silicon wafer with an initial…

A: Answer is explained below.

Q: Why is a filter paper preferred over a sintered glass filter?

A: Filtered paper is made up of fiber and there are numerous holes (obviously of microscopic size) in…

Q: 16 14 12 10 4 2 10 20 30 Minutes 40 50 60 70

A: From retention time and width of two peaks,Resolution for the given chromatogram can be determined.…

Q: A dry-wet-dry oxidation cycle of 20 min – 80 min – 20 min is performed at 1100 °C. (a) What is the…

A: <100>Silicon wafer:

Q: Choose the appropriate techniques for degassing the mobile phase of HPLC. I. Ultrasonic II. Boiling…

Q: The resulting retention volumes for a series of polystyrene standards Molar mass (g/mol) Retention…

A: Given: Molar mass (g/mol) log(Mw) Retention volume (mL) 640000 5.80618 12.14 483000 5.683947…

Q: Sketch a graph of the van Deemter equation (plate height versus flow rate). What would the curve…

A: The van Deemter equation is a relationship between the height of the plate during the flow of mobile…

Q: Two parallel gray planes have emissivities of 0.8 and 0.7 and are maintained at 800°C and 1500°C.…

Q: Match the ff. definition/use with the correct detector being described. consists of a…

A: A phototube, makes use of the photoelectric effect, and have semi cylindrical photocathode and wire…

Q: What is the dimension of a chlorine contact chamber if the CT value is 150 mg-min/L at the chlorine…

A: Given: CT value=150 mg-min/L Chlorine concentration=5 mg/L

Q: In atomic spectroscopic techniques, flames and furnaces are commonly used to atomize the samples.…

A: In atomic spectroscopic techniques, flames and furnaces are commonly used to atomize the samples.…

Q: List four input transducers nd very briefly describe how they are used.

A: LIST OF FOUR INPUT TRANSDCERS

Q: what is the difference between linear voltammetry, cyclic voltammetry and differential anodic…

A: Voltammetry is an electroanalytical technique where the information about an analyte is obtained by…

Q: In solid state sintering of compacted metal powder material, discuss how the progress of…

A: Sintering is the process of transforming a powder into a solid body using heat. It is the process…

Q: Air displacement pipettes is ALWAYS MORE accurate than Mohr and serological pipettes because…

A: To determine whether the given statement is true or false and if false, determine the word that…

Q: e absolute flash-point temperature in K and R?

Q: Molecular Weight Range 8,000-20,000 20,000-32,000 32,000-44,000 44,000-56,000 56,000-68,000…

A: based on the given data graph is plotted as follows

Q: What could be the effect of trapped bubbles in the viscometer during the run on (a) the measured…

A: Type of problem depending upon size of bubbles: A small amount of very small bubbles has no effect.…

Q: What are the disadvantages of using a non- ideal linear velocity on the chromatographic separation…

Q: Indicate the order of elution of the following compounds from a normal-phase packed HPLC column a.…

A: Several compounds mixed in any particular solution mainly separated by utilizing the technique…

Q: A silver-30%gold alloy sample (cylindrical with 1 cm diameter and 0.3 cm height) is subjected to a…

A: The time can be calculated by Faraday's law, m = EitFm: mass of silveri: current (Ampere)F:…

Q: -forming density gradients in respect of the following: I. Type of gradient material used. II. The…

A: Rate-zonal separation and isopycnic separation will be the two primary forms of density gradient…

Q: According to given TLC plate below which of the following statement(s) is/ are false ? |- Rf value…

A: It is given a TLC plate in which the solvent travels a distance of 0.75 (approximately), and…

Question

GCMS is running at high temperatures to achieve compounds vaporization and separation. Describe why the transfer line temperature and filament are usually set similar or higher than the column

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1 Introduction interpretation

VIEW

Step 2 Explanation

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, chemistry and related others by exploring similar questions and additional content below.

Similar questions

Smaller particles affect HPLC column efficiency in what ways? A)increase the mass transfer term. B)diminish the pressure constraints of the mobile phase. C)reduce stationary phase retention D)enable lower slopes inthe C term E)cause higher temperature as a result of increased frictional heating.
Does the amount of radiation (cpm) increase or decrease as the distance between the sorce and the sensor increases? Explain
prepare an assignment on Application of HPLC in Drug Analysis(Amiloride): one page show name of the drug, dosage form, extraction step, type of column, separation parameters e.g., flow rate, mobile phase, detection wavelength and run time
Explain how the Rf (Retention Factor)-values can be in agreement or disagreement with the “like dissolves like” principle?
spectrofluorometry is potentially more sensitive and selective compared tospectrophotometry
Chemistry Column 25 m length and 0.2 mm I.D. has efficiency is 100,000 theoretical plates; Flow rate is 1 mL/min. Calculate the peak width for component with retention factor 2. Which data acquisition sampling rate should be used for proper quantification of this component? Explain. (For accurate integration peak should have at least
What effect will the following have on plate height (H). Make sure to explain your full and complete reasoning. Reducing the rate of sample injection.
What is laser ablation and how can it he used to sample solids for ICPMS?
Why is catalytic dewaxing not considered as a separation process? and
Define the following terms used in HPLC: (a) gradient elution (b) isocratic elution (c) reversed-phase packing (d) sampling loops (e) bonded-phase packing (f) gel filtration Please answer problems a-f
What is Low-excess-air firing (LEA)?
Which among the options for minimzing errors (Separation, Saturation-Mix Modification-Masking, Dilution and Matrix Matching, Internal Standard Methods, Standard Addition Methods) is most helpful with more advantages than disadvantages?