Automotive Technology: A Systems Approach (MindTap Course List)
6th Edition
ISBN: 9781133612315
Author: Jack Erjavec, Rob Thompson
Publisher: Cengage Learning
expand_more
expand_more
format_list_bulleted
Videos
Textbook Question
Chapter 31, Problem 6RQ
Which of the following is a likely cause of a lean condition during acceleration and cruising speeds?
a. A defective oxygen sensor
b. A defective PCM
c. A defective ECT sensor
d. A defective MAF sensor
Expert Solution & Answer
Trending nowThis is a popular solution!
Students have asked these similar questions
Which of the following is not a voltage-generating type sensor?
vehicle speed sensor
OSS
MAP
ISS
Q 151. the activity of an O2 sensor is best monitered with a ______ .
a. scan tool
b. logic probe
c. noid light
d. lab scope
Describe the two basic types of passenger weightdetection sensors used in most vehicles
Chapter 31 Solutions
Automotive Technology: A Systems Approach (MindTap Course List)
Ch. 31 - List four service precautions for working on the...Ch. 31 - What is indicated by a LTFT reading of 24 percent?Ch. 31 - What is the correct procedure for checking an...Ch. 31 - What is the difference between STFT and LTFT?Ch. 31 - The PCM checks for a closed throttle plate each...Ch. 31 - Which of the following is a likely cause of a lean...Ch. 31 - What problem may result from dirt buildup on an...Ch. 31 - Which of the following would not cause a...Ch. 31 - What is the correct way to test an injector with...Ch. 31 - What is the difference between the pulse width and...
Ch. 31 - How can you use a dual trace scope to make sure...Ch. 31 - What are three possible problems that can allow...Ch. 31 - What is the purpose of having two accelerator...Ch. 31 - What is indicated by a negative LTFT value?Ch. 31 - True or False? The signals from an air-fuel ratio...Ch. 31 - While discussing the causes of...Ch. 31 - While discussing IAC valve diagnosis: Technician A...Ch. 31 - While discussing IAC motor removal, service, and...Ch. 31 - While discussing injector testing: Technician A...Ch. 31 - While discussing airflow sensors: Technician A...Ch. 31 - While discussing scan tool diagnosis of fuel...Ch. 31 - While discussing a high idle speed problem:...Ch. 31 - While discussing the causes of a rich air-fuel...Ch. 31 - While diagnosing an idle speed problem: Technician...Ch. 31 - While looking at fuel trim values: Technician A...
Knowledge Booster
Learn more about
Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.Similar questions
- True or False? An A/F ratio sensor can be tested in the same way as an oxygen sensor.arrow_forwardTrue or False? On some engines, if the gap between the crankshaft sensor and its trigger wheel is outside specifications, the sensor should be replaced.arrow_forwardA defective LAT sensor or circuit may cause the fol lowing problems, except. hard engine starting rich or lean air-fuel ratio improper converter clutch lockup reduced fuel economyarrow_forward
- Which of the following is the least likely cause of a no-start condition? Faulty CKP sensor Faulty KS Fuel or ignition system faults Faulty PCM wiringarrow_forwardWhen testing a frequency varying MAF: Technician A says that the frequency should increase with an increase in engine speed. Technician B says that when observed on a lab scope, the signal from the sensor should be a square wave. Who is correct? Technician A Technician B Both A and B Neither A nor Barrow_forwardWhich sensor is used for misfire monitoring on OBD II systems? Oxygen sensor Camshaft position sensor Crankshaft position sensor DPFE sensorarrow_forward
- When diagnosing a vacuum/mechanical cruise control system that cannot maintain a constant speed, all of the following should be checked, except. the brake switch the vacuum lines the vacuum servo the vehicle speed sensorarrow_forwardTechnician A says that EMI can affect sensor signals. Technician B says that EMI can cause intermittent driveability problems. Who is correct? Select one: a. Technician A b. Technician B c. Both A and B d. Neither A nor Barrow_forwardExplain the above : pressure sensor, pressure gauge and pressure transmitter with an applicationarrow_forward
- Explain the working of NDIR and chemical sensors of exhaust gas analyzersarrow_forwardWhile diagnosing a cruise control system that does not turn on: Technician A checks the vehicle speed sensor and its input to the control module. Technician B checks the operation of the brake lights. Who is correct? Technician A Technician B Both A and B Neither A nor Barrow_forwardTechnician A says that a faulty TP sensor can cause delayed shifts. Technician B says that delayed shifts can be caused by an open shift solenoid. Who is correct? a. Technician A only b. Technician B only c. Both A and B d. Neither A nor Barrow_forward
arrow_back_ios
SEE MORE QUESTIONS
arrow_forward_ios
Recommended textbooks for you
Automotive TechnologyMechanical EngineeringISBN:9781337794213Author:ERJAVEC, Jack.Publisher:Cengage,
Automotive Technology: A Systems Approach (MindTa...Mechanical EngineeringISBN:9781133612315Author:Jack Erjavec, Rob ThompsonPublisher:Cengage Learning
Automotive Technology
Mechanical Engineering
ISBN:9781337794213
Author:ERJAVEC, Jack.
Publisher:Cengage,
Automotive Technology: A Systems Approach (MindTa...
Mechanical Engineering
ISBN:9781133612315
Author:Jack Erjavec, Rob Thompson
Publisher:Cengage Learning
Mod-01 Lec-16 Basics of Instrumentation; Author: nptelhrd;https://www.youtube.com/watch?v=qbKnW42ZM5c;License: Standard YouTube License, CC-BY