An Introduction to Thermal Physics
1st Edition
ISBN: 9780201380279
Author: Daniel V. Schroeder
Publisher: Addison Wesley
expand_more
expand_more
format_list_bulleted
Videos
Textbook Question
Chapter 4.2, Problem 13P
Under many conditions, the rate at which heat enters an air conditioned building on a hot summer day ta proportional to the difference in temperature between inside and outside.
Expert Solution & Answer
Want to see the full answer?
Check out a sample textbook solution
Students have asked these similar questions
Suppose you want to raise the temperature of a mass m of ice from T0 < 0 °C to T > 100 °C. In this problem, represent the heat of fusion as Lf, the heat of vaporization as Lv, and the temperatures at which the phase changes occur as Tf and Tv.
How much heat must be transferred for this to happen, including the energy needed for phase changes? Your answer should be in terms of the variables in the introduction and the specific heats of ice (ci), water (cw), and steam (cs). The talent heats are Lf= 334kJ/kg and Lv=2256kJ/kg?
Compute the heat transfer through the air condition if the outside temperature is outside temperature, To = 5 degrees Celsius, inside temperature = 20 degrees Celsius, in a room with length 5 m, width of 6 m and height of 4 m. A typical volume flow for ventilation is 20 liters/second or 0.02 cubic meter/s, how much time will it take to replace all air within this room? Then, compute total thermal power flux out of the room through the ventilation? Given, Cp = 1005 J/khK, and roho = 1.2 kg/cubic.
To illustrate the effect of ice on the aluminum cooling plate, consider the drawing shown here and the data that it contains. Ignore any limitaions due to significant figures. How much heat per second per square meter is conducted through the ice-aluminum combination and through the aluminum by itself?
Chapter 4 Solutions
An Introduction to Thermal Physics
Ch. 4.1 - Prob. 1PCh. 4.1 - At a power plant that produces 1 GW ( 109 watts)...Ch. 4.1 - A power plant produces 1 GW of electricity, at an...Ch. 4.1 - It has been proposed to use the thermal gradient...Ch. 4.1 - Prove directly (by calculating the heat taken in...Ch. 4.1 - To get more than an infinitesimal amount of work...Ch. 4.2 - Why must you put an air conditioner in the window...Ch. 4.2 - Can you cool off your kitchen by leaving the...Ch. 4.2 - Prob. 9PCh. 4.2 - Suppose that heat leaks into your kitchen...
Ch. 4.2 - What is the maximum possible COP for a cyclic...Ch. 4.2 - Explain why an ideal gas taken around a...Ch. 4.2 - Under many conditions, the rate at which heat...Ch. 4.2 - Prob. 14PCh. 4.2 - In an absorption refrigerator the energy driving...Ch. 4.2 - Prob. 16PCh. 4.2 - Prob. 17PCh. 4.3 - Prob. 18PCh. 4.3 - The amount of work done by each stroke of an...Ch. 4.3 - Derive a formula for the efficiency of the Diesel...Ch. 4.3 - The ingenious Stirling engine is a true heat...Ch. 4.3 - A small-scale steam engine might operate between...Ch. 4.3 - Prob. 23PCh. 4.3 - Calculate the efficiency of a Rankine cycle that...Ch. 4.3 - In a real turbine, the entropy of the steam will...Ch. 4.3 - A coal-fired power plant, with parameters similar...Ch. 4.3 - In Table 4.1, why does the entropy of water...Ch. 4.3 - Imagine that your dog has eaten the portion of...Ch. 4.4 - Liquid HFC-134a at its boiling point at 12 bars...Ch. 4.4 - Consider a household refrigerator that uses...Ch. 4.4 - Suppose that the throttling valve in the...Ch. 4.4 - Suppose you are told to design a household air...Ch. 4.4 - Prob. 33PCh. 4.4 - Consider an ideal Hampson-Linde cycle in which no...Ch. 4.4 - The magnetic field created by a dipole has a...Ch. 4.4 - Prob. 36PCh. 4.4 - A common (but imprecise) way of stating the third...
Additional Science Textbook Solutions
Find more solutions based on key concepts
Use the definition of acceleration to draw a vector in the space at right that represents the acceleration of t...
Tutorials in Introductory Physics
7.76 • A particle moves along the x-axis while acted on by a single conservative force parallel to the x-axis. ...
University Physics (14th Edition)
Whether the focal length for light that strikes near the edge of the lens be greater than, less than, or equal ...
Physics (5th Edition)
30. If a compass is placed above a current-carrying wire, as in Figure Q24.30, the needle will line up with the...
College Physics: A Strategic Approach (3rd Edition)
Capacitors C1, and C2 are in series, with voltage V across the combination. Show that the voltages across the i...
Essential University Physics: Volume 2 (3rd Edition)
83. When you are traveling in your car at highway speed, the momentum of a bug is suddenly changed as it splatt...
Conceptual Physical Science (6th Edition)
Knowledge Booster
Learn more about
Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.Similar questions
- Answer the following by filling the blank: During a bout with the flu, an 80-kg person ran a fever of 39 oC. Consider that the specific heat of any human body is 3470 J/kg K, how much energy does the body need to burn to reach the fever temperature? The answer (in fundamental SI unit) is ___________ (type the numeric value only, dont use scientific notation)arrow_forwardOn a cold winter day when the temperature is -20.0 ∘C, what is the amount of heat needed to warm to internal body temperature (37.0∘C) the 0.550 L of air exchanged with each breath? Assume that the specific heat capacity of air is 1020 J/(kg⋅K) and that 1.0 L of air has a mass of 1.3 g. Express your answer in joules. How much heat is lost per hour if the respiration rate is 19.0 breaths per minute?arrow_forwardThe quantity of energy Q transferred by heat conduction through an insulating pad in time interval Δt is described by Q/Δt = κAΔT/d, where κ is the thermal conductivity of the material, A is the face area of the pad (perpendicular to the direction of heat flow), ΔT is the difference in temperature across the pad, and d is the thickness of the pad. In one trial to test material as lining for sleeping bags, 86.0 J of heat is transferred through a 3.40-cm-thick pad when the temperature on one side is 37.0°C and on the other side is 2.00°C. In a trial of the same duration with the same temperatures, how much heat will be transferred when more of the material is added to form a pad with the same face area and total thickness 8.41 cm?arrow_forward
- Show that the thickness of the ice on a lake increases with the square root of the time in cold weather, making the following simplifying assumptions. Let the water temperature be a constant 10◦C, the air temperature a constant −10◦, and assumethat at any given time the ice forms a slab of uniform thickness x. The rate of formation of ice is proportional to the rate at which heat is transferred from the water to the air. Let t = 0 when x = 0arrow_forwardOn a hot dry day, evaporation from a lake has just enough heat transfer to balance the 1.00 kW/m2 of incoming heat from the Sun. What mass of water evaporates in 1.00 h from each square meter?arrow_forwardAn engineer who is working on the heat transfer analysis of a house in English units needs the convection heat transfer coefficient on the outer surface of the house. But the only value he can find from his handbooks is 22 W/m2·K, which is in SI units. The engineer does not have a direct conversion factor between the two unit systems for the convection heat transfer coefficient. Using the conversion factors between W and Btu/h, m and ft, and °C and °F, express the given convection heat transfer coefficient in Btu/h·ft2·°F.arrow_forward
- An aluminum wire is wrapped in rubber insulation. Both are subject to thermal expansion, with the following coefficients of linear expansion: alphaa=24· 10−6 1/C and alphar=8· 10−5 1/C . If the wire and insulation are the same length of 1.85m at a temperature of20.00°C, what is the difference in length (in MILLIMETERS) between the copper wire and the rubber insulation when heated up to a temperature of 189.00°C? Express a magnitude only (no negatives!). ______mm (MILLIMETERS!)arrow_forwardA 2-m * 1.5-m section of wall of an industrial furnaceburning natural gas is not insulated, and the temperatureat the outer surface of this section is measured to be 80°C.The temperature of the furnace room is 30°C, and the combinedconvection and radiation heat transfer coefficient at thesurface of the outer furnace is 10 W/m2·K. It is proposed toinsulate this section of the furnace wall with glass wool insulation(k = 0.038 W/m·K) in order to reduce the heat lossby 90 percent. Assuming the outer surface temperature ofthe metal section still remains at about 110°C, determine thethickness of the insulation that needs to be used.The furnace operates continuously and has an efficiency of78 percent. The price of the natural gas is $1.10/therm (1 therm =105,500 kJ of energy content). If the installation of the insulationwill cost $250 for materials and labor, determine how long it willtake for the insulation to pay for itself from the energy it saves.arrow_forwardA window measures 1.5 m by 0.2 m and the single pane of glass is 0.3 cm thick. The outside temperature is 39 deg C and the inside temperature is 20 deg C, Find the rate of heat flow (that is, find Q/t) as heat travels through the window, and give as a positive answer. The glass has a thermal conductivity (k) of 0.8 W/(m degC) .arrow_forward
- a solid block of iron at 220 C is set on the floor of a foundry at 35 C. What will the block's temperature after sitting on the floor for 20 min? Given that the rate constants for iron in the situtaion is k = .054 min-1. Newtons law of cooling: dT/dt = -K (T-Ta) substitute y=T-Ta to make the equation separable.arrow_forwardConsider a 3-m-high rectangular enclosure consisting of two surfaces separated by a 0.1-m air gap at 1 atm. If the surface temperatures across the air gap are 30°C and –10°C, determine the ratio of the heat transfer rate for the horizontal orientation (with hotter surface at the bottom) to that for vertical orientation.arrow_forwardYou measure a rod with a steel ruler at 20◦C, finding the length of the rod to be 15.78 cm. You place both the rod and the ruler in a 300◦C oven and see that the rod now measures to be 15.85 cm long. What is the coefficient of linear expansion for the material out of which the rod is made? What will the actual rod length be, considering the ruler also expanded in the heat?arrow_forward
arrow_back_ios
SEE MORE QUESTIONS
arrow_forward_ios
Recommended textbooks for you
College PhysicsPhysicsISBN:9781305952300Author:Raymond A. Serway, Chris VuillePublisher:Cengage Learning
University Physics (14th Edition)PhysicsISBN:9780133969290Author:Hugh D. Young, Roger A. FreedmanPublisher:PEARSON
Introduction To Quantum MechanicsPhysicsISBN:9781107189638Author:Griffiths, David J., Schroeter, Darrell F.Publisher:Cambridge University Press
Physics for Scientists and EngineersPhysicsISBN:9781337553278Author:Raymond A. Serway, John W. JewettPublisher:Cengage Learning
Lecture- Tutorials for Introductory AstronomyPhysicsISBN:9780321820464Author:Edward E. Prather, Tim P. Slater, Jeff P. Adams, Gina BrissendenPublisher:Addison-Wesley
College Physics: A Strategic Approach (4th Editio...PhysicsISBN:9780134609034Author:Randall D. Knight (Professor Emeritus), Brian Jones, Stuart FieldPublisher:PEARSON
College Physics
Physics
ISBN:9781305952300
Author:Raymond A. Serway, Chris Vuille
Publisher:Cengage Learning
University Physics (14th Edition)
Physics
ISBN:9780133969290
Author:Hugh D. Young, Roger A. Freedman
Publisher:PEARSON
Introduction To Quantum Mechanics
Physics
ISBN:9781107189638
Author:Griffiths, David J., Schroeter, Darrell F.
Publisher:Cambridge University Press
Physics for Scientists and Engineers
Physics
ISBN:9781337553278
Author:Raymond A. Serway, John W. Jewett
Publisher:Cengage Learning
Lecture- Tutorials for Introductory Astronomy
Physics
ISBN:9780321820464
Author:Edward E. Prather, Tim P. Slater, Jeff P. Adams, Gina Brissenden
Publisher:Addison-Wesley
College Physics: A Strategic Approach (4th Editio...
Physics
ISBN:9780134609034
Author:Randall D. Knight (Professor Emeritus), Brian Jones, Stuart Field
Publisher:PEARSON
Thermodynamics: Crash Course Physics #23; Author: Crash Course;https://www.youtube.com/watch?v=4i1MUWJoI0U;License: Standard YouTube License, CC-BY