Analysis of Oil-in-Water deposit" which is related to oil spill

Q: How JAR test is performed in lab? And what is its significance?

A: JAR test is an important test performed in laboratory. It is used to select and quantify a treatment…

Q: In a normal phase chromatography setup, which would be the predicted characteristics of the eluates…

A: A normal phase chromatography involves a stationary phase and a mobile phase.  It is an adsorptive…

Q: Was your average experimental mass percent of oxygen in potassium chlorate higher or lower than the…

A: One mol KClO3 contain 3 mol of oxygen and 1 mol of K and 1 mol of Cl Molecular mass of KClO3 = 122.5…

Q: What information should the INTRODUCTION section of a chemistry lab report contain? Select all that…

A: Given :  What information should the introduction section of a chemistry lab report contain ?

Q: 2. Propose three types of procedural error that may impact the results that were experimentally…

A: Answer. Errors generally occur while conducting experiments which can effect our results but with…

Q: Refer to the diagram. During analysis the carrier gas travels      a. through the flow controller,…

A:

Q: Materials and detailed methods:  paragraph or two explain how the experiment was done  Raw Data:…

A: Diels -Alder reaction takes place in reactions between conjugated diene and an alkene. In this…

Q: Which of the following best describes the application of flow analysis? O a Asample is injected into…

A: The flow injection method was developed by Ruzicka and Hansen in Denmark in the mid-1970. This is a…

Q: Example: A GC-FID analysis was conducted on a soil sample containing pollutant X. The following…

A: Answer -

Q: David is in dilemma to choose a suitable chromatographic detector for gas chromatography analysis.…

A: The detector which detects the pesticide content in vegetables has to be given and the two…

Q: What do you call the type of analytical method that relies on the absolute stoichiometric…

A: There are several analytical methods are used to determine the concentration of analytes .

Q: from one of our neigboring countries are heavily contaminated with pesticides. Upon analysis, some…

A: WORKING OF SOLID PHASE MICROEXTRACTION :

Q: Match the terms with their definitions: 1. Adsorption chromatography 2. Partition chromatography 3.…

A:

Q: A wipe sample of Tc-99m and Cs-137 were counted in the well counter, both recorded 1,000 cpm.…

A: A wipe sample emits radioactive particles that is counted by the particle counter.  The efficiency…

Q: Time required to elute substance Z when N = 1000 = when N = 2000 The two quantities cannot be…

A: Given,       Time required to elute a substance Z     When  N = 1000   and N = 2000   Required,…

Q: Create a schematic diagram for this experiment procedures   • Make an improvised weighing dish for…

A: The solution of the question is given below:

Q: be micro a

A: Electron probe microanalyzer is an analytical tool used to determine the chemical composition of…

Q: . Describe volumetric quantitative analytical methods.

A: In chemistry, there are many ways to check the deviation of experimental data from the accurate…

Q: Explain two separation techniques how may be feasible for H2O vs Ethanol. One can be an industrial…

A: Separating alcohol from water may be done in a number of different ways. Heating the mixed liquid is…

Q: High-pressure ATR is used to analyze very hard sample.  True  False

A: Attenuated total reflection (ATR) spectroscopy is an analysis technique that utilizes the surface of…

Q: One of the following is not one of the Minimization of errors. Internal standard method O الاختيارات…

A: Here we have to find which option is not correct I.e. one of them is not one of the minimization of…

Q: How are analytes usually recovered after SFC or SFE?

A: Step 1 of 1 SFE is supercritical fluid extraction, in which components in a mixture are…

Q: Compute for the initial dilution of tube #1 and final dilution of tube #5.

A: It contains 0.9 mL of saline and 0.1 mL of serum. Total volume = 1 mL So, we have 0.1 mL of serum in…

Q: 5. On the report sheet, you calculated your percent recovery of caffeine. a. If your percent was…

A:

Q: Why is it not necessary to test the supernatant from both trial samples for the excess reactant is…

A: In step 9, BaCl2 is added to test tube 1, and Na3PO4 is added to test tube 2. Precipitation occurs…

Q: In analytical chemistry, when and why do we do representative sampling? How can you apply this…

A: A question based on analytical chemistry, which is to be accomplished.

Q: The labware we used in Quant Lab is divided into “qualitative” or “quantitative” analytical purpose.…

A: The glassware used in the lab are divided into 2 types that is qualitative and quantitative. As it…

Q: Kinetic Data Collection Time, t (s) Volume of added base (mL) Flrst additlon 40 0.50 Second addition…

A: Given: Concentration of NaOH stock solution = 0.01 M Concentration of t-BuCl stock solution = 0.2 M…

Q: Chemistry Am I suppose to have a straight line in a standard addition plot? Specifically, I am…

A: In the field of analytical chemistry, the standard addition method is one of the most famous…

Q: Organic solvents may be used together with plastic cuvettes if the analysis will be conducted within…

A: A question based on absorption that is to be accomplished.

Q: create a scatter plot using the concentration and absorbance data for your methylene blue standards…

A: A question based tools in analytical chemistry that is to be accomplished.

Q: During the course of an analysis for a solid sample, a loss of 0.40 mg occurs. Calculate the…

A: Relative error is defined as the ratio of absolute error to the true value. Here, Absolute error =…

Q: What does it mean for two solvents to be immiscible?

A: The above questions are regarding the extraction of caffeine . Caffeine is a natural chemical…

Q: A balance high readability is necessarily equated to high accuracy. Select one: a. True b. False…

A:

Q: What is the retention factor of a sample when after injectiion the void time (tM) took 4.18 sec? The…

A:

Q: please answer and explain 3a in terms easy to understand. thank you.

A: Hydrated salts have water within their crystals when the crystals are formed from water; an…

Q: The fluid exiting a chromatographic column is called the eluent eluate analyte solvent Question 22…

A: Chromatography is the laboratory method to separate the components of a mixture.  Elution is the…

Q: Task: You are a forensic analyst employed at the Baltimore County Forensic Lab. You plan to perform…

A: answer - The mobile phase is generally a mixture of non-polar organic solvent, while the stationary…

Q: Left graph is column A; Right graph column B. 0.006 012 0.10 O ON 004 0.001 0.02 00 02 04 0.6 1.0 20…

A: A question based on analytical separations that is to be accomplished.

Q: Reason why a reference material must be analysed side by side with the sample in in DSC analysis

A: Differential Scanning colorimetry (DSC) is a technique to determine the temperature and heat flow…

Q: Would the concentration of OH– in the solutions used for Runs 2–4 be different if deionized water…

A: The main difference between the deionized water and the NaCl solution is the lacking of ion in…

Q: A fly ash (ƿ = 1.8 g mL-1) aerosol consists of particles averaging 13 µm in diameter and with a…

A:

Q: The separation occurs on a thin film of the immobilized solid support surface of liquid stationary…

A: Chromatography is defined as the technique in which there is the separation of mixture into…

Q: Prepare a procedural flow chart that provides a simplified overview of the entire extraction…

A: The procedural flow chat of extraction process is explained in step 2.

Q: A sample of explosives residue is dissolved in an appropriate solvent and is injected into HPLC. The…

A: Introduction: Chromatography is a technique used to separate the mixture if solution. There are two…

Q: The progress of a hypothetical reaction: A + B C+DE, was monitored using paper chromatography.…

A:

Q: SERIAL DILUTION: PROBLEM SOLVING. Set up five (5) tubes on the test tube rack and label them 1-5.…

A: Let us consider the serum concentration to be a M

Q: What is the advantage of microwave ashing and microwave digestion in sample preparation prior…

A: These both methods are the advanced methods to which the sample is subjected prior instrumental…

Q: CHEM 1111 Molar Mass of Butane Data Sheet These tables and all work for calculations are to be…

A: