LABORATORY TECHNIQUES IN ORGANIC CHEMIS
4th Edition
ISBN: 2819260096009
Author: Mohrig
Publisher: MPS PUB
expand_more
expand_more
format_list_bulleted
Question
Chapter 5, Problem 3Q
Interpretation Introduction
Interpretation:
The good way to measure the transfer of
Concept introduction:
The measurement of the volume of the liquids that are transferred can be done by different measuring equipment used in the laboratory such as beakers, pipets and graduated cylinders. The use of equipment to measure the specific volume mainly depends upon the accuracy of the volume needed to be known. Some equipment provides an approximate measurement of the volume like beaker while some equipment provides exact or more accurate measurements like graduated pipets.
Expert Solution & Answer
Want to see the full answer?
Check out a sample textbook solution
Students have asked these similar questions
1. What is the MW of the analyte?2. What is the meq of the analyte?3. What will be the weight (in grams) of the analyte if the standardization is to be quartered?4. What will be Normality of the solution if 7.5ml of the titrant was consumed in the standardization?5. What is the average Normality if two or more trials were conducted with the values of 0.102N and 0.105N?
A 2.0 g of MgCO, was dissolved and diluted to exactly 500-mL volumetric
flask. If 50-mL aliquot was used in the analysis, what is the weight of
MgCO; present in the aliquot sample.
A student was tasked to perform gravimetric analysis of a soluble sulfate. His unknown sample weighed 0.7543 g. The sample underwentprecipitation using BaCl2 and was digested for overnight. The precipitate was then filtered off to obtain white crystalline precipitate that was collected inan ash less filter paper. In performing constant weighing, he obtained a crucible mass that is 29.9442 g. After burning his samples inside the crucible,the obtained mass was 30.3375 g.
Compute for the theoretical % SO3 obtained by the student and the theoretical mass (g) of SO3 that should be obtained by the student using his weighed sample
Chapter 5 Solutions
LABORATORY TECHNIQUES IN ORGANIC CHEMIS
Knowledge Booster
Similar questions
- A student was tasked to perform gravimetric analysis of a soluble sulfate. His unknown sample weighed 0.7543 g. The sample underwentprecipitation using BaCl2 and was digested for overnight. The precipitate was then filtered off to obtain white crystalline precipitate that was collected inan ash less filter paper. In performing constant weighing, he obtained a crucible mass that is 29.9442 g. After burning his samples inside the crucible,the obtained mass was 30.3375 g.29. Compute for the mass (g) of BaSO4 from the experiment.A) 0.3933B) 0.3393C) 0.3133D) 0.3951E) 0.359130. Compute for the experimental mass (g) of SO3 in grams obtained by the student.A) 0.1439B) 0.1349C) 0.1943D) 0.1394E) 0.359131. Compute for the experimental % SO3 obtained by the student.A) 73.21B) 56.33C) 17.89D) 56.89E) 72.8032. Compute for the theoretical % SO3 obtained by the studentA) 0.3933B) 56.37C) 17.33D) 17.89E) 0.425233. Compute for the theoretical mass (g) of SO3 that should be obtained by the student…arrow_forwardPlease help me find weight percentage of the unknown solution, Thank you in advance Data attached below: Data of unknown NaCl solution (by weight) weight of weighing bottle and solution: 34.91g weight of weighing bottle: 23.91g weight of the solution: 11.00g Initial buret reading 33.28ml Final buret reading: 43.26ml The volume of the solution; 9.98 ml The density of solution: 1.10 Weight % of unknow solution: ?arrow_forward5) If all the NaHCO3 in bag 2 reacted, calculate the number of moles of gas produced? tates) E Focusarrow_forward
- Weigh accurately 4.0 g of sodium chloride into a 250cm3 volumetric flask. Using a wash bottle add about 200cm3 of distilled water. Stopper the flask. Shake vigorously for three minutes. Remove the stopper for a second then continue to shake for about another two minutes until all the solid has dissolved. Add more water slowly upto exactly the 250 cm3 mark. 1.Calculate the number of moles of sodium chloride present in: (i) 4.0 g (ii) 250 cm3 solution in the volumetric flask. (iii) one decimeter of solutionarrow_forwardA 0.2653 g of pure potassium dichromate was dissolved in 15 mL of 1.5 M sulfuric acid and transferred to a 250.0 mL volumetric flask and diluted to the mark with distilled water. A 25.0 mL aliquot of this solution was transferred to another 250.0 mL volumetric flask and diluted to the mark with distilled water and this solution has an absorbance 0f 0.387 in a 2.00 cm cell. Calculate the molar absorptivity of potassium dichromate.arrow_forwardHow was the precipitate obtained after filtration? (A By scraping from the filter paper and transferring to a watch glass. B By charring the filter paper and igniting the product in a crucible. By drying the precipitate on the filter paper using a desiccator. D By redissolving in hydrochloric acid.arrow_forward
- 5.00 mL of stock solution is diluted to 25.00 mL, producing solution ALPHA. 10.00 mL of solution ALPHA is diluted to 25.00 mL, resulting in solution BETA. 10.00 mL of solution BETA is then diluted to 25.00 mL, producing solution GAMMA. dilution factor for ALPHA from stock solution = 0.167 dilution factor for BETA from ALPHA solution = 0.0476 part c and d?arrow_forwardGeneral, Organic and Biochemistry - Laboratory Manual 3. a) How would you record the following volume measurement on a burette shown in the picture using rules of significant figures? 07 . mL V= b) If the burette was used to dispense a certain amount of solution, and the new volume reading is shown in the picture below, what volume of the solution was dispensed? Use rules of significantfigures and showyour work! 9FD 11 AHUA 12 /0 09/W0 1 #11 mL Vdispensed 1 Show work: DNH UO 61 10 mearrow_forwardWhy is it improper to fill a volumetric flask to the calibrated mark with solvent BEFORE adding the solute?arrow_forward
- Show your solutions properly with the stoichiometric ratios and units. a) What is the molarity of 100.0 ml lactic acid solution that is prepared by taking 10.0 ml from stock lactic acid solution labelled with following information? Label of stock solution: MW of lactic acid: 90.08 g/mol, 85% (w/w), d: 1.21 g/mL. b) What is the concentration of Na* in ppm that is 0.050 M in Na¿CO3? Assume that the density of this solution is 1.0 g/mL (Na: 22.9897 g/mol, Na2CO3: 105.988 g/mol).arrow_forwardUsing the concepts of volumetry, classify statements as true or false. Justify the one(s) that you judge to be “false”. a) Constant weight is to repeat the entire analytical procedure, until 2 consecutive measurements of the scales vary in mass up to 0.002 g b) The nickel dimethylglyoximate precipitate is of the true crystalline type c) Gravimetric factor is the relationship between the mass of starting material and the mass of the product d) In direct determination, volatilization gravimetry, the volatilized sample is collected on a certain (previously determined) mass of appropriate adsorbent material (silica, alumina) and weighed up.arrow_forwarda) convert 0.750 moles of CuCl2 to mass in grams. b) 25cm3 of sodium hydroxide solution of unknown concentration was filtrated with dilute sulphuric acide of concentration of 0.050 moldm-3 . 20cm3 was required to neturalie the sodiu hydroxide. calculate the concentration of the sodium hydroxide solution in moldm-3 nb. write the balanced equation use mole ratio to covert moles of sulphuric acid to moles of sodium hydroxide place moles in volume given cm3 then convert cm3 to dm3arrow_forward
arrow_back_ios
SEE MORE QUESTIONS
arrow_forward_ios
Recommended textbooks for you
ChemistryChemistryISBN:9781305957404Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCostePublisher:Cengage Learning
ChemistryChemistryISBN:9781259911156Author:Raymond Chang Dr., Jason Overby ProfessorPublisher:McGraw-Hill Education
Principles of Instrumental AnalysisChemistryISBN:9781305577213Author:Douglas A. Skoog, F. James Holler, Stanley R. CrouchPublisher:Cengage Learning
Organic ChemistryChemistryISBN:9780078021558Author:Janice Gorzynski Smith Dr.Publisher:McGraw-Hill Education
Chemistry: Principles and ReactionsChemistryISBN:9781305079373Author:William L. Masterton, Cecile N. HurleyPublisher:Cengage Learning
Elementary Principles of Chemical Processes, Bind...ChemistryISBN:9781118431221Author:Richard M. Felder, Ronald W. Rousseau, Lisa G. BullardPublisher:WILEY
Chemistry
Chemistry
ISBN:9781305957404
Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste
Publisher:Cengage Learning
Chemistry
Chemistry
ISBN:9781259911156
Author:Raymond Chang Dr., Jason Overby Professor
Publisher:McGraw-Hill Education
Principles of Instrumental Analysis
Chemistry
ISBN:9781305577213
Author:Douglas A. Skoog, F. James Holler, Stanley R. Crouch
Publisher:Cengage Learning
Organic Chemistry
Chemistry
ISBN:9780078021558
Author:Janice Gorzynski Smith Dr.
Publisher:McGraw-Hill Education
Chemistry: Principles and Reactions
Chemistry
ISBN:9781305079373
Author:William L. Masterton, Cecile N. Hurley
Publisher:Cengage Learning
Elementary Principles of Chemical Processes, Bind...
Chemistry
ISBN:9781118431221
Author:Richard M. Felder, Ronald W. Rousseau, Lisa G. Bullard
Publisher:WILEY