Automotive Technology: A Systems Approach (MindTap Course List)
6th Edition
ISBN: 9781133612315
Author: Jack Erjavec, Rob Thompson
Publisher: Cengage Learning
expand_more
expand_more
format_list_bulleted
Textbook Question
Chapter 34, Problem 12RQ
As a catalytic converter begins to deteriorate, the signal from the postcatalyst HO2S becomes
the signal of the precatalyst HO2 S.
a. shorter than
b. more like
c. larger than
d. flatter than
Expert Solution & Answer
Want to see the full answer?
Check out a sample textbook solutionStudents have asked these similar questions
While discussing fuel boiling in the fuel rail: Technician A says that fuel boiling in the fuel rail causes a lean air-fuel ratio. Technician B says that the computer will compensate for the improper air-fuel ratio caused by fuel boiling in the fuel rail. Who is correct?
the goverment mandated warranty that specifically covers the catalytic converter and engine control module is the
Explain steps involved in disconnecting a fuel line on a vehicle with multiport fuel injaction and gasoline direct injection ?
Chapter 34 Solutions
Automotive Technology: A Systems Approach (MindTap Course List)
Ch. 34 - A rich air-fuel ratio causes HC emissions to...Ch. 34 - What will result from too little EGR flow? And...Ch. 34 - What can result from a charcoal canister that is...Ch. 34 - What happens if a PCV valve is stuck in the open...Ch. 34 - Explain why the I/M 240 and similar tests are...Ch. 34 - How do you test the efficiency of a secondary AIR...Ch. 34 - True or False? No-start, surging, or stalling can...Ch. 34 - List five common causes for high HC emissions.Ch. 34 - Describe carbon monoxide (CO) emissions in...Ch. 34 - A restricted catalytic converter can cause all of...
Ch. 34 - Which of the following statements about EVAP...Ch. 34 - As a catalytic converter begins to deteriorate,...Ch. 34 - How much pressure does a typical EVAP pressure...Ch. 34 - Which of the following exhaust gases is typically...Ch. 34 - Prob. 15RQCh. 34 - While discussing the proper way to test a...Ch. 34 - Prob. 2ASRQCh. 34 - While discussing catalytic converter diagnosis:...Ch. 34 - While discussing EGR valve diagnosis: Technician A...Ch. 34 - While discussing EGR valve diagnosis: Technician A...Ch. 34 - When discussing the diagnosis of a positive back...Ch. 34 - While diagnosing a PCV problem: Technician A says...Ch. 34 - Technician A says that the AIR system should pump...Ch. 34 - While discussing PCV system diagnosis: Technician...Ch. 34 - While discussing EVAP testing: Technician A says...
Knowledge Booster
Learn more about
Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.Similar questions
- A restricted catalytic converter can cause all of the following except. a. stalling after the engine starts b. popping or backfiring through the intake manifold c. a drop in engine vacuum d. increased power at high speedsarrow_forwardWhile discussing the catalyst efficiency monitor: Technician A says that if the catalytic converter is not reducing emissions properly, the voltage frequency increases on the downstream HO2S. Technician B says that if a fault occurs in the catalyst monitor system on three drive cycles, the MIL will be illuminated. Who is correct? Technician A Technician B Both A and B Neither A nor Barrow_forwardDescribe how a selective catalytic reduction system works.arrow_forward
- technician A says lean ratio of 15:1 to 16:1 provide the best fuel economy. technician B says rich mixture have a ratio below 14.7:1 and provide more power from the engine but greater fuel combustion. who is correct?arrow_forwardWhat is meant by abnormal combustionarrow_forwardWhile discussing electronic fuel injection principles: Technician A says that the PCM always adjusts the air-fuel ratio in response to the O2S signals. Technician B says that cold air is dense, which is why the PCM enriches the mixture when the engine is cold. Who is correct?arrow_forward
- Please use the air standerd analysis instead of the cold air standerd analysisarrow_forwardWhat is meant by sequential firing of fuel injectors?arrow_forwardExplain the steps involved in disconnecting a fuel line on a vehicle with: Multiport fuel injection (50 - 60 words) Gasoline Direct Iniection (30 - 40 words)arrow_forward
- Explain with details (a) Exhaust gas recirculation (b) Charge cooling.arrow_forwardTechnician A says that gasoline can be used as a source of hydrogen for a fuel cell. Technician B says that carbon dioxide can be used as a source of hydrogen for a fuel cell. Who is correct?arrow_forwardWhich of the following statements about fuel trim is not true? a. A positive fuel trim value means that the PCM detects a lean mixture and is decreasing the pulse width to add more fuel to the mixture. b. Short-term fuel trim represents changes made immediately in response to HO2S signals. c. Long-term fuel trim represents changes made to set a new base pulse width. d. Long-term fuel trim responds to the trends of the short-term fuel trim.arrow_forward
arrow_back_ios
SEE MORE QUESTIONS
arrow_forward_ios
Recommended textbooks for you
- Automotive Technology: A Systems Approach (MindTa...Mechanical EngineeringISBN:9781133612315Author:Jack Erjavec, Rob ThompsonPublisher:Cengage LearningAutomotive TechnologyMechanical EngineeringISBN:9781337794213Author:ERJAVEC, Jack.Publisher:Cengage,
Automotive Technology: A Systems Approach (MindTa...
Mechanical Engineering
ISBN:9781133612315
Author:Jack Erjavec, Rob Thompson
Publisher:Cengage Learning
Automotive Technology
Mechanical Engineering
ISBN:9781337794213
Author:ERJAVEC, Jack.
Publisher:Cengage,
The Refrigeration Cycle Explained - The Four Major Components; Author: HVAC Know It All;https://www.youtube.com/watch?v=zfciSvOZDUY;License: Standard YouTube License, CC-BY