Automotive Technology
7th Edition
ISBN: 9781337794213
Author: ERJAVEC, Jack.
Publisher: Cengage,
expand_more
expand_more
format_list_bulleted
Concept explainers
Videos
Textbook Question
Chapter 18, Problem 10ASRQ
While discussing electric motors: Technician A says that when there is high CEMF, there will be high current flow. Technician B says that if the reluctance of an electromagnet increases, its field strength increases. Who is correct?
- Technician A
Expert Solution & Answer
Trending nowThis is a popular solution!
Students have asked these similar questions
Identify examples of motors used in a new automobile. For example, a motor is used to run the fan that delivers warm or cold air into the car.
Which of following is not an advantage of V-belt drive over flat belt drive?
a)Efficiency of the V-belts is higher than flat belt’s one
b)Width of V-belts is smaller than flat belt one
c)V-belts has the high velocity ratio than flat belt one
d)V-belts are made endless
e)V-belt drive has the small distance between centers of pulleys than flat belt drive
Technician A says that a 12-volt light bulb that draws 12 amps has a power output of 1 watt. Technician B says that a motor that has 1 ohm of resistance has a power rating of 144 watts if it is connected to a 12-volt battery. Who is correct?
Expert Answer
Chapter 18 Solutions
Automotive Technology
Ch. 18 - Prob. 1SACh. 18 - Prob. 2SACh. 18 - The part of the armature that the brushes ride on...Ch. 18 - Describe how to perform a starter bench test.Ch. 18 - True or False? The strength of the magnetic field...Ch. 18 - True or False? Worn armature bearings can result...Ch. 18 - Which of the following is not part of the starter...Ch. 18 - Which of the following tests would not be...Ch. 18 - When the starter spins but does not crank the...Ch. 18 - If the solenoid clicks while trying to crank the...
Ch. 18 - Prob. 5MCCh. 18 - Prob. 6MCCh. 18 - Prob. 7MCCh. 18 - The device that prevents the engine from turning...Ch. 18 - A control circuit voltage drop test shows a 1.1...Ch. 18 - An engine cranks slowly: Technician A says that a...Ch. 18 - Prob. 2ASRQCh. 18 - Pinion gear-to-flywheel ring gear clearance is...Ch. 18 - Technician A says that a starter no-load test is...Ch. 18 - Cranking current is excessive but is normal when...Ch. 18 - Prob. 6ASRQCh. 18 - When diagnosing a no-crank no-start condition, no...Ch. 18 - While discussing a no-crank condition: Technician...Ch. 18 - Prob. 9ASRQCh. 18 - While discussing electric motors: Technician A...
Knowledge Booster
Learn more about
Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.Similar questions
- True or False: All electric motors must be cooled or they will overheat.arrow_forwardDescribe what may happen to an electric motor if the drive belt is too tight.arrow_forwardWhile discussing IAC motor removal, service, and replacement: Technician A says that throttle body cleaner may be used to clean the IAC motor internal components. Technician B says that on some vehicles, IAC motor damage occurs if the pintle is extended more than specified during installation. Who is correct? a. Technician A b. Technician B c. Both A and B d. Neither A nor Barrow_forward
- There is a short circuit in an electric motor winding when A. there is an adverse weather condition. B. a winding conductor is worn bare and touches anotherpart of the conductor that is also bare. C. there is a defect in the centrifugal start switch. D. the motor will not start.arrow_forwardWhat safety precautions should be taken when startinga large electric motor whose coupling is disconnected?arrow_forwardWhich of the following is not part of the starter motorcircuit?a. Batteryb. Starting safety switchc. Starter motord. Relay solenoidarrow_forward
- True or False: Three-phase motors have low starting torque.arrow_forwardTrue or False? Coil secondary resistance is typically very low, less than 1 ohm.arrow_forwardThe following statement is made about an ignition system: tech a says that the greater the speed of the magnets rotating past a the ignition coil, the greater the voltage will be induced into the ignition coil. Tech b says that the primary windings produce a higher voltage than the secondary winding. Who is correct?arrow_forward
- Technician A says that a magneto resistive sensor is equipped with a permanent magnet. Technician B says that a Hall-effect switch is equipped with a permanent magnet. Who is correct? a. Technician A b. Technician B c. Both A and B d. Neither A nor Barrow_forwardAn open winding in an electric motor means that A. the winding is making contact with the motor frame. B. one winding is making contact with another winding. C. a wire in one winding is broken. D. the centrifugal switch to the start winding is open.arrow_forwardWhat are the advantages of alternators over generators?arrow_forward
arrow_back_ios
SEE MORE QUESTIONS
arrow_forward_ios
Recommended textbooks for you
Automotive Technology: A Systems Approach (MindTa...Mechanical EngineeringISBN:9781133612315Author:Jack Erjavec, Rob ThompsonPublisher:Cengage Learning
Refrigeration and Air Conditioning Technology (Mi...Mechanical EngineeringISBN:9781305578296Author:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill JohnsonPublisher:Cengage LearningAutomotive TechnologyMechanical EngineeringISBN:9781337794213Author:ERJAVEC, Jack.Publisher:Cengage,
Welding: Principles and Applications (MindTap Cou...Mechanical EngineeringISBN:9781305494695Author:Larry JeffusPublisher:Cengage Learning
Automotive Technology: A Systems Approach (MindTa...
Mechanical Engineering
ISBN:9781133612315
Author:Jack Erjavec, Rob Thompson
Publisher:Cengage Learning
Refrigeration and Air Conditioning Technology (Mi...
Mechanical Engineering
ISBN:9781305578296
Author:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson
Publisher:Cengage Learning
Automotive Technology
Mechanical Engineering
ISBN:9781337794213
Author:ERJAVEC, Jack.
Publisher:Cengage,
Welding: Principles and Applications (MindTap Cou...
Mechanical Engineering
ISBN:9781305494695
Author:Larry Jeffus
Publisher:Cengage Learning
Material Properties 101; Author: Real Engineering;https://www.youtube.com/watch?v=BHZALtqAjeM;License: Standard YouTube License, CC-BY