Automotive Technology (Custom)
6th Edition
ISBN: 9781337495356
Author: ERJAVEC
Publisher: Cengage
expand_more
expand_more
format_list_bulleted
Concept explainers
Textbook Question
Chapter 36, Problem 6ASRQ
While diagnosing the control system of a BEV: Technician A begins by checking the voltage of the auxiliary battery. Technician B inspects all fuses, fusible links, wiring harness, connectors, and ground in the low-voltage circuit. Who is correct?
a. Technician A only
b. Technician B only
c. Both A and B
d. Neither A nor B
Expert Solution & Answer
Want to see the full answer?
Check out a sample textbook solutionStudents have asked these similar questions
An overheating vehicle is being discussed.
Technician A states that the thermostat is
open until the engine fully warms up.
Technician B states that the vehicle may be
overheating because the thermostat is stuck
closed. Who is correct?
Select one:
a. Technician A only
b. Technician B only
c. Both Technicians A and B
d. Neither Technician A nor B
hile discussing NTC thermistors; Technician A says that some systems use this type of thermistor as a protection device. Technician B says that when there is high current in a circuit, the resistance of the thermistor increases and causes a decrease in current flow. Who is correct?
When discussing the reasons why a change from 12 V to 42 V batteries is likely
in the future, Technician A says this will produce an increase in power for an
increased range of accessories. Technician B says this will provide an increase in
power but also an increase in maintenance. Who is right?
1. A only.
2. B only.
3. Both A and B.
4. Neither A nor B.
Chapter 36 Solutions
Automotive Technology (Custom)
Ch. 36 - Why are carbon dioxide emissions a concern?Ch. 36 - List five things a driver of a BEV can do to...Ch. 36 - What makes up the propulsion system in a BEV?Ch. 36 - What basic factors affect the required time to...Ch. 36 - There are two basic ways a BEV is connected to an...Ch. 36 - Explain what the ratings of kilowatts and kilowatt...Ch. 36 - True or False? All fuel cell vehicles have...Ch. 36 - Which of the statements about hydrogen is true? a....Ch. 36 - True or False? A PEM fuel cell needs to operate at...Ch. 36 - Why is water control so important to the...
Ch. 36 - Which of the following CANNOT be used as a source...Ch. 36 - Which of the following statements about fuel cells...Ch. 36 - What is the basic fuel for a fuel cell? a....Ch. 36 - The component that changes the molecular structure...Ch. 36 - Which of the following statements about hydrogen...Ch. 36 - Technician A says power is the ability to do work....Ch. 36 - While discussing inductive charging: Technician A...Ch. 36 - Technician A says some BEVs use liquid to heat the...Ch. 36 - While discussing charger connections: Technician A...Ch. 36 - Technician A says that a fuel cell produces...Ch. 36 - While diagnosing the control system of a BEV:...Ch. 36 - Prob. 7ASRQCh. 36 - Technician A says that all FCEVs have regenerative...Ch. 36 - Technician A says that gasoline can be used as a...Ch. 36 - While discussing hydrogen: Technician A says that...
Knowledge Booster
Learn more about
Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.Similar questions
- Technician A says that installing a thermostat incorrectly can cause the housing to break. Technician B says that it is OK to install a thermostat in either direction. Who is correct? Select one: a. Technician A only b. Technician B only C. Both A and B d. Neither A nor Barrow_forwardWhich of the following is not a true statementabout blade fuses?a. They are available in several different sizes.b. They are color coded according to their voltage capacity.c. They are normally in an underhood fuse block.d. They allow the vehicle’s electrical system tobe broken down into small circuits.arrow_forwardTechnician A says that many vehicles use an AC generator as the charging unit. Technician B says that all vehicles use an alternator as the charging unit. Who is correct? a. Technician A b. Technician B c. Both A and B d. Neither A nor Barrow_forward
- An overheating vehicle is being discussed. Technician A states that the vehicle may be overheating because the heater control valve is stuck closed. Technician B states that the vehicle may be overheating because the PCM in not energizing the cooling fan relay. Who is correct? Select one: a. Technician A only b. Technician B only c. Both Technicians A and B d. Neither Technician A nor Barrow_forwardTechnician A says that many newer charging systems do not have a separate voltage regulator. Technician B says that most late-model charging systems are computer regulated through the ground of the field. Who is correct?arrow_forwardTechnician A says that a 12-volt light bulb that draws 12 amps has a power output of 1 watt. Technician B says that a motor that has 1 ohm of resistance has a power rating of 144 watts if it is connected to a 12-volt battery. Who is correct? Expert Answerarrow_forward
- While discussing what is indicated by a vehicle’s charge indicator: Technician A says that any positive reading on an ammeter shows that the generator is in working condition. Technician B says that if the voltmeter reading does not increase immediately after starting the engine, the battery is bad. Who is correct? Technician A Technician B Both A and B Neither A nor Barrow_forwardTechnician A says that a faulty radiator fan relay can cause an engine to overheat. Technician B says that bidirectional control is NOT used to test an electric cooling fan. Who is correct? Select one: a. Technician A only b. Technician B only c. Both A and B d. Neither A nor Barrow_forwardA starter cranks, but cranks slowly. The shop performs a voltage drop on the ground and power side of the starter circuit and they both test good. Technician A says the battery may be bad. Technician B says the starter may be bad. Who is correct?arrow_forward
- A pneumatic power system will usually have a return line a. True b. Falsearrow_forwardWhich of the following is the purpose of fail-safe circuits? O Fail-safe circuits are designed to protect electric motors against voltage surge O All of these are true O Fail-safe circuits are designed to provide overload protection for system components O Fail-safe circuits are designed to maintain constant current in electric motor coilsarrow_forwardTechnician A fast charges a sulfated battery then reinstalls it in the vehicle. Technician B trickle charges a sulfated battery over 24 hours before reinstalling it. Who is correct? a. A only b. B only c. both A and B d. neither A nor Barrow_forward
arrow_back_ios
SEE MORE QUESTIONS
arrow_forward_ios
Recommended textbooks for you
- Automotive Technology: A Systems Approach (MindTa...Mechanical EngineeringISBN:9781133612315Author:Jack Erjavec, Rob ThompsonPublisher:Cengage LearningAutomotive TechnologyMechanical EngineeringISBN:9781337794213Author:ERJAVEC, Jack.Publisher:Cengage,Refrigeration and Air Conditioning Technology (Mi...Mechanical EngineeringISBN:9781305578296Author:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill JohnsonPublisher:Cengage Learning
Automotive Technology: A Systems Approach (MindTa...
Mechanical Engineering
ISBN:9781133612315
Author:Jack Erjavec, Rob Thompson
Publisher:Cengage Learning
Automotive Technology
Mechanical Engineering
ISBN:9781337794213
Author:ERJAVEC, Jack.
Publisher:Cengage,
Refrigeration and Air Conditioning Technology (Mi...
Mechanical Engineering
ISBN:9781305578296
Author:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson
Publisher:Cengage Learning
The Robot Revolution: The New Age of Manufacturing | Moving Upstream; Author: Wall Street Journal;https://www.youtube.com/watch?v=HX6M4QunVmA;License: Standard Youtube License