Concept explainers
Visible-Light Curing in Dentistry
An essential part of modern dentistry is visible-light curing (VLC), a procedure that hardens the restorative materials used in fillings, veneers, and other applications. These “curing lights" work by activating molecules known as photoinitiators within the restorative materials The photoinitiators, in turn, start a process of
Figure 25-50
An intense beam of light cures or hardens, the restorative material used to fill a cavity. (Problems 109, 110,111, and 112)
The most common photo initiator is camphoroquinone (CPQ). To cure CPQ in the least time, one should illuminate it with
More recently, VLC units have begun to use LEDs as their light source These lights stay cool, emit nearly all of their energy output as visible light at the desired wavelength, and provide light with an intensity as high as 1000 mW/cm2, which is about 10 times the intensity of sunlight on the surface of the Earth.
111 • How much
- A. 6.67 × 10−8 N/m2
- B. 2.00 × 10−6 N/m2
- C. 1.33 × 10−5 N/m2
- D. 4 03 × 103 N/mM2
Want to see the full answer?
Check out a sample textbook solutionChapter 25 Solutions
Physics (5th Edition)
Additional Science Textbook Solutions
Tutorials in Introductory Physics
Conceptual Physical Science (6th Edition)
The Cosmic Perspective
Lecture- Tutorials for Introductory Astronomy
College Physics
College Physics: A Strategic Approach (3rd Edition)
- (a) What is me ratio of the speed of red light to violet light in diamond, based on Table 25.2? (b) What is this ratio in polystyrene? (c) Which is more dispersive?arrow_forwardConstruct Your Own Problem Consider a space sail such as mentioned in Example 29.5 Construct a problem in which you calculate the light pressure on the sail in N/m2 produced by reflecting sunlight. Also calculate the force that could be produced and how much effect that would have on a spacecraft. Among the things to be considered are the intensity of sunlight, its average wavelength, the number of photons per square meter this implies, the area of the space sail, and the mass of the system being accelerated.arrow_forwardIntegrated Concepts (a) During laser vision correction, at brief burst at 193 nm ultraviolet light is projected onto the cornea of the patient. It makes a spot 1.00 mm in diameter and deposits 0.500 mJ of energy. Calculate the depth of the layer ablated, assuming the corneal tissue has the same properties as water and is initially at 34.0°C. The tissue’s temperature is increased to 100°C and evaporated without further temperature increase. (b) Does your answer imply that the shape of the cornea can be ?nely controlled?arrow_forward
- Integrated Concepts (a) On a day when the intensity of sunlight is 1.00 kW/m2, a circular lens 0.200 m in diameter focuses light onto water in a black beaker. Two polarizing sheets of plastic are placed in front of the lens with their axes at an angle of 20.0°. Assuming the sunlight is un-polarized and the polarizers are 100% efficient, what is the initial rate of heating of the water in °C/s, assuming it is 80.0% absorbed? The aluminum beaker has a mass of 30.0 grams and contains 250 grams of water. (b) Do the polarizing filters get hot? Explain.arrow_forwardDo the photons of red light produce better resolution in a microscope than blue light photons? Explain.arrow_forwardConstruct Your Own Problem Consider a spectrometer based on a diffraction grating. Construct a problem in which you calculate the distance between two wavelengths of electromagnetic radiation in your spectrometer. Among the things to be considered are the wavelengths you wish to be able to distinguish, the number of lines per meter on the diffraction grating, and the distance from the grating to the screen or detector. Discuss the practicality of the device in terms of being able to discern between wavelengths of interest.arrow_forward
- Youngs double-slit experiment underlies the instrument landing system used to guide aircraft to sale landings at some airports when the visibility is pool. Although real systems are more complicated than the example described here, they operate on the same principles. A pilot is trying to align her plane with a runway as suggested in Figure P37.22. Two radio antennas (the black dots in the figure) are positioned adjacent to the runway, separated by d = 40.0 m. The antennas broadcast unmodulated coherent radio waves at .10.0 MHz. The red lines in Figure P37.22 represent paths along which maxima in the interference pattern of the radio waves exist. (a) Find the wavelength of the waves. The pilot locks onto the strong signal radiated along an interference maximum and steers the plane to keep the received signal strong. If she has found the central maximum, the plane will have precisely the correct heading to land when it reaches the runway as exhibited by plane A. (b) What If? Suppose the plane is living along the first side maximum instead as is the case for plane B. How far to the side of the runway centerline will the plane be when it is 2.00 km from the antennas, measured along its direction of travel? (c) It is possible to tell the pilot that she is on the wrong maximum by sending out two signals from each antenna and equipping the aircraft with a two-channel receiver. The ratio of the two frequencies must not be the ratio of small integers (such as 34). Explain how this two-frequency system would work and why it would not necessarily work if the frequencies were related by an integer ratio.arrow_forwardOxygenated hemoglobin absorbs weakly in the red (hence its red color) and strongly in the near infrared, whereas deoxygenated hemoglobin has the opposite absorption. This fact is used in a pulse oximeter to measure oxygen saturation in arterial blood. The device clips onto the end of a persons finger and has two light-emitting diodesa red (660. nm) and an infrared (940. nm)and a photocell that detects the amount of light transmitted through the linger at each wavelength. (a) Determine the frequency of each of these light sources. (b) If 67% of the energy of the red source is absorbed in the blood, by what factor does the amplitude of the electromagnetic wave change? Hint: The intensity of the wave is equal to the average power per unit area as given by Equation 21.28.arrow_forwardYou use a sequence of ideal polarizing niters, each with its axis making the same angle with the axis of the previous filter, to rotate the plane of' polarization of a polarized light beam by a total of 45.0. You wish to have an intensity reduction no larger than 10.0%. (a) How many polarizers do you need to achieve your goal? (b) What is the angle between adjacent polarizers?arrow_forward
- A pure red object on a black background seems to disappear when illuminated with pure green light. Explain why.arrow_forwardWhat type of experimental evidence indicates that light is a wave?arrow_forwardIntegrated Concepts Suppose you put on two pairs of Polaroid sunglasses with their axes at an angle of 15.0°. How much longer will it take the light to deposit a given amount of energy in your eye compared with a single pair of sunglasses? Assume the lenses are clear except for their polarizing characteristics.arrow_forward
- Physics for Scientists and Engineers with Modern ...PhysicsISBN:9781337553292Author:Raymond A. Serway, John W. JewettPublisher:Cengage LearningPhysics for Scientists and EngineersPhysicsISBN:9781337553278Author:Raymond A. Serway, John W. JewettPublisher:Cengage LearningPrinciples of Physics: A Calculus-Based TextPhysicsISBN:9781133104261Author:Raymond A. Serway, John W. JewettPublisher:Cengage Learning
- Physics for Scientists and Engineers, Technology ...PhysicsISBN:9781305116399Author:Raymond A. Serway, John W. JewettPublisher:Cengage LearningCollege PhysicsPhysicsISBN:9781305952300Author:Raymond A. Serway, Chris VuillePublisher:Cengage LearningCollege PhysicsPhysicsISBN:9781285737027Author:Raymond A. Serway, Chris VuillePublisher:Cengage Learning