An aqueous solution of 0.2100 g of a mixture containing potassium cyanide and potassium chloride required 14.56 mL of 0.1000 M silver nitrate to produce a faint permanent turbidity; 30.00 mL more of the silver nitrate was added (an excess) and the precipitate of AgCl and AgCN filtered off from the solution. The filtrate and washings were titrated with 13.06 mL 0.1000 M thiocyanate solution. Calculate the percentages of KCl and KCN in the sample.

An aqueous solution of 0.2100 g of a mixture containing potassium cyanide and potassium chloride required 14.56 mL of 0.1000 M silver nitrate to produce a faint permanent turbidity; 30.00 mL more of the silver nitrate was added (an excess) and the precipitate of AgCl and AgCN filtered off from the solution. The filtrate and washings were titrated with 13.06 mL 0.1000 M thiocyanate solution. Calculate the percentages of KCl and KCN in the sample.

Fundamentals Of Analytical Chemistry

9th Edition

ISBN:9781285640686

Author:Skoog

Publisher:Skoog

Chapter31: Introduction To Analytical Separations

Section: Chapter Questions

Problem 31.21QAP

See similar textbooks

Similar questions

The arsenic in a 1.203-g sample of a pesticide was converted to H3AsO4 by suitable treatment. The acid was then neutralized, and 40.00 mL of 0.05871 M AgNO3 was added to precipitate the arsenic quantitatively as Ag3AsO4. The excess Ag+ in the filtrate and in the washings from the precipitate was titrated with 9.63 mL of 0.1000 M KSCN, and the reaction was. Find the percentage of As2O3 in the sample.
The arsenic in a 1.010 g sample of a pesticide was converted to H3AsO4 by suitable treatment. The acid was then neutralized, and exactly 40.00 mL of 0.06222M AgNO3 was added to precipitate the arsenic quantitatively as Ag3AsO4. The excess Ag in the filtrate and in the washings from theprecipitate was titrated with 10.76 mL of 0.1000MKSCN; the reaction wasAg+ + SCN-→ AgSCN(s) Calculate the percent AsO3 in the sample.
The solubility of borax, which is made up of sodium tetraborate (Na2B4O5(OH)4 8H2O), was analyzed. The dissolution of borax is: Na2B4O5(OH)4 • 8H2O(s) ⇌ 2 Na+(aq) + B4O5(OH)42–(aq) + 8 H2O(l) A 50 mL saturated solution was prepared. After filtration of solution, 5 mL aliquot was transferred to a flask and titrated using 0.432 M HCl. The endpoint was found to be 4.73 mL of the titrant. Tetraborate anion (B4O5(OH)42-) is a weak base which reacts with HCl like the following reaction: B4O5(OH)42–(aq) + 2 H+(aq) + 3 H2O(l) ⇌ 4 H3BO3(aq) What is Ksp expression for the dissolution? What is the tetraborate ions concentration in the filtrate? What is the molar solubility and Ksp of borax if the titration was done at room temperature (298 K)?
The amount of sulfate in a solid sample was determined by first dissolving 562.2 mg of sample in water, and then precipitating the sulfate by the addition of 25.00 mL of 0.022 96 M BaCl2. The precipitate was filtered from the solution and the remaining Ba2+ was titrated with 16.52 mL of 0.014 57 M EDTA. What was the mass percent of sulfate in the solid?
To determine the concentration of glucose in the packaged juice industry, 50 mL of sample is analyzed. Analysis of it (and other reducing sugars) was carried out there using triiodide back titration. An excess volume of 75.00 mL of 0.338 M triiodide standard solution in alkaline medium was added to the glucose solution. The resulting solution was acidified and the excess triiodide was titrated with 18.37 mL of standard 0.526 M thiosulfate solution. Calculate is the concentration in ppm in the sample. In alkaline medium: Glucose (C6H12O6) / Gluconate (C6H11O7-), Triiodide (I3- ) / Iodide (I-) In acid medium: Thiosulfate (S2O32-) / Tetrathionate (S4O62-), Triiodide (I3- ) / Iodide (I-)
The protein content of wheat flour can be determined reasonably accurately by multiplying the percentage of nitrogen present by 5.7. A 2.06-g sample of flour was taken through a Kjeldahl procedure and the ammonia produced was distilled into a boric acid solution. If this solution required 34.70 mL of 0.174 N HCl for titration to the methyl red end point, what is the a) % Nitrogen and b) % protein in the flour? (Use 1:1 stoich ratio between N and HCl)
A saturated solution of magnesium hydroxide is prepared and the excess solid magneisum hydorixed is allowed to settle. A 25.0 mL aliquot of the saturated solution is withdrawn and transfered to a flask, two drops of inficator are added. A 0.00053 M HCL is dispensed from a buret into a solution. The solution changes color after the addition of 13.2 mL. What is the Ksp of magnesium hydroxide?
To determine the fluoride content in an aqueous and chloride-containing preparation of ammonium fluoride, the following analysis was performed. 105.2 mg of the preparation was dissolved in 100.0 mL of water. Then a 300 mL 40 mM lead chloride solution was added, whereby all fluoride ions were precipitated out of the solution in the form of the sparingly soluble salt PbClF (s). The precipitate was separated and washed at 15 degrees with a lead fluoride chloride saturated solution and dried at 130 degrees. The precipitate weighed 651.3 mg. a) Calculate the fluoride content (as % by weight F) in the preparation.b) Determine the purity of the ammonium fluoride preparation
The SO2 present in air is mainly responsible for the phenomenon of acid rain. The concentration of SO2 can be determined by titrating against a standard permanganate solution as follows: 5SO2 + 2MnO4- + 2H2O ---> 5SO42- + 2Ms2 + 4H+ Calculate the number of grams of SO2 in a sample of air if 4.90mL of 0.00700M KMnO4 solution are required for the titration. Be sure your answer has the correct number of significant digits.
The concentration of CO in the air can be determined by passing a known volume of air through a tube containing I2O5, resulting in the formation of CO2 and I2. I2 is removed from the tube by distillation and collected in a solution containing excess KI, producing I3-. I3- is titrated with a standard solution of Na2S2O3. A 4.79 L air sample was sampled as described here, requiring 7.17 ml of 0.00329 M Na2S2O3 to reach the endpoint in a typical analysis. If the density of the air is 1.23×10^-3 g/ml, what is the amount of CO in the air in ppm? (CO: 28 g/ml)
A sample containing calcium was analyzed by gravimetry, converting all calcium to calcium oxalate monohydrate (CaC2O4 • H2O). The sample weighing 0.2654 g was dissolved by adding 6M HCl, and then ammonium oxalate solution was added to precipitate all the calcium. The precipitate was suction filtered and dried in an oven at 95 °C for one hour. The solid obtained weighed 0.3216 grams.Calculate:A) The percentage of CaCO3B) The percentage of Ca C) The percentage of CaO
A Medical Technology student was given a capsule of a multivitamins and she was asked to determine the % by mass (w/w) of ascorbic acid present in the capsule. The student analyzed the 2.001 g sample using volumetric titration. The following data was generated in the analysis: KIO3 + 5KI + 6H+ → 3I2 + 6K+ + 3H2O C6H8O6 + I2 → C6H6O6 + 2I- + 2H+ Table 1. Standardization of KIO3 Molarity of Ascorbic Acid Standard Solution 0.03542 M Volume of Ascorbic Acid 25.00 mL Volume of KIO3 8.70 mL Molarity of KIO3 ______________M Table 2. Determination of Ascorbic Acid Concnetration Initial burette reading, KIO3 0.00 mL Final burette reading, KIO3 33.60 mL Volume consumed, KIO3 33.60 mL MM of Ascorbic Acid 176.12 g/mole choices 7.30% 30.1% 33.6% 32.5%