(a)
Interpretation:
The balanced equation for the given reaction should be given.
Concept introduction:
The reduction and oxidation reactions are occur simultaneously with in a single reaction is known as redox reaction.
The unbalanced charge (electron) and atoms (ions) in the equation of redox reactions are commonly balanced by half reaction method.
In this method, the given redox reaction is separated by two half reactions, one is oxidation and another one is reduction.
The medium of the reaction is used to balance the Hydrogen and Oxygen ions in the half cell reactions.
Balancing of redox reaction in acid medium:
In the acid medium, the addition of
Charge is balanced by addition of electron in the sides with the greater positive charge.
Balancing of redox reaction in basic medium:
In the basic medium, the addition of
(b)
Interpretation:
The number of moles of oxide were formed, and number of moles of semimetal were in the initial
Concept Introduction:
Precipitation reaction:
If precipitate is formed, when two soluble salt solutions are combined together is known as precipitation reaction.
Mole:
Mole of the compound present in the solution is calculated by molarity concentration of the compound multiplied with litre volume of solution.
Mass:
Mass of the compound is calculated by mole of the compound is multiplied with molar mass of the compound.
Mass percent:
The mass percent of analyte in give sample is given by below equation,
(c)
Interpretation:
The semimetal should be determined.
Concept Introduction:
Precipitation reaction:
If precipitate is formed, when two soluble salt solutions are combined together is known as precipitation reaction.
Mole:
Mole of the compound present in the solution is calculated by molarity concentration of the compound multiplied with litre volume of solution.
Mass:
Mass of the compound is calculated by mole of the compound is multiplied with molar mass of the compound.
Mass percent:
The mass percent of analyte in give sample is given by below equation,
Want to see the full answer?
Check out a sample textbook solutionChapter 7 Solutions
General Chemistry: Atoms First
- 1. Sometimes a reaction can fall in more than one category. Into what category (or categories) does the reaction of Ba(OH)2(aq) + H+PO4(aq) fit? acid-base and oxidation-reduction oxidation-reduction acid-base and precipitation precipitationarrow_forwardTriiodide ions are generated in solution by the following (unbalanced) reaction in acidic solution: IO3(aq) + I(aq) I3(aq) Triiodide ion concentration is determined by titration with a sodium thiosulfate (Na2S2O3) solution. The products are iodide ion and tetrathionate ion (S4O6). a. Balance the equation for the reaction of IO3 with I ions. b. A sample of 0.6013 g of potassium iodate was dissolved in water. Hydrochloric acid and solid potassium iodide were then added. What is the minimum mass of solid KI and the minimum volume of 3.00 M HQ required to convert all of the IO3 ions to I ions? c. Write and balance the equation for the reaction of S2O32 with I3 in acidic solution. d. A 25.00-mL sample of a 0.0100 M solution of KIO. is reacted with an excess of KI. It requires 32.04 mL of Na2S2O3 solution to titrate the I3 ions present. What is the molarity of the Na2S2O3 solution? e. How would you prepare 500.0 mL of the KIO3 solution in part d using solid KIO3?arrow_forwardWrite balanced net ionic equations for the following reactions in acid solution. (a) Liquid hydrazine reacts with an aqueous solution of sodium bromate. Nitrogen gas and bromide ions are formed. (b) Solid phosphorus (P4) reacts with an aqueous solution of nitrate to form nitrogen oxide gas and dihydrogen phosphate (H2PO4-) ions. (c) Aqueous solutions of potassium sulfite and potassium permanganate react. Sulfate and manganese(II) ions are formed.arrow_forward
- A 1.345-g sample of a compound of barium and oxygen was dissolved in hydrochloric acid to give a solution of barium ion, which was then precipitated with an excess of potassium chromate to give 2.012 g of barium chromate, BaCrO4. What is the formula of the compound?arrow_forwardCalcium in blood or urine can be determined by precipitation as calcium oxalate, CaC2O4. The precipitate is dissolved in strong acid and titrated with potassium permanganate. The equation for reaction is 2MnO4(aq)+6H+(aq)+5H2C2O4(aq)2Mn2+(aq)+10CO2(g)+8H2O A 24-hour urine sample is collected from an adult patient, reduced to a small volume, and titrated with 26.2 mL of 0.0946 M KMnO4. How many grams of calcium oxalate are in the sample? Normal range for Ca2+ output for an adult is 100 to 300 mg per 24 hour. Is the sample within the normal range?arrow_forwardThe active ingredients of an antacid tablet contained only magnesium hydroxide and aluminum hydroxide. Complete neutralization of a sample of the active ingredients required 48.5 mL of 0.187 M hydrochloric acid. The chloride salts from this neutralization were obtained by evaporation of the filtrate from the titration; they weighed 0. 4200 g. What was the percentage by mass of magnesium hydroxide in the active ingredients of the antacid tablet?arrow_forward
- A solution of hydrogen peroxide, H2O2, is titrated with a solution of potassium permanganate, KMnO4. The reaction is 5H2O2(aq)+2KMnO4(aq)+3H2SO4(aq)5O2(g)+2MnSO4(aq)+K2SO4(aq)+8H2O(l) It requires 51.7 mL of 0.145 M KMnO4 to titrate 20.0 g of the solution of hydrogen peroxide. What is the mass percentage of H2O2 in the solution?arrow_forwardChlorisondamine chloride (C14H20Cl6N2) is a drug used in the treatment of hypertension. A 1.28-g sample of a medication containing the drug was treated to destroy the organic material and to release all the chlorine as chloride ion. When the filtered solution containing chloride ion was treated with an excess of silver nitrate, 0.104 g silver chloride was recovered. Calculate the mass percent of chlorisondamine chloride in the medication, assuming the drug is the only source of chloride.arrow_forwardThe exposed electrodes of a light bulb are placed in a solution of H2SO4 in an electrical circuit such that the light bulb is glowing. You add a dilute salt solution, and the bulb dims. Which of the following could be the salt in the solution? a. Ba(NO3)2 b. NaNO3 c. K2SO4 d. Ca(NO3)2 Justify your choices. For those you did not choose, explain why they are incorrect.arrow_forward
- Chemistry: Principles and ReactionsChemistryISBN:9781305079373Author:William L. Masterton, Cecile N. HurleyPublisher:Cengage LearningChemistry & Chemical ReactivityChemistryISBN:9781133949640Author:John C. Kotz, Paul M. Treichel, John Townsend, David TreichelPublisher:Cengage LearningGeneral Chemistry - Standalone book (MindTap Cour...ChemistryISBN:9781305580343Author:Steven D. Gammon, Ebbing, Darrell Ebbing, Steven D., Darrell; Gammon, Darrell Ebbing; Steven D. Gammon, Darrell D.; Gammon, Ebbing; Steven D. Gammon; DarrellPublisher:Cengage Learning
- Chemistry & Chemical ReactivityChemistryISBN:9781337399074Author:John C. Kotz, Paul M. Treichel, John Townsend, David TreichelPublisher:Cengage LearningChemistryChemistryISBN:9781305957404Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCostePublisher:Cengage Learning