Concept explainers
Construct Your Own Problem
Consider a method for measuring the mass of a person's arm in anatomical studies. The subject lies on her back, extends her relaxed arm to the side and two scales are placed below the arm. One is placed under the elbow and the other under the back of her hand. Construct a problem in which you calculate the mass of the arm and find its center of mass based on the scale readings and the distances of the scales from the shoulder joint. You must include a free body diagram of the arm to direct the analysis. Consider changing the position of the scale under the hand to provide more information, if needed. You may wish to consult references to obtain reasonable mass values.
Want to see the full answer?
Check out a sample textbook solutionChapter 9 Solutions
College Physics
Additional Science Textbook Solutions
Lecture- Tutorials for Introductory Astronomy
Essential University Physics: Volume 2 (3rd Edition)
Conceptual Physics (12th Edition)
Physics: Principles with Applications
College Physics: A Strategic Approach (4th Edition)
Sears And Zemansky's University Physics With Modern Physics
- A 12.0m boom, of a crane lifting a 3000kg load is shown below. The center of mass of the boom is at its geometric center, and the mass of the boom is 1000kg . For the position shown, calculate tension T in the cable and the force at the axle A.arrow_forwardThe forearm shown below is positioned at an angle with respect to the upper arm , and a 5.0- kg mass is held in the hand. The total mass of the forearm and hand is 3.0 kg, and their center of mass is 15.0 cm from the elbow. (a) What is the magnitude of the force that the biceps muscle exerts on the forearm for =60 ? (b) What is the magnitude of the force on the elbow joint for the same angle? (c) How do these forces depend on the angle ?arrow_forwardRepeat the preceding problem replacing the marble with a hollow sphere. Explain the new results.arrow_forward
- A bowling ball rolls up a ramp 0.5 m high without slipping to storage. It has an initial velocity of its center of mass of 3.0 m/s. (a) What is its velocity at the top of the ramp? (b) If the ramp is 1 m high does it make it to the top?arrow_forwardIn order to get his car out of the mud, a man ties one end of a rope to the front bumper and the other end to a tee 15 m away as shown below. He then pulls on the center of the rope with a force of 400 N, which causes its center to be displaced 0.30 m, as shown. What is the force of the rope on the car?arrow_forwardIn an emergency situation, a person with a broken forearm ties a strap from his hand to clip on his shoulder as in Figure P8.92. His 1.60-kg forearm remains in a horizontal position and the strap makes an angle of = 50.0 with the horizontal. Assume the forearm is uniform, has a length of = 0.320 m, .assume the biceps muscle is relaxed, and ignore the mass and length of the hand. Find (a) the tension in the snap and (b) the components of the reaction force exerted by the humerus on the forearm. Figure P8.92arrow_forward
- As shown in Figure 10.13 on page 306, toppling chimneys often break apart in midfall because the mortar between the bricks cannot withstand much shear stress. As the chimney begins to fall, shear forces must act on the topmost sections to accelerate them tangentially so that they can keep up with the rotation of the lower part of the stack. For simplicity, let us model the chimney as a uniform rod of length pivoted at the lower end. The rod starts at rest in a vertical position (with the frictionless pivot at the bottom) and falls over under the influence of gravity. What fraction of the length of the rod has a tangential acceleration greater than g sin , where is the angle the chimney makes with the vertical axis?arrow_forwardBIO When a gymnast performing on the rings executes the iron cross, he maintains the position at rest shown in Figure P10.85a. In this maneuver, the gymnasts feet (not shown) are off the floor. The primary muscles involved in supporting this position are the latissimus dorsi (lats) and the pectoralis major (pecs). One of the rings exerts an upward fore Fh on a hand as shown in Figure P10.85b. The force Fs is exerted by the shoulder joint on the arm. The latissimus dorsi and pectoralis major muscles exert a total force Fm on the arm. (a) Using the information in the figure, find the magnitude of the force Fm. (b) Suppose an athlete in training cannot perform the iron cross but can hold a position similar to the figure in which the arms make a 45 angle with the horizontal rather than being horizontal. Why is this position easier for the athlete? Figure P10.85arrow_forwardEven when the head is held erect, as in Figure 9.41, its center of mass is not directly over the principal point of support (the atlanto-occipital joint). The muscles at the back of the neck should therefore exert a force to keep the head erect. That is why your head falls forward when you fall asleep in the class. (a) Calculate the force exerted by these muscles using the information in the figure. (b) What is the force exerted by the pivot on the head?arrow_forward
- The Iron Cross When a gymnast weighing 750 N executes the iron cross as in Figure lN.91a, the primary muscles involved in supporting this position are the latissimus dorsi (lats") and the pectoralis major (pecs"). The rings exert an upward force on the aims and support the weight of the gymnast. The force exerted by the shoulder joint on the arm is labeled Fs, while the two muscles exert a total force Fw on the arm. Estimate the magnitude of the force Fw. Note that one ring supports half the weight of the gymnast, which is 375 N as indicated in Figure P8.91b. Assume that the force Fw acts at an angle of 45 below the horizontal at a distance of 4.0 cm from the shoulder joint In your estimate, take the distance from the shoulder joint to the hand to be L = 70 cm and ignore the weight of the arm.arrow_forward(a) What force should the woman in Figure 9.45 exert on the floor with each hand to do a push-up? Assume that she moves up at a constant speed. (b) The triceps muscle at the back of her upper arm has an effective lever arm of 1.75 cm, and she exerts force on the floor at a horizontal distance of 20.0 cm from the elbow joint. Calculate the magnitude of the force in each triceps muscle, and compare it to her weight. (c) How much work does she do if her center of mass rises 0.240 m? (d) What is her useful power output if she does 25 pushups in one minute?arrow_forward
- College PhysicsPhysicsISBN:9781938168000Author:Paul Peter Urone, Roger HinrichsPublisher:OpenStax CollegePhysics for Scientists and Engineers, Technology ...PhysicsISBN:9781305116399Author:Raymond A. Serway, John W. JewettPublisher:Cengage LearningCollege PhysicsPhysicsISBN:9781285737027Author:Raymond A. Serway, Chris VuillePublisher:Cengage Learning
- Principles of Physics: A Calculus-Based TextPhysicsISBN:9781133104261Author:Raymond A. Serway, John W. JewettPublisher:Cengage LearningUniversity Physics Volume 1PhysicsISBN:9781938168277Author:William Moebs, Samuel J. Ling, Jeff SannyPublisher:OpenStax - Rice UniversityPhysics for Scientists and Engineers: Foundations...PhysicsISBN:9781133939146Author:Katz, Debora M.Publisher:Cengage Learning