HEATING, VENTILATING,+AC ANAL...EBOOK>I<
6th Edition
ISBN: 2819480255750
Author: Mcquiston
Publisher: INTER WILE
expand_more
expand_more
format_list_bulleted
Videos
Textbook Question
Chapter 3, Problem 3.36P
A building has a total heating load of 200,000 Btu/hr. The sensible heat factor for the space is 0.8 and the space is to be maintained at 72 F db and 30 percent relative humidity. Outdoor air at 40 F db and 20 percent relative humidity in the amount of 1000 cfm is required. Air is supplied to the space at 120 F db. Water vapor with enthalpy of 1150 Btu/lbma is used to humidify the air. Find (a) the conditions and amount of air supplied to the space, (b) the temperature rise of the air through the furnace, (c) the amount of water vapor required, and (d) the capacity of the furnace. Assume sea-level pressure.
Expert Solution & Answer
Want to see the full answer?
Check out a sample textbook solution
Students have asked these similar questions
A space is to be maintained at 22C and 50% relative humidity. The sensible heat load is 100 kW, and the latent heat load is 15 kW. Outside air is at 38C DB and 25C WB temp. Air is supplied to the space at 13C. If all-outside air system (no recirculation) is to be implemented, determine: (a) the cooling capacity in tons; (b) capacity of supply air fan in cmh; and (c) the coil bypass factor.
The cooling load calculations on a theatre show that at design conditions the sensible heat load is 200 kw and the latent heat load is 70 kw. The indoor design conditions are 26°C dry bulb and50% relative humidity. Air is to be supplied to the theatre at 16°C while the outside airis at 30°C dry bulb and 60% relative humidity. Take ventilating air as 25% of the supply air. Calculate the tons of refrigeration required by the conditioner.
room contains air at 30 degrees * C and a total pressure of 96.0 kPa with a relative humidity of 75 percen ermine (a) the partial pressure of dry air and (b) the specific humidity.
Chapter 3 Solutions
HEATING, VENTILATING,+AC ANAL...EBOOK>I<
Ch. 3 - A space is at a temperature of 75 F (24 C), and...Ch. 3 - Determine the humidity ratio, enthalpy, and...Ch. 3 - Suppose the air of Problem 3-2 is at a pressure...Ch. 3 - What is the enthalpy of moist air at 70 F (20 C)...Ch. 3 - The inside surface temperature of a window in a...Ch. 3 - What is the mass flow rate of dry air flowing at a...Ch. 3 - Determine the dew point of moist air at 80 F (27...Ch. 3 - A room is to be maintained at 72 F (22 C) db. It...Ch. 3 - Air is cooled from 80 F db and 67 F wb until it is...Ch. 3 - Conditions in a room are measured to be 80 F db...
Ch. 3 - The environmental conditions in a room are to be...Ch. 3 - Air enters a cooling coil at the rate of 5000 cfm...Ch. 3 - Air flowing in a duct has dry and wet bulb...Ch. 3 - Air is humidified with the dry bulb temperature...Ch. 3 - Air at 38 C db and 20 C wb is humidified...Ch. 3 - Two thousand cfm (1.0 m3/s) of air at an initial...Ch. 3 - Air at 40 F (5 C) db and 35 F (2 C) wb is mixed...Ch. 3 - Rework Problem 3-25, using Chart 1a, with the...Ch. 3 - The design cooling load for a zone in a building...Ch. 3 - Assume that the air in Problem 3-22 is supplied to...Ch. 3 - The sensible heat loss from a space is 500,000...Ch. 3 - Air enters a refrigeration coil at 90 Fdb and 75...Ch. 3 - A building has a total heating load of 200,000...Ch. 3 - Reconsider Problem 3-36 for an elevation of 5000...Ch. 3 - The system of Problem 3-34 has a supply air fan...Ch. 3 - An evaporative cooling system is to be used to...Ch. 3 - A cooling system is being designed for use at high...Ch. 3 - Consider a space heating system designed as shown...Ch. 3 - A variable-air-volume VAV cooling system is a type...Ch. 3 - Rework Problem 3-43 for an elevation of 5000 feet...Ch. 3 - The design condition for a space is 77 F (25 C) db...Ch. 3 - Rework Problem 3-45 for an elevation of 5000 feet...Ch. 3 - It is necessary to cool and dehumidify air from 80...Ch. 3 - Conditions in one zone of a dual-duct conditioning...Ch. 3 - Rework Problem 3-48 for an elevation of 5000 ft...Ch. 3 - A water coil in Problem 3-48 cools return air to...Ch. 3 - A multizone air handler provides air to several...Ch. 3 - Under normal operating conditions a zone has a...Ch. 3 - An interior zone of a large building is designed...Ch. 3 - Outdoor air is mixed with room return air to...Ch. 3 - Consider an enclosed swimming pool. The pool area...Ch. 3 - One particular zone served by a multizone air...Ch. 3 - A research building requires 100 percent outdoor...Ch. 3 - A space requires cooling in the amount of 120,000...
Additional Engineering Textbook Solutions
Find more solutions based on key concepts
Compute points on the velocity profile from the pipe wall to the centerline of a 2 -in Schedule 40 steel pipe i...
Applied Fluid Mechanics (7th Edition)
Determine the resultant of the two forces and express the result as a Cartesian vector.
Engineering Mechanics: Statics
A force F of magnitude 800 lb is applied to point C of the bar AB as shown. Determine both the x-y and the n-t ...
Engineering Mechanics: Statics
Water in piston/cylinder (Fig. P3.111) is a 101kPa, 25°C, and mass 0.5 kg. The piston rests on some stops, and ...
Fundamentals Of Thermodynamics
Resolve the component force F1 into its x and y components, F1x and F1y . Resolve the component force F2 into i...
Engineering Mechanics: Statics & Dynamics (14th Edition)
Three rigid bodies, 2,3, and 4, are connected by four springs as shown in the figure. A horizontal force of 1,0...
Introduction To Finite Element Analysis And Design
Knowledge Booster
Learn more about
Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.Similar questions
- Moist air at 32 degrees Cdb and relative humidity of 60% enter a refrigeration system with a flow rate of 90 kg/min. Saturated air at 15 degrees Cdb leaves the system. Calculate the heat and moisture removed in kW and kg/s respectively.arrow_forwardwhich of the following properties is NOT true about moist air at standard condition which is at a dry bulb temperature of 340C and humidity ratio of 10g w/kg da ? 1. the relative humidity of the air is about 30% 2. The enthalpy of the air is about 55kj/kg 3.The specific volume of the air is about 0.884 m3/kg 4.The dew point temperature of the air is about 140Carrow_forwardIn an attempt to conserve water and to be awarded LEED (Leadership in Energy and Environmental Design) certification, a 20,000-liter cistern has been installed during construction of a new building. The cistern collects water from an HVAC (heating, ventilation, and air-conditioning) system designed to provide 2830 cubic meters of air per minute at 22°C and 50% relative humidity after converting it from ambient conditions (31°C, 70% relative humidity). The collected condensate serves as the source of water for lawn maintenance. Estimate (a) the rate of intake of air at ambient conditions in cubic feet per minute and (b) the hours of operation required to fill the cistern.arrow_forward
- A space is to be maintained at 75 F db and 40% relative humidity. The total heat gain to the space is 62,000 Btu/hr with a SHF of 0.8. The outdoor air requirement is 500 cfm. The outdoor air has a temperature of 90 F and 50% relative humidity. Assume that the supply air has a temperature of 50 F db. Determine the following: a. Quantity of supplied air b. Capacity of the cooling coil c. Rate of moisture removal from the dehumidification elementarrow_forwardAn air conditioning system, shown schematically below, supplies air at the rate of 4 kg/s to a space maintained at a db-temperature of 27°C and relative humidity of 50%. The sensible and latent heat loads on the space are 46 kW and 20 kW respectively. Outdoor air at 35°C db-temperature and 24°C wb-temperature is introduced at the rate of 1.1 kg/s. The relative humidity of the air leaving the cooling coil is 90%. The pressure is constant at 101.3 kPa. Determine:the supply air temperature in °Cthe supply air relative humidity in %the mass flow rate of the air that bypasses the cooling coil in kg/sthe refrigeration capacity of the cooling coil in kWarrow_forwardIs it possible that during sensible cooling process the condition of air reaches a relative humidity of more than 100%.arrow_forward
- Air at 0° C and 95% relative humidity has to be heated and humidified to 25° C and 40% relative humidity by the following three processes: (a) preheating; (b) adiabatic saturation in a recirculated water air-washer; and (c) reheating to final state. Calculate: 1. The heating required in two heaters; 2. The makeup water required in washer and temperature of washer. Assume effectiveness of washer as 80 per centarrow_forwardAn auditorium is to be maintained at a temperature of 24°C dry bulb and 18°C wet bulb temperatures. The sensible heat load is 67kW and 49 kg per hour or moisture must be removed. Air is supplied to the auditorium at 19°C. Determine (a) the relative humidity at condition 1 and 2 (b) the mass flow rate of supply air, (c) the enthalpy and specific volume of condition 1 and 2, (d) the sensible heat ratio.arrow_forwardA room contains 50 kg of dry air and 0.8 kg of water vapor at 25°C and 1 atm total pressure. The relative humidity of air in the room is vaplanmadı Lütfen birini seçin: inden miş а. 35% ju işaretle b. 60% C. 55% d. 80% e. 75% Sonraki sayfaarrow_forward
- An air conditioned space is to be supplied with 300 cmm of air at 20°C dry bulb and 40% relative humidity. Unconditioned air from atmosphere at 32°C dry bulb and 28°C dew point is supplied to the dehumidifier coils, from where the same passes on to a heating coil before entering the conditioned space. Determine the cooling required. Solve the problem both from first principles and with Psychrometric chart.arrow_forwardA sample of moist air with a volume of 3.5 m3 has a dry bulb temperature of 40°C and a relative humidity of 50%. The total pressure is 90 kPa. -Calculate the humidity ratio in kg/kg-The degree of saturation in %-The specific volume in m3 per kg-The mass in kg-The enthalpy in kJ/kgarrow_forwardCalculate (a) the humidity of air at a temperature of 65 deg C and 42% RH, and (b) compare the value from the Psychrometric Chart.arrow_forward
arrow_back_ios
SEE MORE QUESTIONS
arrow_forward_ios
Recommended textbooks for you
Elements Of ElectromagneticsMechanical EngineeringISBN:9780190698614Author:Sadiku, Matthew N. O.Publisher:Oxford University Press
Mechanics of Materials (10th Edition)Mechanical EngineeringISBN:9780134319650Author:Russell C. HibbelerPublisher:PEARSON
Thermodynamics: An Engineering ApproachMechanical EngineeringISBN:9781259822674Author:Yunus A. Cengel Dr., Michael A. BolesPublisher:McGraw-Hill Education
Control Systems EngineeringMechanical EngineeringISBN:9781118170519Author:Norman S. NisePublisher:WILEY
Mechanics of Materials (MindTap Course List)Mechanical EngineeringISBN:9781337093347Author:Barry J. Goodno, James M. GerePublisher:Cengage Learning
Engineering Mechanics: StaticsMechanical EngineeringISBN:9781118807330Author:James L. Meriam, L. G. Kraige, J. N. BoltonPublisher:WILEY
Elements Of Electromagnetics
Mechanical Engineering
ISBN:9780190698614
Author:Sadiku, Matthew N. O.
Publisher:Oxford University Press
Mechanics of Materials (10th Edition)
Mechanical Engineering
ISBN:9780134319650
Author:Russell C. Hibbeler
Publisher:PEARSON
Thermodynamics: An Engineering Approach
Mechanical Engineering
ISBN:9781259822674
Author:Yunus A. Cengel Dr., Michael A. Boles
Publisher:McGraw-Hill Education
Control Systems Engineering
Mechanical Engineering
ISBN:9781118170519
Author:Norman S. Nise
Publisher:WILEY
Mechanics of Materials (MindTap Course List)
Mechanical Engineering
ISBN:9781337093347
Author:Barry J. Goodno, James M. Gere
Publisher:Cengage Learning
Engineering Mechanics: Statics
Mechanical Engineering
ISBN:9781118807330
Author:James L. Meriam, L. G. Kraige, J. N. Bolton
Publisher:WILEY
The Refrigeration Cycle Explained - The Four Major Components; Author: HVAC Know It All;https://www.youtube.com/watch?v=zfciSvOZDUY;License: Standard YouTube License, CC-BY