Automotive Technology
7th Edition
ISBN: 9781337794213
Author: ERJAVEC, Jack.
Publisher: Cengage,
expand_more
expand_more
format_list_bulleted
Concept explainers
Question
Chapter 15, Problem 2ASRQ
To determine
The technician with correct approach.
Expert Solution & Answer
Trending nowThis is a popular solution!
Students have asked these similar questions
Technician A says that a 12-volt light bulb that draws 12 amps has a power output of 1 watt. Technician B says that a motor that has 1 ohm of resistance has a power rating of 144 watts if it is connected to a 12-volt battery. Who is correct?
Expert Answer
Which type of resistor is commonly used in automotive circuits?
a. Fixed value
b. Stepped
c. Variable
d. All of the above
Technician A says that many vehicles use an AC generator as the charging unit. Technician B says that all vehicles use an alternator as the charging unit. Who is correct?
a. Technician A
b. Technician B
c. Both A and B
d. Neither A nor B
Chapter 15 Solutions
Automotive Technology
Ch. 15 - What is represented by the E, I, and R in the...Ch. 15 - What are the two types of wires and which is the...Ch. 15 - Define voltage drop.Ch. 15 - Define circuit protection.Ch. 15 - Prob. 5SACh. 15 - What is the difference between voltage and...Ch. 15 - What is an SPST switch?Ch. 15 - Solve the parallel circuit for total circuit...Ch. 15 - Prob. 1TFCh. 15 - True or False? An open switch is one that can flow...
Ch. 15 - Which type of resistor is commonly used in...Ch. 15 - Prob. 2MCCh. 15 - Prob. 3MCCh. 15 - Prob. 4MCCh. 15 - Prob. 5MCCh. 15 - Prob. 1ASRQCh. 15 - Prob. 2ASRQCh. 15 - While discussing the circuit shown in Figure...Ch. 15 - While discussing electrical grounds: Technician A...Ch. 15 - Prob. 5ASRQCh. 15 - Prob. 6ASRQCh. 15 - While discussing copper wire: Technician A says...Ch. 15 - While discussing current flow: Technician A says...Ch. 15 - While discussing voltage Technician A says that...Ch. 15 - While discussing the AWG system: Technician A says...
Knowledge Booster
Learn more about
Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.Similar questions
- While discussing electric motors: Technician A says that when there is high CEMF, there will be high current flow. Technician B says that if the reluctance of an electromagnet increases, its field strength increases. Who is correct? Technician A Technician B Both A and B Neither A nor Barrow_forwardWhile discussing voltage Technician A says that voltage is the force developed by the attraction of the electrons to protons. Technician B says that the force developed by the attraction of electrons to protons is called electromotive force and it is measured in volts. Who is correct? Technician A Technician B Both A and B Neither A nor Barrow_forwardWhich of the following is not made of semiconductor material? Zener diode Thermistor PM generator Hall-effect switcharrow_forward
- The alternating current produced by the AC generator is rectified into DC, or direct current, through the use of. transistors electromagnetic relays diodes capacitorsarrow_forwardWhile checking an A/C compressor clutch coil spikesuppressing diode with an ohmmeter, the meter shows infinite resistance when the diode is measured in both directions: Technician A says that the diode is open. Technician B says that all diodes should behave this way until a specified voltage is applied to them. Who is correct? Technician A Technician B Both A and B Neither A nor Barrow_forwardWhile discussing current flow: Technician A says that current results from electrons being attracted to protons. Technician B says that for practical purposes, it is best to remember that current flows from a point of higher potential to a point of lower potential. Who is correct? Technician A Technician B Both A and B Neither A nor Barrow_forward
- While diagnosing the location of a wire-to-wire short: Technician A checks the wiring of the affected circuits for signs of burned insulation and melted conductors. Technician B checks common connectors shared by the two affected circuits. Who is correct? Technician A Technician B Both A and B Neither A nor Barrow_forwardWhile checking an A/C compressor clutch coil clamping diode with a DMM, the meter shows infinite resistance when the diode is measured in both directions: Technician A says that the diode is open. Technician B says that all diodes should behave this way until a specified voltage is applied to them. Who is correct? a. Technician A b. Technician B c. Both A and B d. Neither A nor Barrow_forwardTechnician A says that the reserve rating of a battery is the amount of steady current that a fully charged battery can supply tor 20 hours without the voltage falling below 10.5 volts. Technician B says that ampere-hour ratings state how many hours the battery is capable of supplying 25 amperes. Who is correct? Technician A Technician B Both A and B Neither A nor Barrow_forward
arrow_back_ios
arrow_forward_ios
Recommended textbooks for you
- Automotive Technology: A Systems Approach (MindTa...Mechanical EngineeringISBN:9781133612315Author:Jack Erjavec, Rob ThompsonPublisher:Cengage LearningAutomotive TechnologyMechanical EngineeringISBN:9781337794213Author:ERJAVEC, Jack.Publisher:Cengage,
Automotive Technology: A Systems Approach (MindTa...
Mechanical Engineering
ISBN:9781133612315
Author:Jack Erjavec, Rob Thompson
Publisher:Cengage Learning
Automotive Technology
Mechanical Engineering
ISBN:9781337794213
Author:ERJAVEC, Jack.
Publisher:Cengage,