Automotive Technology: A Systems Approach - With Manual and Access
6th Edition
ISBN: 9781305513235
Author: ERJAVEC
Publisher: Cengage
expand_more
expand_more
format_list_bulleted
Textbook Question
Chapter 10, Problem 13RQ
Why should a memory saver be installed before dis connecting a vehicles battery?
Expert Solution & Answer
Want to see the full answer?
Check out a sample textbook solutionStudents have asked these similar questions
The EWB system relies on the vehicle's battery for power but what if the vehicle battery fails ?
What is indicated by a reading of battery voltage on the ground side of a component?
true or False? The computer in most late-model vehicles must undergo a relearn or initialization procedure after the vehicle's battery has been disconnected and reconnected?
Chapter 10 Solutions
Automotive Technology: A Systems Approach - With Manual and Access
Ch. 10 - WHat should be worn when working with any type of...Ch. 10 - Prob. 2RQCh. 10 - What is the best way to lift a vehicle when...Ch. 10 - True or False? The first step in removing an...Ch. 10 - Prob. 5RQCh. 10 - The buildup of minerals and deposits inside the...Ch. 10 - Hydrocarbon solvents are. flammable toxic both a...Ch. 10 - Prob. 8RQCh. 10 - Which cleaning method uses high-frequency sound...Ch. 10 - Parts must be when they go into an abrasive blast...
Ch. 10 - Prob. 11RQCh. 10 - Which of the following is not considered part of...Ch. 10 - Why should a memory saver be installed before dis...Ch. 10 - Which of the following statements is not true...Ch. 10 - Which of the following is not a common way to...Ch. 10 - While working on an engine with an excessive...Ch. 10 - While discussing the common causes for cracks...Ch. 10 - Technician A uses a crane to remove an engine from...Ch. 10 - Prob. 4ASRQCh. 10 - While discussing abrasive cleaners: Technician A...Ch. 10 - Technician A labels or marks all electrical wires...Ch. 10 - While discussing cleaning engine parts: Technician...Ch. 10 - While loosening the axle shaft hub nuts on a FWD...Ch. 10 - While preparing to remove an engine: Technician A...Ch. 10 - After removing the vehicles hood in preparation...
Knowledge Booster
Learn more about
Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.Similar questions
- While discussing inductive charging technician a says most current begs use this system because it's safe technician b says this method requires that a weatherproof paddle be inserted into the vehicles charge port who is correct?arrow_forwardTrue or False? The air bag diagnostic monitor supplies back-up power to the air bag module in the event that the battery or cables are damaged during the accident.arrow_forwardList five things a driver of a BEV can do to extend the driving range of the vehicle.arrow_forward
- Technician A says battery warranties are often prorated. Technician B says most prorated warranties have a deductible. Who is correct? Technician A Technician B Both A and B Neither A nor Barrow_forwardWhich of the following is the least likely cause of a no-start condition? Faulty CKP sensor Faulty KS Fuel or ignition system faults Faulty PCM wiringarrow_forwardWhile discussing what is indicated by a vehicle’s charge indicator: Technician A says that any positive reading on an ammeter shows that the generator is in working condition. Technician B says that if the voltmeter reading does not increase immediately after starting the engine, the battery is bad. Who is correct? Technician A Technician B Both A and B Neither A nor Barrow_forward
- While discussing the MIL on OBD II systems: Technician A says that the MIL will flash if the PCM detects a fault that would damage the catalytic converter. Technician B says that whenever the PCM has detected a fault, it will turn on the MIL. Who is correct? a. Technician A • Technician B • Both A and B • Neither A nor Barrow_forwardIn addition to the battery, what does the charging system include?arrow_forwardBelow figure is an air-cooling system for the battery pack. Is this an Active or Passive air-cooling system? What are the main differences between Active and Passive air- cooling system? Cooling Fan Air Intake Air Exhaustarrow_forward
- What could be the problem when the vehicle’s domelight dims when a power seat is moved?arrow_forwardTechnician A fast charges a sulfated battery then reinstalls it in the vehicle. Technician B trickle charges a sulfated battery over 24 hours before reinstalling it. Who is correct? a. A only b. B only c. both A and B d. neither A nor Barrow_forwardTechnician A says that before a battery is removed, a memory' saver ought to be installed. Technician B says that before a battery is removed, the positive cable should be disconnected and the area around the battery should be cleaned. Who is correct? Technician A Technician B Both A and B Neither A nor Barrow_forward
arrow_back_ios
SEE MORE QUESTIONS
arrow_forward_ios
Recommended textbooks for you
- Automotive Technology: A Systems Approach (MindTa...Mechanical EngineeringISBN:9781133612315Author:Jack Erjavec, Rob ThompsonPublisher:Cengage LearningAutomotive TechnologyMechanical EngineeringISBN:9781337794213Author:ERJAVEC, Jack.Publisher:Cengage,
Automotive Technology: A Systems Approach (MindTa...
Mechanical Engineering
ISBN:9781133612315
Author:Jack Erjavec, Rob Thompson
Publisher:Cengage Learning
Automotive Technology
Mechanical Engineering
ISBN:9781337794213
Author:ERJAVEC, Jack.
Publisher:Cengage,
Mod-01 Lec-16 Basics of Instrumentation; Author: nptelhrd;https://www.youtube.com/watch?v=qbKnW42ZM5c;License: Standard YouTube License, CC-BY