Answered: For SFE, differentiate between (a)…

Science

Chemistry

For SFE, differentiate between (a) on-line and off-line processes. (b) static and dynamic extractions.

Fundamentals Of Analytical Chemistry

9th Edition

ISBN:9781285640686

Author:Skoog

Publisher:Skoog

Chapter34: Miscellaneous Separation Methods

Section: Chapter Questions

Problem 34.18QAP

See similar textbooks

Related questions

Q: sely proportional to the column efficiency irectly proportional to the selectivity factor not…

A: B option is correct. Inversely proportional to column efficiency. Band-broadening is a general term…

Q: Mercury is present in Lake Miramar at a total concentration of 20.4 ng/L. Lab tests suggest an…

A: The partition coefficient can be calculated as: K=CHg×CpCdissolve (1) Where CHg is the…

Q: Calculate the dead time (tm), based on the following log tr (min) vs. #Carbons plot for the GC-FID…

A: A question based on analytical chemistry that is to be accomplished.

Q: On a 0.109-mm-diameter column with a 0.813-μm-thick stationary phase, an unretained solute passes…

A: Phase ratio is ratio between volume of the column and thickness of the film coated inside wall of…

Q: 1. Discuss briefly the specifications and test parameters for system suitability for HPLC analysis.

A: Important Parameters used in HPLC analysis are as follows: 1). Retention time (tR): It is the time…

Q: Which of the following results from an in-line HPLC mobile phase filter becoming plugged with…

A: Correct option is B.

Q: Write three substances or species that can be determined using each of the following instrumental…

A: Introduction: A pH meter is a device used to measure the hydrogen ion activity in the solution. The…

Q: In Ghana, it has been noticed that adulteration of palm oil with carcinogenic dyes are on the rise.…

A: The adulteration of palm oil with many fat soluble azo dyes that are difficult to separate from the…

Q: kindly prepare an assignment on Application of HPLC in Drug Analysis: one page show name of the…

A: In high-performance liquid chromatography (HPLC) we inject the sample, which is in solution form,…

Q: The mass transfer term "C" depends on which of the following factors? A.type of column B.length of…

A: Chromatography:

Q: Dye 1 Dye 2 Run 1 Run 2 Run 3 Run 1 Run 2 Run 3 Start of Band (mL} 1.1 1.1 1.2 2.2 2.2 2.3 End of…

A: Retention Volume : It is the volume of the mobile phase which is required to elute out a particular…

Q: You add 1 mL of sample and collect 1 mL fractions from a column with a volume of 20 mL where the…

A: Ans:- Given: column size is 20ml , sample loaded is 1 ml. Now, we see that the partition coefficient…

Q: confirmation ▪ True or false: The purpose of the internal standard is to make quantitation of the…

A: Internal standard is added blank as well as sample to determine the concentration of analyte.

Q: What is the role of stationary phase and mobile phase in Chromatography? Please shortly write at…

A: Concept is based on Chromatography.

Q: 7.7 Separation of Two Solutes Having Linear Equilibrium Two solutes have a linear equilibrium with…

A: The effective velocity of solute: u=vε+1-εK The superficial velocity is given by: v=ratearea=rAπr2

Q: The interaction between a basic analyte and the residual silanol groups of the stationary phase is…

A: When pH of mobile phase is equal to pKa of silanol then its proton will get deprotonated and basic…

Q: How long is a macrocentury, if a lecture period (50.0 min) is close to 1.00 microcentury?

A: Given: 1.00 microcentury = 50.0 min approx.

Q: What is the gravimetric factor if a weight of cl is to be determined from a weight of PbCl2?

A: A gravimetric factor converts grams of a compound into grams of a single element. Example-…

Q: What is the role of specific visualizing agents in a Thin layer Chromatography? Please shortly write…

A: Thin Layer Chromatography (TLC) is a type of adsorption chromatography in which separation of…

Q: columns of equal length (time in min). Column 1 Column 2 10 suodsa opaad

A: Answer. For Component A we have 8-1.2 = 6.8

Q: How would i perform a serial dilution of 1/2 and 1/4 if i have 7.5mL of an unknown protein, the…

A: The molarity of a solution is the number of moles of solute in the solvent. Molarity varies with the…

Q: What do you understand by Isocratic and Gradient elution?

A: Isocratic Elution : In the light of chromatography isocratic elution means that the composition of…

Q: Which of the following is an example of co-precipitation error? mixed-crystal formation…

Q: What is the difference between isocratic and gradient elution?

Q: Why does the efficiency (decreased plate height) of liquid chromatography increase as the stationary…

A: to improve resolution in HPLC by Increasing column length. by Decreasing particle size. by…

Q: What are the properties that determine retention time in the Chromatography process?

A: In chromatography, retention time is the interval between the injection of a sample and the…

Q: The partition coefficient of ammonia between water and chloroform is wanted to be determined. The…

A: In this question determine concentration of ammonia in water and chloroform with the help of HCl and…

Q: ist FOUR kinetic variables that affect column efficiency and explain how each variab

A: Band broadening reflects the the loss of column efficiency

Q: Explain how it is that SPE cartridges & disks allow analysts to more efficiently pre- concentrate…

A: Interpretation- To explain that how SPE cartridges and disks allow analysts to more efficiently…

Q: An organic compound is extracted from an aqueous phase using an organic solvent: 40 ml of the…

Q: When a Levy-Jennings graph for TSH was checked, the mean of results was found to have shifted by…

A: Ans. (a) This is a systematic type error (a constant shift in one direction). Systematic or bias…

Q: 0.2 E o: A В 0.1 E 5 10 15 20 Linear velocity, cm/s Plate height H, cm

A: Van Deemter Equation: This equation is used in a packed column in gas chromatography where plate…

Q: Let the retention factor of species A be 0.2 while the retention factor of species B be 0.4. If…

A: The factor reflecting the dissolving/soluble capacity of any pigment in known solvent is designated…

Q: which of the four binary mobile phase compositions (mixing ratio 1: 1) shown below will have the…

A: The polar and non-polar compounds are: Non-polar - Pentane, toluene. Polar - Methanol, acetone,…

Q: Compare gradient and isocratic mode in HPLC.

A: Gradient and isocratic mode in HPLC are the two different modes of operating condition in HPLC.

Q: Comment on the strengths and limitations of particle sizing using sieve analysis. Suggest an…

A: Sieving is a technique for particle sizing which is performed to separate a sample based on its…

Q: What is the role of stationary phase and mobile phase in Chromatography? Please shortly answer at…

A: The stationary phase remains fixed in place while the mobile phase carries the components of the…

Q: Which is NOT a factor that affects retention time? I. the pressure used II. The nature of the…

A: the retention time will vary depending on: the pressure used (because that affects the flow rate…

Q: Based on the given preparation procedure, identify THREE mistakes that were made.

A: High-performance liquid chromatography (HPLC) is a more enhanced chromatography with a large…

Q: How GC retention time can be affected by the mobile phase flow rate and the temperature of the…

Q: Table 2. Effect of injection volume and temperature on retention time, peak width and resolution.…

A: Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: pt: The analyte component interacting most strongly with the stationary phase faster than those with…

A: Part A: We know that, the components that adhere more strongly to the stationary phase travel more…

Q: A) Predict the elution order of 2-naphthoic acid (pKg = 4.16), 2-nitrobenzoic acid (pKg = 2.185),…

A: Elution is played a major role in Column chromatographic methods. It is the process of extracting…

Q: Prepare a procedural flow chart that provides a simplified overview of the entire extraction…

A: The procedural flow chat of extraction process is explained in step 2.

Q: A silver-30%gold alloy sample (cylindrical with 1 cm diameter and 0.3 cm height) is subjected to a…

A: The time can be calculated by Faraday's law, m = EitFm: mass of silveri: current (Ampere)F:…

Q: FT-IR technique can be utilized for the analysis of unknown analytes by matching it with__________.…

Question

For SFE, differentiate between
(a) on-line and off-line processes.
(b) static and dynamic extractions.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, chemistry and related others by exploring similar questions and additional content below.

Similar questions

If some of the analytes were found to be out of range after doing the Quality Control and the machine repeatedly gives invalid result. What are the possible problem and best solution as a Medical Technologist?
prepare an assignment on Application of HPLC in Drug Analysis(Amiloride): one page show name of the drug, dosage form, extraction step, type of column, separation parameters e.g., flow rate, mobile phase, detection wavelength and run time
How long is a microcentury, if a lecture period (50.0 min) is close to 1.00 microcentury?
How long is a macrocentury, if a lecture period (50.0 min) is close to 1.00 microcentury?
Prepare a procedural flow chart that provides a simplified overview of the entire extraction process.
The partition coefficient of ammonia between water and chloroform is wanted to be determined. The necessary quantities of ingredients are taken into the separation funnel, and the extraction process is applied. At the end of the extraction process, 5 mL portions of each of the water and chloroform phases are titrated with 0.1 M HCI in the presence of methyl orange indicator. If the volumes spent at the turning points are 7.2 and 5.1 mL, respectively, calculate the KSU, KLOROFORM (Dispersion coefficient) value.
Which of the following is an example of co-precipitation error? mixed-crystal formation re-precipitation occulsion surface adsoprtion
How would i perform a serial dilution of 1/2 and 1/4 if i have 7.5mL of an unknown protein, the final volume is 0.5mL and the known protein standard is 100 microgram/mL?
Describe the different types of GC instrumentation and column types available, and provide some of the pro’s and con’s of each particular type for pharmaceutical and forensic analysis.
The mass transfer term "C" depends on which of the following factors? A.type of column B.length of column C.size of solvent particles D.equilibration of analyte particles partitioning between the mobile phase and stationary phase E.interaction between stationary phase and mobile phase
What are the properties that determine retention time in the Chromatography process? Please shortly write at your own words. (5-6 lines maximum ).
What are method blanks and method detection limit used in analytical chemistry? Explain thoroughly