Answered: If you had a cell suspension of 2.5 x…

If you had a cell suspension of 2.5 x 10^4 cells/mL and plated 100uL into each well (4 wells), how many cells were added per well?

Curren'S Math For Meds: Dosages & Sol

11th Edition

ISBN:9781305143531

Author:CURREN

Publisher:CURREN

Chapter1: Relative Value, Addition, And Subtraction Of Decimals

Section: Chapter Questions

Problem 38SST

See similar textbooks

Related questions

Q: Below is a trace from an analytical gel-filtration column upon which a single sample containing a…

A: Gel filtration column is used in gel filtration chromatography (GFC) technique. GFC is also known as…

Q: You want to set up a 1:10 dilution series, so that you can plate a 10-1, 10-2, and a 10-3dilution;…

A: It is basically done for counting the microorganisms like viruses, bacteria etc from an unknown…

Q: You were instructed to add 0.2 ml of kombucha to 9.8 ml of fresh tea, but instead added 2.0 ml of…

A: Dilution is defined as the ratio of stock volume to the final volume. Here, final volume is the sum…

Q: Appropriate pippetor for measuring 10ul of liquid is: 200 1000 20

A: INTRODUCTION Pipette Pipette is a laboratory equipment used to transfer small quantities of liquid.

Q: The following Rf values were computed from a reverse phase chromatography experiment. Arran them…

A: There are different techniques to separate a compound from a mixture of substances. The different…

Q: Calculate the CFU present in 150 mL water sample and b) dilution factor up to 5. Consider the…

A: The serial dilution process is used to calculate the number of microorganisms present in a…

Q: When calibrating a pH meter, 3 (three) standard color-coded buffer solutions are used, which of…

A: pH is a quantitative measure of how acidic or basic is the aqueous or other liquid solution is. It…

Q: When 11 milliliters are transferred from his sample to a dilution vial containing 99 ml, what is the…

A: Given Volume of stock transferred = 11ml Vial volume = 99ml Both are same unit so don't have to…

Q: How many CFU per ml are there in the original sample using the following dilution and plating…

A: "Microbiology" is a hugely important field in both basic and applied research. New and fascinating…

Q: In a neutral solution, the [H] is : O 1.0x10-14M zero 1.0×107M 1.0x10-7M

A: The acidity of any solution is determined by the molarity of the Hydrogen ions. So, the pH of any…

Q: relative density of the insoluble powder

Q: Results: Tub Ranking of reaction Iodine Test Benedict's Test e rate 1 2 3 4

A: The most important thing to remember is that chemical reactions rely on reactant particles colliding…

Q: How would you determine the contents of the test tubes if all of the samples were transparent?

A: The study of chemical reactions that occurs within living organisms is called biochemistry. This…

Q: 1,500,000 units of an antibiotic if the elixir contains three million units per fluid ounce?

A: Elixir An elixir is sweetened alcoholic solution of alcohol containing a medicinal drug with syrup…

Q: Using 25 µL of a patient's serum, how much diluent would be needed to create a 1:2 dilution? ul

A: Firstly, we convert the 25ul into ml . i.e. 25 ul = 0.03 ml Then, there will be the multiplication…

Q: if you are following a protocol requiring to use 200,000 cells, how much of the suspendion that…

A: Cells are the basic functional and structural unit of the body. The cells of the body are…

Q: Using the fraction conversion method solve the following Convert 500 mL=______qt

A: Millilitres to quarts: Both quarts and millilitres are units used to measure volume. 1 millilitres…

Q: You receive an order for 750 mL of 27% dextrose solution. You have available D50W, 1000 mL. How many…

A: Given, D50W means 50% dextrose solution, 100 ml 750 ml of 27% dextrose is desired Sterile water

Q: Now calculate the slope and equation for the best fit line. You may use excel

Q: You count 4 squares of a hemacytrometer and ontain 82,65,85 cells in each squy.what is the cell…

A: Hemocytometer is device used for the counting of blood cells in a sample. It has counting chambers…

Q: Which of the following reagents will you include in the blank (negative control) for this…

A: A variable is any quantity we can measure. In any experiment there are three variables:…

Q: | || | | || | || 1 45 Using the figure, which lane has a poor quality sample and is possibly…

A: Electrophoresis (Gel electrophoresis) is commonly used in labs to study a mixture of biomolecules…

Q: What occurred when the blood was mixed with each solution, distilled water, ISO 0.9% and ISO 12.5%…

A: Osmosis is a latent process and results without any expense of power. It includes the transfer of…

Q: If the 10-9 plate was counted to have 155 colonies on it, would the CFU/mL be 1.55*1011? If not,…

A: CFU Colony forming unit it a method to calculate the number of microorganisms in a culture media.

Q: Using 25 μL of serum, how much diluent would be needed to create a 1:2 dilution? ______ μL

A: The process of reducing a solute concentration by adding solvent to a solution is referred to as…

Q: How would you make two-fold serial dilutions such that the last tube is a 1:32 dilution of the…

A: Serial dilution is used mostly in studies involving cell cultures (microbiology or even cell culture…

Q: You have a 6 M solution of stock A. You do the following serial dilutions: Add 1 ml of stock A to…

A: Dilution is calculated by stock volume to the final volume. Solution = Stock volume/ (stock volume+…

Q: Using absorbance readings and a standard curve relating absorbance to cell number, you suspect that…

A: The countable range of colonies for an ideal plate count method is considered 30-300 colonies per…

Q: Using 10 μL of a patient's serum, how much diluent would be needed to create a 1:10 dilution? ______…

A: Dilution is the technique of lowering the concentration of a solute in a solution by merely adding…

Q: Below is a BSA standard curve and the duplicate values of absorbance for 3 samples. Calculate the…

A: Standard curve is made with known concentrations of Bovine serum albumin (BSA) to find the unknown…

Q: Label three sets of eight microfuge tubes (1-8) and add the volumes of BSA stock solution (2 mg/ml)…

A: BSA is Bovine Serum Albumin and it is a serum albumin protein which is obtained from cows and often…

Q: rate for the remaining solution to complete on time. have infused. The set calibration is 20 gtt/mL.…

A: Given:- To give 1000 mL IV fluid to run for 8hrs. Only 250 mL infused after 4 hr Calibration set is…

Q: Complete the Table Volume capacity and precision a graduated cylinder 50 mL; P=0.1 mL Volume…

A: Diluting a concentration solution: In order to prepare a lower concentration solution from a given…

Q: What is the estimated size of the specimen under a 10x10 ocular micrometer under HPO? (Take note:…

A: The specimen size can be calculated by using the number of ocular units occupied by it. Here simply…

Q: To make 500ml of 1xBuffer, measure __ML of 20x stock and add ___mL water to make the total volume…

A: To make a 500 ml of 1x buffer , measure 25 ml of 20x stock and add 475 mL of water to make a total…

Q: Using 25 uL of a patient's serum, how much diluent would be needed to create a 1:2 dilution? ______…

A: Blood is found in the human body's capillaries/veins/arteries, which are blood vessels that flow…

Q: You are asked to prepare Murashige & Skoog (MS) medium according to concentration shown the Table.…

A: We are having the concentration of the ammonium nitrate and potassium nitrate at 1 litre or 1000 ml…

Q: To prepare a vaginal irrigation, a nurse uses 3 tsp of vinegar and 1.5 L of water. a. How many ml…

A: Vaginal Irrigation is a technique wherein large amounts of water are flushed into the vagina in…

Q: 7.3x105 CFU/ml= Broth culture, how many bacteria would be contained

A: The number of viable bacterial cells in liquid culture is estimated by means of a colony-forming…

Q: A sample is diluted by a factor of 10 five times. The 10^-3 dilution has 272 colonies on it.…

A: A serial dilution is a process of sequential dilution in order to decrease the density of cell…

Q: You obtained the following raw data when setting up a Biuret standard curve: BSA (mg/ml) 0 1 2 3 4 5…

A: Even when the concentration of BSA (Bovine Serum Albumin) is 0 , an absorbance of 0.158 was…

Q: How much liquid media should you put in your dilution blank if you wanted to serially dilute a1 ml…

A: Serial dilution of the original sample containing microorganisms to achieve countable colonies on…

Q: You are observing the results from a standard plate count and you observe 53 CFUS. To make the plate…

A: The correct answer is option (4) 5.3 x 105 CFU/ml CFU/ml stands for colony-forming units per…

Q: show the complete solution and write answers in 3 significant figures. DYE CALCULATED Rf Tartrazine…

A: Introduction The retention factor (Rf) of a particular compound is the ratio of the distance the…

Q: The plate with 45 colonies was inocculated with 100 µL Volume of a 10^-8 Dilution. Given the formula…

A: Original cell density (OCD) can be found using the number of colonies of colony-forming units,…

Q: how to calculate the experiment fow rate for this gel chromatography Experiment flow rate ? Flow…

A: Given Values: Total volume eluted out of the gel filtration column = 15 ml The time taken in seconds…

Q: With reference to Table 2, what was the total extract volume in mL? Enter a number (no decimal…

A: In cells, there are thousands of distinct proteins. Extraction and purification of these substances…

Q: You obtained the following raw data when setting up a Biuret standard curve: BSA (mg/ml) Absorbancy…

A: The Biuret test is used to find the amount of protein in the given analyte as it checks the presence…

Q: add 2.75 mL out of 5.0 mL of an undiluted sample to 125.25 mL. ad, you add all 5.0 mL to the 125.25…

A: We should we the formula to solve this question: Dilution factor = Final volume of the…

Q: how did you accurately get the volume for the three sample problems (COPD, NORMAL, and fibrosis)?

A: Lungs are essential parts of the respiratory system. A pair of lungs in humans are formed in such a…

Question

If you had a cell suspension of 2.5 x 10^4 cells/mL and plated 100uL into each well (4 wells), how many cells were added per well?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, biology and related others by exploring similar questions and additional content below.

Similar questions

If 400 mL of a 20% w/v solution were diluted to 2 L, what would be the finalpercentage strength?
If the 10-9 plate was counted to have 155 colonies on it, would the CFU/mL be 1.55*1011? If not, what would it be?
if you are following a protocol requiring to use 200,000 cells, how much of the suspendion that contains 500,000 cells per ml shoud you use?
How many mL of 10 x stock solution would you need to make 118 mL of 1x PBS? Report your answer to 1 decimal place.
With reference to Table 2, what was the total extract volume in mL? Enter a number (no decimal places)
You want to dilute a sample by 1/3. For a final volume of 27 ml, how much sample would you add to how much liquid media?
The plate with 45 colonies was inocculated with 100 µL Volume of a 10^-8 Dilution. Given the formula OCD = CFU/V x D, what as the Original Colony Density?
You record the absorbance of your unknown BSA sample at 0.276. What is the concentration in ug/mL of the unknown assuming you have a standard curve with the line of best fit with y=0.0001x+0.0038 as its equation
A.How much of 10,000x SYBR safe would you add to 50 ml to make a final concentration of 1x? B.How will you set up the serial dilution? How many tubes do you need? What is the concentration in each? How much LB will you add to each tube? What volume of cells will you add?
You want to set up a 1:10 dilution series, so that you can plate a 10-1, 10-2, and a 10-3dilution; however, you only have access to two9 ml dilution blanks. Explain how you could accomplish this task with only two blanks.
If there are 103 cells per mL at the middle of log phase, andthe generation time of the cells is 30 minutes, how many cellswill there be 2 hours later?a) 2 x 103b) 4 x 103c) 8 x 103d) 1.6 x 104e) 1 x 107
If you have a stock vial of an antibiotic with a concentration of 450 mg/mL, but the antibiotic is to be administered at 90 μg/mL in a total volume of 10cc, diagram/describe how you would do this?