Interpretation:
The conclusion about the homogeneity of the distillate in the fractional distillation of ethanol-water mixture should be determined. Also, whether the mixture has a constant boiling point or not and is pure compound or not is to be determined.
Concept introduction:
The fractional distillation is a technique that is used to separate various components or fractions from a mixture on the basis of their volatilities. The fractional distillation can be used if the boiling point difference between the components is less than
A mixture with uniform composition and properties throughout is called homogenous mixture.
Want to see the full answer?
Check out a sample textbook solutionChapter 5 Solutions
Macroscale and Microscale Organic Experiments
- Fractional distillation of a binary mixture leaves behind a liquid consisting of both components. The composition of this liquid does not change as it is boiled. Provide an explanation for this observation.arrow_forwardExplain the importance of using a thermometer in the simple distillation setup. Enumerate the characteristics of a substance for it to be separated from the heterogeneous mixture by steam distillation. How does steam facilitate the distillation of essential oils? Discuss some applications of simple distillation and steam distillation. Explain why you can use each method for the chosen application. What is the most dominant intermolecular forces of attraction that exist between: a. water and limonene, the major monoterpene component of lemon essential oil? b. water and constituent ions of sodium chloride? 6. Based on your answers in number 5, which pair (water-limonene or water-sodium chloride) exhibits a stronger attraction between their molecules/ions? 7. Describe what happens during the salting-out process in terms of the intermolecular forces of attraction involved as mentioned in your previous answers.arrow_forwardWhat characteristics must a substance possess for it to be separated from a heterogeneous mixture by steam distillation?arrow_forward
- An ethanol/water mixture forms an azeotropic mixture. Why is it not possible to obtain a pure sample of ethanol from the mixture by fractional distillation? How would you obtain pure ethanol from the azeotropic mixture?arrow_forwardPure potassium hydrogen phthalate is used for the standardization of the sodium hydroxide solution. Suppose that the potassium hydrogen phthalate is not completely dry. Will the reported molar concentration of the sodium hydroxide solution be too high, too low, or unaffected because of the moistness of the potassium hydrogen phthalate? Explain.arrow_forwardWhy is fractional distillation more efficient than simple distillation when purifying liquid mixtures?arrow_forward
- A student obtained a solid product in laboratory synthesis. To verify the identity of the solid, she measured the milting point and found that the material melted over a 12°C range. After it had cooled, she measured the melting point of the same sample again and found that this time the solid HUD a sharp melting point at the temperature that is characteristic of the desired product Why were the two melting points different? What was responsible for the change in the melting point?arrow_forwardBriefly explain the principles involved in the separation of the components of a mixture by solvent extraction.arrow_forwardDefine eutectic point. For a binary ( two.component ) mixture of solid organic compoundsarrow_forward
- physical chemistry: With the given diagram below, How many phases does a mixture of these liquids have? Liquid Amount (mol) xT xW xE A 15 0.5 0.25 0.25 B 20 0.33 0.33 0.33 C 7.5 0.1 0.8 0.1 For the mixture in the problem above, what are the composition of the phases? If there are two phases, what are the compositions of the trichloromethane-rich and water-rich phases?arrow_forwardSketch the solid-liquid phase diagram of 2,6-xylenol and tert-butanol. Pure tert-butanol has a melting point of 297 K and pure t-butanol has a melting point of 318 K. The lowest melting point of the solid without changing composition is 252 K and occurs when the mole fraction of t-butanol is 0.75.arrow_forward7.5. For this chemical equilibrium in an enclosed system, how many degrees of freedom are there?arrow_forward
- Macroscale and Microscale Organic ExperimentsChemistryISBN:9781305577190Author:Kenneth L. Williamson, Katherine M. MastersPublisher:Brooks ColeEBK A SMALL SCALE APPROACH TO ORGANIC LChemistryISBN:9781305446021Author:LampmanPublisher:CENGAGE LEARNING - CONSIGNMENTPhysical ChemistryChemistryISBN:9781133958437Author:Ball, David W. (david Warren), BAER, TomasPublisher:Wadsworth Cengage Learning,