Applied Fluid Mechanics
7th Edition
ISBN: 9780133414622
Author: UNTENER
Publisher: YUZU
expand_more
expand_more
format_list_bulleted
Textbook Question
Chapter 5, Problem 5.69PP
A scuba diver with wet suit, tank, and gear has a mass of
Expert Solution & Answer
Want to see the full answer?
Check out a sample textbook solutionStudents have asked these similar questions
a scuba diver with, tank, and gear has a mass of 78 Kg. The diver and gear displace a total volumen of 82.5 L of sea water. The diver would like to add enough lead weights to become neutrally buoyant for a dive. How much lead (sg=11.35) should be added to tthe weight belt to achieve neutral buoyancy?
The density of a floating body can be determined by tying weights to the body until both the body and the weights are completely submerged, and then weighing them separately in air. Consider a wood log that weighs 1400 N in air. If it takes 34 kg of lead (? = 11,300 kg/m3) to completely sink the log and the lead in water, determine the average density of the log.
Balloons are often filled with helium gas because it weighs only about one-seventh of what air weighs under identical conditions. The buoyancy force, which can be expressed as Fb = ? airgVballoon, will push the balloon upward. If the balloon has a diameter of 12 m and carries two people, 70 kg each, determine the acceleration of the balloon when it is first released. Assume the density of air is ? =1.16kg/m3, and neglect the weight of the ropes and the cage
Chapter 5 Solutions
Applied Fluid Mechanics
Ch. 5 - The instrument package shown in Fig. 5.18 weighs...Ch. 5 - A 1.0 -m-diameter hollow sphere weighing 200 N is...Ch. 5 - A certain standard steel pipe has an outside...Ch. 5 - A cylindrical float has a 10 -in diameter and is...Ch. 5 - A buoy is a solid cylinder 0.3 m in diameter and...Ch. 5 - A float to be used as a level indicator is being...Ch. 5 - A concrete block with a specific weight of...Ch. 5 - Figure 5.19shows a pump partially submerged in oil...Ch. 5 - A steel cube 100mm on a side weighs 80N. We want...Ch. 5 - A cylindrical drum is 2 ft in diameter, 3 ft long,...
Ch. 5 - If the aluminum weights described in Problem 5.10...Ch. 5 - Figure 5.20 shows a cube floating in a fluid....Ch. 5 - A hydrometer is a device for indicating the...Ch. 5 - For the hydrometer designed in Problem 5.13 what...Ch. 5 - For the hydrometer designed in Problem 5.13 , what...Ch. 5 - A buoy is to support a cone-shaped instrument...Ch. 5 - A cube has side dimensions of 18.00 in. It is made...Ch. 5 - A cube has side dimensions of 18.00 in. It is made...Ch. 5 - A ship has a mass of 292 Mg. Compute the volume of...Ch. 5 - An iceberg has a specific weight of 8.72kN/m3....Ch. 5 - A cylindrical log has a diameter of 450 mm and a...Ch. 5 - The cylinder shown in Fig. 5.23 is made from a...Ch. 5 - If the cylinder from Problem 5.22 is placed in...Ch. 5 - A brass weight is to be attached to the bottom of...Ch. 5 - For the cylinder with the added brass (described...Ch. 5 - For the composite cylinder shown in Fig. 5.25 what...Ch. 5 - A vessel for a special experiment has a hollow...Ch. 5 - A light foam cup similar to a disposable coffee...Ch. 5 - A light foam cup similar to a disposable coffee...Ch. 5 - Repeat Problem 5.29, but consider that the steel...Ch. 5 - Figure 5.27 shows a raft made of four hollow drums...Ch. 5 - Figure 5.28 shows the construction of the platform...Ch. 5 - For the raft shown in Fig. 5.27, how much of the...Ch. 5 - For the raft and platform shown in Figs. 5.27 and...Ch. 5 - A float in an ocean harbor is made from a uniform...Ch. 5 - Describe how the situation described in Problem...Ch. 5 - A cube 6.00 in on a side is made from aluminum...Ch. 5 - Prob. 5.38PPCh. 5 - A cylindrical block of wood is 1.00 m in diameter...Ch. 5 - A container for an emergency beacon is a...Ch. 5 - The large platform shown in Fig. 5.29 carries...Ch. 5 - Will the cylindrical float described in Problem...Ch. 5 - Will the buoy described in Problem 5.5 be stable...Ch. 5 - Will the float described in Problem 5.6 be stable...Ch. 5 - A closed, hollow, empty drum has a diameter of...Ch. 5 - Figure 5.30 shows a river scow used to carry bulk...Ch. 5 - Prob. 5.47PPCh. 5 - For the vessel shown in Fig. 5.26and described in...Ch. 5 - For the foam cup described in Problem 5.28, will...Ch. 5 - Referring to Problem 5.29, assume that the steel...Ch. 5 - Referring to Problem 5.30, assume that the steel...Ch. 5 - Prob. 5.52PPCh. 5 - Will the cylinder together with the brass plate...Ch. 5 - A proposed design for a part of a seawall consists...Ch. 5 - A platform is being designed to support some water...Ch. 5 - Prob. 5.56PPCh. 5 - A barge is 60 ft long, 20 ft wide, and 8 ft deep....Ch. 5 - If the barge in Problem 5.57 is loaded with 240000...Ch. 5 - A piece of cork having a specific weight of...Ch. 5 - Figure 5.20 shows a cube floating in a fluid, (a)...Ch. 5 - A boat is shown in Fig. 5.33(a). Its geometry at...Ch. 5 - (a) If the cone shown in Fig. 5.34 is made of pine...Ch. 5 - Refer to Fig. 5.35. The vessel shown is to be used...Ch. 5 - Prob. 5.64PPCh. 5 - Wetsuits are prohibited in some triathlons due to...Ch. 5 - A cylinder that is 500 mm in diameter and 2.0 m...Ch. 5 - The diving bell shown in Fig. 5.2 weighs 72 kN and...Ch. 5 - Prob. 5.68PPCh. 5 - A scuba diver with wet suit, tank, and gear has a...Ch. 5 - Prob. 5.70PPCh. 5 - Does steel float? It has a specific gravity of...Ch. 5 - Prob. 5.72PPCh. 5 - An undersea camera (Figure 5.36 ) is to hang from...Ch. 5 - Work Problem 5.73 again, but this time the camera...Ch. 5 - Write a program for evaluating the stability of a...Ch. 5 - For any cylinder of a uniform density floating in...Ch. 5 - For the results found in Project 2, compute the...Ch. 5 - Write a program for evaluating the stability of a...Ch. 5 - Write a program for determining the stability of a...
Knowledge Booster
Learn more about
Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.Similar questions
- One side of the container has a 03-m square door that is hinged at its top edge. If the container is filled with water, determine the smallest force F that must be applied to the bottom edge of the door to keep it closed.arrow_forwardThe test tube opens at 293 K with 15 cm Hg at the bottom, and 7.5 cm of water above the Hg. Calculate the pressure at the bottom of the tube if the atmospheric pressure is 760 mm Hg. Use the density of 13:55 g / cm3 for Hg and 0998 g / cm3 to air.Berikan answers in terms of dyne / cm2,psia, and kN / m2 • (see conversion table). a. … KPa. b. … Dyne / cm2. c. … Psia.arrow_forwardA hydraulic cylinder filled with water has an inside diameter of 1.0 in and a length of 2.0 ft. How many pounds of force must be applied to a piston at the end of the cylinder to compress the water by 0.1 in? Take the bulk modulus of water to be K=312,000 psi.arrow_forward
- Assuming specific weight of air to be constant at 12 N/m3, what is the approximate height of a Mountain if mercurybarometer at the base of the mountains reads 645 mm and at the same time another mercury barometer at the top of the mountains reads 480 mm?arrow_forward1.) In which situation must you do more work: inflating a balloon at sea level or inflating the same balloon to the same volume at the summit of Mt. Pulag? Explain in terms of pressure and volume change.arrow_forward120 L of hydraulic oil have a mass of 110 kg. For the oil, calculate the Specific Weight, γ (kN/m3). (Hint: first calculate the Density). Group of answer choices 8.99 kN/m3 8.55 kN/m3 9.05 kN/m3 9.17 kN/m3 10.1 kN/m3arrow_forward
- A diver’s watch resists an absolute pressure of 5.5 bar. At an ocean having density of 1025 kg/m3 and exposing an atmospheric pressure of 1 bar, what depth can maximally the diver dive to prevent water inlet into his watch? 1 bar = 105 Pa and g = 9.81 m/s2.arrow_forwardIf a scuba diver descends too quickly into the sea, the internal pressure on each eardrum remains at atmospheric pressure, while the external pressure increases due to the increased water depth. At sufficient depths, the difference between the external and internal pressures can rupture an eardrum. Eardrums can rupture when the pressure difference is as little as 35 kPa. What is the depth at which this pressure difference could occur? The density of seawater is 1025 kg/m3. 1)sketch (include everything in the system) 2)solution(step by step)arrow_forwardBalloons are often filled with helium gas because it weighs only about one-seventh of what air weighs under identical conditions. The buoyancy force, which can be expressed as Fb = ? airgVballoon, will push the balloon upward. If the balloon has a diameter of 12 m and carries two people, 70 kg each Using appropriate software, investigate the effect of the number of people carried in the balloon on acceleration. Plot the acceleration against the number of people, and discuss the results Assume the density of air is ? =1.16kg/m3, and neglect the weight of the ropes and the cagearrow_forward
- Balloons are often filled with helium gas because it weighs only about one-seventh of what air weighs under identical conditions. The buoyancy force, which can be expressed as Fb = ρairgVballoon, will push the balloon upward. If the balloon has a diameter of 12 m and carries two people, 85 kg each, determine the acceleration of the balloon when it is first released. Assume the density of air is ρ = 1.16 kg/m3 , and neglect the weight of the ropes and the cage.arrow_forwardDiscuss the resultant hydrostatic force acting on a submerged surface and the center of pressure. Why do the forces acting on a surface vary when the surface is tilted or in a vertical position?arrow_forwardA spherical balloon containing Oxygen (initially at sea level) has a radius of 8 inches. If the uniform density of air is 0.07498lb/ft3 and that the pressure at sea level is 14.7psia, determine the new radius (inch) of the balloon if it has been brought above sea level by 6000ft.arrow_forward
arrow_back_ios
SEE MORE QUESTIONS
arrow_forward_ios
Recommended textbooks for you
- International Edition---engineering Mechanics: St...Mechanical EngineeringISBN:9781305501607Author:Andrew Pytel And Jaan KiusalaasPublisher:CENGAGE L
International Edition---engineering Mechanics: St...
Mechanical Engineering
ISBN:9781305501607
Author:Andrew Pytel And Jaan Kiusalaas
Publisher:CENGAGE L
Physics 33 - Fluid Statics (1 of 10) Pressure in a Fluid; Author: Michel van Biezen;https://www.youtube.com/watch?v=mzjlAla3H1Q;License: Standard YouTube License, CC-BY