Tutorials in Introductory Physics
1st Edition
ISBN: 9780130970695
Author: Peter S. Shaffer, Lillian C. McDermott
Publisher: Addison Wesley
expand_more
expand_more
format_list_bulleted
Videos
Textbook Question
Chapter 24.6, Problem 3cTH
Two thin convex lenses and an object are arranged as shown below. Two rays from the tip of the object are drawn in order to determine the location of the image produced by lens 1. Lens 2 is placed so that one of its focal points coincides with the location of the image produced by lens 1.
c. On the diagram above, clearly indicate:
• the direction in which the observer must look to see the tip of the image,
• the direction in which the observer must look to See the tail of the image, and
• an angle that represents the angular size of the entire image seen by the observer.
Expert Solution & Answer
Want to see the full answer?
Check out a sample textbook solution
Students have asked these similar questions
Sketched below are several objects (the arrows labeled "O") in front of lenses. In each case, carefully redraw the sketch on your whiteboard, and then(a) Draw 3 principal rays leaving the top of the object;(b) Locate the image;(c) State whether the image is real or virtual, inverted or upright, and larger or smaller than the object.
(iv) For diagram #iii, suppose the focal length is 5 cm and the object is placed 7 cm from the lens. Find the exact location and magnification of the image. Does this agree with your expectation from the ray diagram?
Consider a light ray from a fish that emerges into the air with angle α as shown on the left. Now consider this same light ray originating from the fish going through glass before emerging into the air at angle β, as shown on the right. Which angle is larger: α or β? (Note: the path shown through the glass is illustrative only – you might have to change the slope.
A small object O is placed one-third of the distance between two parallel plane mirrors as in the figure below.
(a) Trace appropriate bundles of rays for viewing the four images that lie closest to the object.
(b) If the distance between the two parallel plane mirrors is a, then express the distances of these 4 images from the object in terms of the distance a
Chapter 24 Solutions
Tutorials in Introductory Physics
Ch. 24.1 - On the diagram, sketch what you would see on the...Ch. 24.1 - The small bulb is replaced by three longfilament...Ch. 24.1 - The three longfilament bulbs are replaced by a...Ch. 24.1 - Predict the size and shape of the shadow that will...Ch. 24.1 - Is it possible to place the bulb in another...Ch. 24.1 - Prob. 2cTHCh. 24.1 - Prob. 2dTHCh. 24.1 - Prob. 3aTHCh. 24.1 - A student is looking at the building shown at...Ch. 24.1 - Prob. 4aTH
Ch. 24.1 - Suppose that this student were walking through the...Ch. 24.2 - The top view diagrams at right were drawn by a...Ch. 24.2 - Draw a ray diagram to determine the location of...Ch. 24.2 - Describe how you could use a ray diagram to...Ch. 24.2 - A pencil is placed in front of a plane mirror as...Ch. 24.2 - Prob. 3bTHCh. 24.3 - Prob. 1aTHCh. 24.3 - A pin is placed in front of a semicylindrical...Ch. 24.3 - Prob. 1cTHCh. 24.3 - Prob. 2aTHCh. 24.3 - A very small, very bright bulb is placed for from...Ch. 24.4 - The following are top view diagrams of solid...Ch. 24.4 - The following are top view diagrams of solid...Ch. 24.4 - The following are top view diagrams of solid...Ch. 24.4 - The following are top view diagrams of solid...Ch. 24.4 - Prob. 2THCh. 24.4 - Prob. 3aTHCh. 24.4 - Prob. 3bTHCh. 24.4 - Is the image(s) of the nail real or virtual?...Ch. 24.5 - Suppose that the bulb is placed as shown. Using...Ch. 24.5 - Prob. 1bTHCh. 24.5 - Prob. 1cTHCh. 24.5 - Prob. 1dTHCh. 24.5 - Prob. 2aTHCh. 24.5 - Treat the image produced by lens 1 as an object...Ch. 24.5 - Repeat parts a andb for the case in which lens 2...Ch. 24.6 - Reproduced below is a side view diagram of the...Ch. 24.6 - In section III of the tutorial Magnification, you...Ch. 24.6 - Two thin convex lenses and an object are arranged...Ch. 24.6 - Prob. 3bTHCh. 24.6 - Two thin convex lenses and an object are arranged...Ch. 24.6 - Prob. 3dTHCh. 24.6 - Two thin convex lenses and an object are arranged...
Additional Science Textbook Solutions
Find more solutions based on key concepts
3. What is free-fall, and why does it make you weightless? Briefly describe why astronauts are weightless in th...
The Cosmic Perspective (8th Edition)
What happens during the fight or flight response?
Conceptual Integrated Science
A battery with an internal resistance of r and an emf of 10.00 V is connected to a load resistor R = r. As the ...
University Physics Volume 2
13. A 50 kg box hangs from rope. What is the tension in the rope if:
a. The box is at rest?
b. The box moves ...
Physics for Scientists and Engineers: A Strategic Approach, Vol. 1 (Chs 1-21) (4th Edition)
Q21.18 What similarities do electric forces have with gravitational forces? What are, the most significant diff...
University Physics with Modern Physics (14th Edition)
(III) A wire is bent into the shape of a regular polygon with n sides whose vertices are a distance R from the ...
Physics for Scientists and Engineers with Modern Physics
Knowledge Booster
Learn more about
Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.Similar questions
- A 1.5 cmcm high object is located 30 cmcm from a diverging lens, whose focal length is 11 cmcm . What is the height of the image produced by the lens? You have determined the height of the image using numerical methods and, in so doing, have also determined its position, s′s′s'. Now, use graphical methods to evaluate your results.The diagram below shows the object, a ray (ray 1) parallel to the optic axis of the lens, and a ray (ray 2) proceeding toward the first focal point of the lens. Draw the refracted rays and the image produced by the lens. Make sure you extend the refracted rays sufficiently backward in order to find the image. Keep in mind that principal-ray diagrams must be drawn accurately to give good results!arrow_forwardIf the incident ray at point A is at the critical angle between mediums 2 and 3, does the ray incident at point B refract out of medium 2 into 3? If so, what is the (i) angle of refraction at point B? If not, what is the reflected angle at point B? (ii) Draw an accurate ray diagram at point B. (iii) What is the initial angle θ at point C?arrow_forwardA concave lens refracts parallel rays in such a way that they are bent away from the axis of the lens. For this reason, a concave lens is referred to as a diverging lens. Part A: Consider the following diagrams, where F represents the focal point of a concave lens. In these diagrams, the image formed by the lens is obtained using the ray tracing technique. Which diagrams are accurate?(Figure 1) *Type A if you think that only diagram A is correct, type AB if you think that only diagrams A and B are correct, and so on. Part B: If the focal length of the concave lens is -7.50 cm , at what distance d_o from the lens should an object be placed so that its image is formed 3.70 cm from the lens?arrow_forward
- Thank you so much in advance. The diagram shows a lens with a positive focal length 11 cm. (a) If we place an object at a distance of 25 cm from the lens, where will the resulting image position on the other side of the lens be found? Include units in answer, (b) With the object at 25 cm from the lens, what will the magnification be for the image at this position? (c) If we place an object at a distance of 4 cm from the lens, where will the resulting image position be found? (d) With the object at 4 cm from the lens, what will the magnification be for the image at this position?arrow_forwardA beam of light travels vertically downward and strikes a horizontal mirror, reflecting directly back vertically upward, as indicated by the black dashed line in the diagram at left. The mirror is now rotated, so that it is 10° away from horizontal, as is the red mirror in the diagram . The incident solid black ray is the same in both cases. a) At what angle from the vertical will the reflected beam (the red dashed arrow) now be seen? b) If the mirror is further rotated until it is 20° from the horizontal, what will be the new angle between the reflected beam and the vertical?arrow_forwardA ray of light travels through air until it strikes the interface between the air and another medium. The incident ray makes an angle of ?1 = 33.0° with the normal, as shown in the figure below. Upon passage into the second medium, the ray is refracted, emerging from the interface at an angle ?2 with respect to the normal. (a)Suppose that the second medium is ice. What is the angle of refraction, ?2 (in degrees)? (Enter your answer to at least one decimal place.) (b)Suppose that the second medium is crown glass. What is the angle of refraction, ?2,in this case (in degrees)? (Enter your answer to at least one decimal place.) (c)Finally, suppose that the second medium is ethyl alcohol. What is the angle of refraction, ?2, in this case (in degrees)? (Enter your answer to at least one decimal place.)arrow_forward
- Analyse the following observation table showing variation of image distance with object distance in case of a convex lens and answer the question that follow without doing any calculations1) What is the focal length of the convex lens? Give reason in support of your answer2) Write the serial number of that observation which is not correct. How did you arrive at this conclusion.3) Take an appropriate scale to draw ray diagram for the observation at S. No. 4 and find the approximate value of the magnification.Class - 10thChapter - Light, reflection and refraction.arrow_forwardA thin beam of white light is directed at a flat sheet of silicate flint glass at an angle of 20° to the surface of the sheet. Due to dispersion in the glass, the beam is spread out in a spectrum as shown in the figure. The refractive index of silicate flint glass versus wavelength is graphed in figure to the right. (a) The rays (A and B) shown in the figure correspond to the extreme wavelengths. Which corresponds to red and which to violet? Explain your reasoning. (b) For what thickness of the glass sheet will the spectrum be 1.0 mm wide, as shown (see Problem 7)? Hint: you must first solve Problem 7 first before doing Problem 8). Answer: 93.5 mmarrow_forwardA scene point with coordinate (X, Y, Z) = (α, β, γ) in the world is perspectively projected into an image at coordinate (x, y) = (δ, ϵ), where both coordinates are given in millimeters in the camera coordinate frame and the camera’s principal point is at coordinates (0, 0, f). The camera reference frame is translated ζ mm in the negative direction along the z-axis relative to the world reference frame. What are values for the camera intrinsics and extrinsics? Show all your work.arrow_forward
- A narrow beam of light is incident on the left side of the prism shown in the figure below. The prism is a right triangle, with two of its angles measuring 45°. A) The transmitted beam that exits the hypotenuse of the prism makes an angle of ? = 17.5° with the direction of the incident beam. What is the index of refraction of the prism? B) In part (a), we assumed the beam was monochromatic. Consider instead the case where the beam was composed of white light. Because the index of refraction differs for different wavelengths, the white light would be dispersed into constituent colors. Assume the index of refraction for blue wavelengths is 1.01n and for red wavelengths it is 0.99n, where n is the index of refraction found in part (a). What is the angular spread (in degrees) between red and blue light exiting the prism?arrow_forwardA plane wave hits a piece of glass whose front surface is spherical and whose back surface is plane. The radius of the lens is 10 cm and the thickness of the glass is 1 cm at the center, as shown in the diagram at right. At time t1, the center of the plane wavefront has just reached the lens. A short time later, at time t2, the center of the wavefront will have passed completely through the glass, as shown. a) Find the time that elapses between t1 and t2, the time it takes the center of the wavefront to pass thorugh the middle 1 cm of the glass. b) Find the amount by which the edges of the wavefront at t2 will be ahead of the cetner of the wavefront, due to the fact that these edges passed through empty space, with no glass in their paths.arrow_forwardThe two mirrors illustrated as shown meet at a right angle. The beam of light in the vertical plane indicated by the dashed lines strikes mirror 1 as shown. (a) Determine the distance the reflected light beam travels before strikingmirror 2. (b) In what direction does the light beam travel after being reflected from mirror 2?arrow_forward
arrow_back_ios
SEE MORE QUESTIONS
arrow_forward_ios
Recommended textbooks for you
Glencoe Physics: Principles and Problems, Student...PhysicsISBN:9780078807213Author:Paul W. ZitzewitzPublisher:Glencoe/McGraw-Hill
University Physics Volume 3PhysicsISBN:9781938168185Author:William Moebs, Jeff SannyPublisher:OpenStax
Glencoe Physics: Principles and Problems, Student...
Physics
ISBN:9780078807213
Author:Paul W. Zitzewitz
Publisher:Glencoe/McGraw-Hill
University Physics Volume 3
Physics
ISBN:9781938168185
Author:William Moebs, Jeff Sanny
Publisher:OpenStax
Domestic Electric Circuits; Author: PrepOnGo Class 10 & 12;https://www.youtube.com/watch?v=2ZvWaloQ3nk;License: Standard YouTube License, CC-BY