Concept explainers
Interpretation: The molality of normal Creatinine solution and osmotic pressure at
Concept Introduction:
Molality of a solution also called as molal concentration can be defined as the mass of solute in grams to the mass of the solvent in kilograms. It can be given by the equation,
When a semipermeable membrane, separates a solution and pure solvent. The solvent molecules are passed through the semi permeable membrane. There is gradual increase in the volume of solution with a decrease in volume of the solvent with respect to time. The flow of solvent through a semipermeable membrane into the solution is called as osmosis. By the time system reaches equilibrium, the changes in the liquid level stops. There is a higher hydrostatic pressure on the solution than compared to that of the pure solvent because there is variation in the liquid levels at this point. The excess pressure on the solution is called osmotic pressure.
The osmotic pressure of solution is calculated by using,
Here,
Want to see the full answer?
Check out a sample textbook solutionChapter 10 Solutions
Chemistry: An Atoms First Approach
- Water at 25 C has a density of 0.997 g/cm3. Calculate the molality and molarity of pure water at this temperature.arrow_forwardConsider two solutions, A and B, separated by an osmotic semipermeable membrane that allows only water to pass through, as shown in the diagram in Problem 8-113. Based on each of the following identities for solutions A and B, indicate whether the liquid level in compartment A, with time, will increase, decrease, or not change. a. A = 1.0 M glucose solution and B = 2.0 M glucose solution b. A = 5.0%(m/v) NaCl solution and B = 4.0%(m/v) NaCl solution c. A = 2.0 M Na2SO4 solution and B = 3.0 M KNO3 solution d. A = 2.0 M glucose solution and B = 1.0 M NaCl solutionarrow_forwardYou have two aqueous solutions separated by a semipermeable membrane. One contains 5.85 g of NaCl dissolved in 100. mL of solution, and the other contains 8.88 g of KNO3 dissolved in 100. mL of solution. In which direction will solvent flow: from the NaCl solution to the KNO3 solution, or from KNO3 to NaCl? Explain briefly.arrow_forward
- Assume that 30 L of maple sap yields one kilogram of maple syrup (66% sucrose, C12H22O11). What is the molality of the sucrose solution after one fourth of the water content of the sap has been removed?arrow_forwardWhat is the freezing point and normal boiling point of a solution made by adding 39 mL of acetone, C3H6O, to 225 mL of water? The densities of acetone and water are 0.790 g/cm3 and 1.00 g/cm3, respectively.arrow_forwardWhat would be the freezing point of a solution formed by adding 1.0 mole of glucose (a molecular compound) to the following amounts of water? a. 250 g (0.25 kg) b. 500 g (0.500 kg) c. 1000 g (1.000 kg) d. 2000 g (2.000 kg)arrow_forward
- 6-111 As noted in Section 6-8C, the amount of external pressure that must be applied to a more concentrated solution to stop the passage of solvent molecules across a semipermeable membrane is known as the osmotic pressure The osmotic pressure obeys a law similar in form to the ideal gas law (discussed in Section 5-4), where Substituting for pressure and solving for osmotic pressures gives the following equation: RT MRT, where M is the concentration or molarity of the solution. (a) Determine the osmotic pressure at 25°C of a 0.0020 M sucrose (C12H22O11) solution. (b) Seawater contains 3.4 g of salts for every liter of solution. Assuming the solute consists entirely of NaCl (and complete dissociation of the NaCI salt), calculate the osmotic pressure of seawater at 25°C. (c) The average osmotic pressure of blood is 7.7 atm at 25°C. What concentration of glucose (C6H12O6) will be isotonic with blood? (d) Lysozyme is an enzyme that breaks bacterial cell walls. A solution containing 0.150 g of this enzyme in 210. mL of solution has an osmotic pressure of 0.953 torr at 25°C. What is the molar mass of lysozyme? (e) The osmotic pressure of an aqueous solution of a certain protein was measured in order to determine the protein's molar mass. The solution contained 3.50 mg of protein dissolved in sufficient water to form 5.00 mL of solution. The osmotic pressure of the solution at 25°C was found to be 1.54 torr. Calculate the molar mass of the protein.arrow_forwardThe average lithium ion concentration in seawater is 0.18 ppm. What is the molality of Li+ in seawater?arrow_forwardConsider two solutions, A and B, separated by an osmotic semipermeable membrane that allows only water to pass through, as shown in the following diagram. Based on each of the following identities for solutions A and B, indicate whether the liquid level in compartment A, with time, will increase, decrease, or not change. a. A = 1.0 M NaCl solution and B = 2.0 M NaCl solution b. A = 5.0%(m/v) glucose solution and B = 4.0%(m/v) glucose solution c. A = 2.0 M KCl solution and B = 2.0 M KNO3 solution d. A = 1.0 M glucose solution and B = 1.0 M NaCl solutionarrow_forward
- General, Organic, and Biological ChemistryChemistryISBN:9781285853918Author:H. Stephen StokerPublisher:Cengage LearningIntroduction to General, Organic and BiochemistryChemistryISBN:9781285869759Author:Frederick A. Bettelheim, William H. Brown, Mary K. Campbell, Shawn O. Farrell, Omar TorresPublisher:Cengage LearningChemistry & Chemical ReactivityChemistryISBN:9781337399074Author:John C. Kotz, Paul M. Treichel, John Townsend, David TreichelPublisher:Cengage Learning
- Chemistry & Chemical ReactivityChemistryISBN:9781133949640Author:John C. Kotz, Paul M. Treichel, John Townsend, David TreichelPublisher:Cengage LearningChemistry: The Molecular ScienceChemistryISBN:9781285199047Author:John W. Moore, Conrad L. StanitskiPublisher:Cengage LearningChemistry: Principles and PracticeChemistryISBN:9780534420123Author:Daniel L. Reger, Scott R. Goode, David W. Ball, Edward MercerPublisher:Cengage Learning