Fundamentals of Heat and Mass Transfer
7th Edition
ISBN: 9780470501979
Author: Frank P. Incropera, David P. DeWitt, Theodore L. Bergman, Adrienne S. Lavine
Publisher: Wiley, John & Sons, Incorporated
expand_more
expand_more
format_list_bulleted
Question
Chapter 6, Problem 6.75P
To determine
The power required to maintain the sphere at temperature
Expert Solution & Answer
Want to see the full answer?
Check out a sample textbook solutionStudents have asked these similar questions
How does an increase in gas temperature affect pressure drop in a haghouse, assuming the mass flow rate of particles and the molar flow rate of gas are constant?
9. What is diffusion and convection? Provide an example for each!
In a falling-film evaporator, Air at 40℃ and 50 kPa flows through a wetted-wall column with 100 mm diameter at a velocity of 5 m/s. What is the mass-transfer coefficient for the humidification of this stream by evaporation from the wet walls? If the air in this situation is 50 % saturated, and the saturation particle pressure of water vapour at 40℃ is 7375 Pa, what is the local evaporation flux in a unit of kg/m²s?
Chapter 6 Solutions
Fundamentals of Heat and Mass Transfer
Ch. 6 - The temperature distribution within a laminar...Ch. 6 - In flow over a surface, velocity and temperature...Ch. 6 - In a particular application involving airflow over...Ch. 6 - Water at a temperature of T=25C flows over one of...Ch. 6 - For laminar flow over a flat plate, the local heat...Ch. 6 - A flat plate is of planar dimension 1m0.75m. For...Ch. 6 - Parallel flow of atmospheric air over a flat plate...Ch. 6 - For laminar free convection from a heated vertical...Ch. 6 - A circular. hot gas jet at T is directed normal to...Ch. 6 - Experiments have been conducted to determine local...
Ch. 6 - A concentrating solar collector consists of a...Ch. 6 - Air at a free stream temperature of T=20C is in...Ch. 6 - The heat transfer rate per unit width (normal to...Ch. 6 - Experiments to determine the local convection heat...Ch. 6 - An experimental procedure for validating results...Ch. 6 - If laminar flow is induced at the surface of a...Ch. 6 - Consider the rotating disk of Problem 6.16. A...Ch. 6 - Consider airflow over a flat plate of length L=1m...Ch. 6 - A fan that can provide air speeds up to 50 m/s is...Ch. 6 - Consider the flow conditions of Example 6.4 for...Ch. 6 - Assuming a transition Reynolds number of 5105,...Ch. 6 - To a good approximation, the dynamic viscosity the...Ch. 6 - Prob. 6.23PCh. 6 - Consider a laminar boundary layer developing over...Ch. 6 - Consider a laminar boundary layer developing over...Ch. 6 - Experiments have shown that the transition from...Ch. 6 - An object of irregular shape has a characteristic...Ch. 6 - Experiments have shown that, for airflow at T=35C...Ch. 6 - Experimental measurements of the convection heat...Ch. 6 - To assess the efficacy of different liquids for...Ch. 6 - Gases are often used instead of liquids to cool...Ch. 6 - Experimental results for heat transfer over a flat...Ch. 6 - Consider conditions for which a fluid with a free...Ch. 6 - Consider the nanofluid of Example 2.2. Calculate...Ch. 6 - For flow over a flat plate of length L, the local...Ch. 6 - For laminar boundary layer flow over a flat plate...Ch. 6 - Sketch the variation of the velocity and thermal...Ch. 6 - Consider parallel flow over a flat plate for air...Ch. 6 - Forced air at T=25C and V=10m/s is used to cool...Ch. 6 - Consider the electronic elements that are cooled...Ch. 6 - Consider the chip on the circuit board of Problem...Ch. 6 - A major contributor to product defects in...Ch. 6 - A microscale detector monitors a steady flow...Ch. 6 - A thin, flat plate that is 0.2m0.2m on a side is...Ch. 6 - Atmospheric air is in parallel flow...Ch. 6 - Determine the drag force imparted to the top...Ch. 6 - For flow over a flat plate with an extremely rough...Ch. 6 - A thin, flat plate that is 0.2m0.2m on a side with...Ch. 6 - As a means of preventing ice formation on the...Ch. 6 - A circuit board with a dense distribution of...Ch. 6 - On a summer day the air temperature is 27C and the...Ch. 6 - It is observed that a 230-mm-diameter pan of water...Ch. 6 - The rate at which water is lost because of...Ch. 6 - Photosynthesis, as it occurs in the leaves of a...Ch. 6 - Species A is evaporating from a flat surface into...Ch. 6 - Prob. 6.57PCh. 6 - Prob. 6.58PCh. 6 - An object of irregular shape has a characteristic...Ch. 6 - Prob. 6.60PCh. 6 - An object of irregular shape 1 m long maintained...Ch. 6 - Prob. 6.62PCh. 6 - Prob. 6.63PCh. 6 - Prob. 6.64PCh. 6 - Prob. 6.65PCh. 6 - A streamlined strut supporting a bearing housing...Ch. 6 - Prob. 6.67PCh. 6 - Consider the conditions of Problem 6.7, for which...Ch. 6 - Using the naphthalene sublimation technique. the...Ch. 6 - Prob. 6.70PCh. 6 - Prob. 6.71PCh. 6 - Prob. 6.72PCh. 6 - Dry air at 32C flows over a wetted (water) plate...Ch. 6 - Dry air at 32C flows over a wetted plate of length...Ch. 6 - Prob. 6.75PCh. 6 - Prob. 6.76PCh. 6 - Prob. 6.77PCh. 6 - An expression for the actual water vapor partial...Ch. 6 - A mist cooler is used to provide relief for a...Ch. 6 - A wet-bulb thermometer consists of a...Ch. 6 - Prob. 6.81PCh. 6 - Prob. 6.83PCh. 6 - An experiment is conducted to determine the...Ch. 6 - Prob. 6.85PCh. 6 - Consider the control volume shown for the special...Ch. 6 - Prob. 6S.2PCh. 6 - Prob. 6S.3PCh. 6 - Consider two large (infinite) parallel plates, 5...Ch. 6 - Prob. 6S.5PCh. 6 - Consider Couette flow for which the moving plate...Ch. 6 - A shaft with a diameter of 100 mm rotates at 9000...Ch. 6 - Consider the problem of steady, incompressible...Ch. 6 - Prob. 6S.11PCh. 6 - A simple scheme for desalination involves...Ch. 6 - Consider the conservation equations (6S.24) and...
Knowledge Booster
Learn more about
Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.Similar questions
- Air at 25°C and atmospheric pressure flows with a velocity of 3 m/s inside a 10mm diameter tube of 1 m length. The inside surface of the tube contains a deposit of naphthalene. Determine the average mass transfer coefficient for the transfer of naphthalene from the pipe surface into the air.arrow_forwardAir at 100 Fahrenheit and 2 atm is being passed over a shallow bed of naphthalene spheres that are 0.5 inch in diameter at a superficial velocity (v0) of 5 fts^-1. The MW of naphthalene is 128.2 g mol^-1, and it’s diffusivity in air at these operating conditions is 0.033 cm^2s^-1. The porosity of the bed is 0.40, and the total surface area of the naphthalene particles is 86.3 ft^2 for each 1 ft^3 of packed bed.The viscosity of air under these conditions is 0.0184 cP and the density of air is 0.0023 g cm^-3. The equilibrium concentration of naphthalene in the air under these conditions is 0.006 mol L^-1. Assuming the concentration of the naphthalene in the air stream is negligible, estimate the initial evaporation rate of the naphthalene in pounds per second from 1 ft^3 of bed.arrow_forwardCalculate the time taken for a 7 um radius cloud droplet to grow via condensation into a 3500 um rain droplet. Assume a super-saturation of 1.55%, a water vapour density of 3 g m-3, and a water vapour diffusion coefficient in dry air of D=24 x10-6 m2 S -1 PLEASE SHOW CALCULATIONarrow_forward
- How is storage modulus and loss modulus relate with diffussivity of a drug molecule pass through a gel? Does higher storage modulus means lower difussivity?arrow_forwardA nuclear power station is situated in Coal Valley, which is a roughly rectangular valley that is 5 km long, 2 km wide, and 200 m deep. You have been asked to evaluate the effects of a worst-case scenario where the reactor housing fails, and radiation is released to the atmosphere. In your evaluation, you determine that 120 kg of Iodine-131 (a radioisotope that causes thyroid gland and liver damage) could be released into the atmosphere. Assuming the release of Iodine-131 was very rapid and all of it was uniformly distributed through the valley’s atmosphere with none escaping the valley, what would the concentration of Iodine-131 be in the valley’s air? Your answer should be expressed in units of ppm(v), and you may assume an atmospheric pressure of 1.0 atm and a temperature of 20oC. 2. Assuming the Iodine-131 concentration you calculated in part (a) is the initial concentration in the valley, you now want to determine the time it will take for the concentration to decrease to…arrow_forwardIs latent heat load of infiltration necessarily zero when the humidity ratio (absolute humidity) of the hot outside air in summer is the same as that of inside air? Explain.arrow_forward
- If the air temperature at 18:00h is 8 C, and the air adjacent to the surface has a relative humidity of 70%, at what time will condensation occur if the evening cooling rate is 1 C/hour? Will the condensation be in the form of dew or frost?arrow_forwardThermal energy generated by the electrical resistance of a 5-mm-diameter and 4-m-long bare cable is dissipated to the surrounding air at 80°C. The voltage drop and the electric current across the cable in steady operation are measured to be 20.0 V and 4.5 A, respectively. Disregarding radiation, estimate the surface temperature of the cable. Evaluate air properties at a film temperature of 100°C and 1 atm pressure.arrow_forwardYou are asked to determine the concentration of a diffusing gas at a given depth on a metal surface after a given time. If you know the temperature of the metal, the surface concentration of the gas, and the diffusion coefficient, describe how you would approach this problem.arrow_forward
- Insulation degrades (experiences an increase in thermal conductivity) if it is subjected to water vapor condensation. The problem may occur in home insulation during cold periods, when vapor in a humidified room diffuses through the drywall (plaster board) and condenses in the adjoining insulation. Estimate the mass diffusion rate for a 3 m × 4 m wall, under conditions for which the vapor pressure is 0.035 bar in the room air and 0.0 bar in the insulation. The drywall is 15 mm thick, and the solubility of water vapor in the wall material is approximately 5 × 10−3 kmol/m3 ⋅ bar. The binary diffusion coefficient for water vapor in the drywall is approximately 10−9 m2/s.arrow_forwardCalculate the Cunningham correction factor for a particle with a 0.03-micron diameter in air at 1 atm pressure and 0 °C.arrow_forwardOxygen gas at a temperature of 27°C at atmospheric pressure flows in parallel at 20 m/s over a square thin plate with a side of 10 cm. Since the plate is held at 127°C, what is the heat transfer from the plate to the fluid? Heat transfer (W) takes place from only one surface of the platearrow_forward
arrow_back_ios
SEE MORE QUESTIONS
arrow_forward_ios
Recommended textbooks for you
- Principles of Heat Transfer (Activate Learning wi...Mechanical EngineeringISBN:9781305387102Author:Kreith, Frank; Manglik, Raj M.Publisher:Cengage Learning
Principles of Heat Transfer (Activate Learning wi...
Mechanical Engineering
ISBN:9781305387102
Author:Kreith, Frank; Manglik, Raj M.
Publisher:Cengage Learning
Heat Transfer – Conduction, Convection and Radiation; Author: NG Science;https://www.youtube.com/watch?v=Me60Ti0E_rY;License: Standard youtube license