Physics for Scientists and Engineers with Modern Physics
Physics for Scientists and Engineers with Modern Physics
10th Edition
ISBN: 9781337553292
Author: Raymond A. Serway, John W. Jewett
Publisher: Cengage Learning
bartleby

Concept explainers

bartleby

Videos

Textbook Question
Book Icon
Chapter 12, Problem 35AP

A uniform beam of mass m is inclined at an angle θ to the horizontal. Its upper end (point P) produces a 90° bend in a very rough rope tied to a wall, and its lower end rests on a rough floor (Fig. P12.35). Let μs represent the coefficient of static friction between beam and floor. Assume μs is less than the cotangent of θ. (a) Find an expression for the maximum mass M that can be suspended from the top before the beam slips. Determine (b) the magnitude of the reaction force at the floor and (c) the magnitude of the force exerted by the beam on the rope at P in terms of m, M, and μs.

Figure P12.35

Chapter 12, Problem 35AP, A uniform beam of mass m is inclined at an angle  to the horizontal. Its upper end (point P)

 (a)

Expert Solution
Check Mark
To determine

The expression for the maximum mass that can be suspended from the top surface before the beam starts slip.

Answer to Problem 35AP

The expression for the maximum mass that can be suspended from the top surface before the beam starts slip is 12m(2μssinθcosθcosθμssinθ) .

Explanation of Solution

Given information: The mass of the beam is m , inclination angle of the beam is θ , the coefficient of static friction between the beam and the floor is μs , and the μs is less than cotangent of θ .

The following figure shows the force diagram of the beam.

Physics for Scientists and Engineers with Modern Physics, Chapter 12, Problem 35AP

Figure-(I)

Formula to calculate the frictional force acting on the base of the beam is,

f=μsn

  • f is the frictional force acting on the base of the beam.
  • μs is the coefficient of static friction.
  • n is the normal force acting at point O .

Formula to calculate the net torque about the point O is,

mg(L2cosθ)+Mg(Lcosθ)T(Lsinθ)=0

  • m is the mass of the beam.
  • g is the acceleration due to gravity.
  • L is the length of the beam.
  • θ is the inclination angle of the beam with horizontal.
  • M is the mass hanged at the upper end of the beam.
  • T is the tension on the rope.

Rearrange the above equation to find T .

mg(L2cosθ)+Mg(Lcosθ)T(Lsinθ)=0T(Lsinθ)=mg(L2cosθ)+Mg(Lcosθ)T=mgcosθ2sinθ+Mgcosθsinθ

Formula to calculate the net vertical forces is,

Mg+mgn=0

Rearrange the above equation to find n .

Mg+mgn=0n=Mg+mg

Formula to calculate the net horizontal force is,

T=f

Substitute mgcosθ2sinθ+Mgcosθsinθ for T , μsn for f and Mg+mg for n in the above equation to find M .

(mgcosθ2sinθ+Mgcosθsinθ)=μs(Mg+mg)mcosθ2sinθ+Mcosθsinθ=μsM+mμsM(cosθsinθμs)=m(μscosθ2sinθ)M=m(μscosθ2sinθ)(cosθsinθμs)

Further simplify the above equation to find M .

M=m(μscosθ2sinθ)(cosθsinθμs)M=m2(2μssinθcosθ)(cosθμssinθ)

Conclusion:

Therefore, the expression for the maximum mass that can be suspended from the top surface before the beam starts slip is 12m(2μssinθcosθcosθμssinθ) .

(b)

Expert Solution
Check Mark
To determine

The magnitude of the reaction force at the floor.

Answer to Problem 35AP

The magnitude of the reaction force at the floor is (m+M)g1+μs2 .

Explanation of Solution

Given information: The mass of the beam is m , inclination angle of the beam is θ , the coefficient of static friction between the beam and the floor is μs , and the μs is less than cotangent of θ .

Formula to calculate the net reaction force acting in the floor is,

R=n2+f2

  • R is the reaction force at the floor.

Substitute Mg+mg for n and μsn for f in the above equation to find R .

R=(Mg+mg)2+(μs(Mg+mg))2=(Mg+mg)2(1+μs2)=(Mg+mg)(1+μs2)=g(m+M)1+μs2

Conclusion:

Therefore, the magnitude of the reaction force at the floor is (m+M)g1+μs2 .

(c)

Expert Solution
Check Mark
To determine

The magnitude of the force exerted by the beam in the rope at P .

Answer to Problem 35AP

The magnitude of the force exerted by the beam in the rope at P is gM2+μs2(m+M)2 .

Explanation of Solution

Given information: The mass of the beam is m , inclination angle of the beam is θ , the coefficient of static friction between the beam and the floor is μs , and the μs is less than cotangent of θ .

Since the coefficient of static friction of the floor is less than cotangent of the angle θ , thus,

fμsn

Substitute mgcosθ2sinθ+Mgcosθsinθ for f and Mg+mg for n in the above equation to find μs .

(mgcosθ2sinθ+Mgcosθsinθ)μs(Mg+mg)μs[M+m2M+m]cotθ

Formula to calculate the magnitude of the net force exerted by the beam in the rope at point P is,

F=T2+(Mg)2

  • F is the magnitude of the force exerted by the beam in the rope.

Substitute mgcosθ2sinθ+Mgcosθsinθ for T in the above equation to find F .

F=(mgcosθ2sinθ+Mgcosθsinθ)2+(Mg)2=(m2+M)2g2cot2θ+(Mg)2=g(m2+M)2cot2θ+M2=gM2+(m+M)2[(m2+Mm+M)cotθ]2

Substitute μs for [M+m2M+m]cotθ in the above equation to find F .

F=gM2+(m+M)2[(m2+Mm+M)cotθ]2=gM2+(m+M)2[μs]2=gM2μs2(m+M)2

Conclusion:

Therefore, the magnitude of the force exerted by the beam in the rope at P is gM2+μs2(m+M)2

Want to see more full solutions like this?

Subscribe now to access step-by-step solutions to millions of textbook problems written by subject matter experts!
Students have asked these similar questions
A uniform plank of length 2.00 m and mass 30.0 kg is supported by three ropes as indicated by the blue vectors in Figure P12.25. Find the tension in each rope when a 700-N person is d = 0.500 m from the left end.
A solid copper cube has an edge length of 86.9 cm. How much stress must be applied to the cube to reduce the edge length to 86 cm? The bulk modulus of copper is 1.4 x 1011 N/m2.
A solid copper cube has an edge length of 85.5 cm. How much stress must be applied to the cube to reduce the edge length to 85.0 cm? The bulk modulus of copper is 1.4*1011 N/m2.

Chapter 12 Solutions

Physics for Scientists and Engineers with Modern Physics

Ch. 12 - Prob. 7PCh. 12 - A uniform beam of length L and mass m shown in...Ch. 12 - A flexible chain weighing 40.0 N hangs between two...Ch. 12 - A 20.0-kg floodlight in a park is supported at the...Ch. 12 - Prob. 11PCh. 12 - Review. While Lost-a-Lot ponders his next move in...Ch. 12 - Figure P12.13 shows a claw hammer being used to...Ch. 12 - A 10.0-kg monkey climbs a uniform ladder with...Ch. 12 - John is pushing his daughter Rachel in a...Ch. 12 - Prob. 16PCh. 12 - The deepest point in the ocean is in the Mariana...Ch. 12 - A steel wire of diameter 1 mm can support a...Ch. 12 - A child slides across a floor in a pair of...Ch. 12 - Evaluate Youngs modulus for the material whose...Ch. 12 - Prob. 21PCh. 12 - When water freezes, it expands by about 9.00%....Ch. 12 - Review. A 30.0-kg hammer, moving with speed 20.0...Ch. 12 - A uniform beam resting on two pivots has a length...Ch. 12 - A bridge of length 50.0 m and mass 8.00 104 kg is...Ch. 12 - Prob. 26APCh. 12 - The lintel of prestressed reinforced concrete in...Ch. 12 - Prob. 28APCh. 12 - A hungry bear weighing 700 N walks out on a beam...Ch. 12 - Prob. 30APCh. 12 - A uniform sign of weight Fg and width 2L hangs...Ch. 12 - When a person stands on tiptoe on one foot (a...Ch. 12 - A 10 000-N shark is supported by a rope attached...Ch. 12 - Assume a person bends forward to lift a load with...Ch. 12 - A uniform beam of mass m is inclined at an angle ...Ch. 12 - Prob. 36APCh. 12 - When a circus performer performing on the rings...Ch. 12 - Figure P12.38 shows a light truss formed from...Ch. 12 - Prob. 39APCh. 12 - A stepladder of negligible weight is constructed...Ch. 12 - A stepladder of negligible weight is constructed...Ch. 12 - Review. A wire of length L, Youngs modulus Y, and...Ch. 12 - Two racquetballs, each having a mass of 170 g, are...Ch. 12 - Prob. 44APCh. 12 - Review. An aluminum wire is 0.850 m long and has a...Ch. 12 - You have been hired as an expert witness in a case...Ch. 12 - A 500-N uniform rectangular sign 4.00 m wide and...Ch. 12 - A steel cable 3.00 cm2 in cross-sectional area has...Ch. 12 - A uniform rod of weight Fg and length L is...Ch. 12 - In the What If? section of Example 12.2, let d...
Knowledge Booster
Background pattern image
Physics
Learn more about
Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.
Similar questions
SEE MORE QUESTIONS
Recommended textbooks for you
Text book image
Physics for Scientists and Engineers
Physics
ISBN:9781337553278
Author:Raymond A. Serway, John W. Jewett
Publisher:Cengage Learning
Text book image
Physics for Scientists and Engineers with Modern ...
Physics
ISBN:9781337553292
Author:Raymond A. Serway, John W. Jewett
Publisher:Cengage Learning
Text book image
Physics for Scientists and Engineers: Foundations...
Physics
ISBN:9781133939146
Author:Katz, Debora M.
Publisher:Cengage Learning
Text book image
Principles of Physics: A Calculus-Based Text
Physics
ISBN:9781133104261
Author:Raymond A. Serway, John W. Jewett
Publisher:Cengage Learning
SIMPLE HARMONIC MOTION (Physics Animation); Author: EarthPen;https://www.youtube.com/watch?v=XjkUcJkGd3Y;License: Standard YouTube License, CC-BY