A pharmacist prepares 80 mL of an isotonic solution of 1.1 %w/v Lidocaine HCl (E-value 0.2). To prepare the solution, he dissolves Lidocaine HCl in purified water to make an isotonic solution. Then he dilutes the Lidocaine HCl solution with 0.9%w/v sterile sodium chloride to complete the formulation. How many milliliters of purified water is needed to make the formulation by this method?

A pharmacist prepares 80 mL of an isotonic solution of 1.1 %w/v Lidocaine HCl (E-value 0.2). To prepare the solution, he dissolves Lidocaine HCl in purified water to make an isotonic solution. Then he dilutes the Lidocaine HCl solution with 0.9%w/v sterile sodium chloride to complete the formulation. How many milliliters of purified water is needed to make the formulation by this method?

Biomedical Instrumentation Systems

1st Edition

ISBN:9781133478294

Author:Chatterjee

Publisher:Chatterjee

Chapter19: Biomedical Laboratory Instrumentation

Section: Chapter Questions

Problem 7P

See similar textbooks

Similar questions

Given a BSA stock solution of 4mg/mL how would you prepare a 5 mL sample with a final concentration of 1 mg/mL?
A 2.5mg/ml solution of ampicillin is available for use, what volume would youadd to 200ml of LB medium to obtain a final concentration of 50µg/ml ofampicillin?
Using absorbance readings and a standard curve relating absorbance to cell number, you suspect that a bacterial culture contains 7.4 x 109 CFUs/ml. What dilution of this sample would give you a countable plate?
If a 250 ml solution of ethanol in water is prepared with 4 ml of absolute ethanol (100%), what is the dilution factor?
Solution Absorbance mg/ml aspirin Standard solution - 1.6 mg/mL A 0.638 0.08 mg/mL B 0.504 0.064 mg/mL C 0.376 0.048 mg/mL D 0.259 0.032 mg/mL E 0.126 0.016 mg/mL A = -log T where T = %T ÷ 100 Construct a callibration curve using the above data. Absorbance should be on the vertical axis and "mg/mL of acetylsalicylic acid" on the horizontal axis. The line should go through the origin. Using the data provided, the graph you have generated, and the procedure that was used to generate the solutions which were examined by spectroscopy, calculate the amount of acetylsalicylic acid per tablet. Commercial tablet 1 labelled as 100 mg enteric coated Absorbance = 0.16 Commercial tablet 2 labelled as 300 mg Absorbance = 0.45 Student prepared tablet from practical 5 Absorbance = 0.19 Using the data provided, the graph you have generated, and the procedure that was used…
If you have 50 ml of pure stock formalin solution how many ml of diluent will you need? What is the total volume of the reagent used you have prepared? Write down your answers with complete solutions and correct labels.
You have a 20 mg/mL stock solution of the amino acid arginine and need to make plates containing arginine at a concentration of 10 micrograms/mL. How much of the stock solution do you add to 1 liter of plate media?
The physician has ordered 500,00 units of IV Pfizerpen every 4 hours. How much diluent will you add for a concentration of 500,000 units/mL? How many milliliters will you administer?
4 mL of 10% TCA solution was added to 1 mL of serum and after mixing, it was waited for two minutes and filtered through non-phosphorus filter paper. 1 mL of the filtrate was taken and 13 mL of distilled water, 4 mL of sulfomolybdic acid and 2 mL of dilute SnCl2 solution were added and mixed, and after waiting for 15 minutes, the absorbances of the obtained solutions against pure water at 520 nm were read. If the function of the calibration graph obtained with 0.5-2.5 mg/mL standard phosphorus solutions is y= 0.245x + 0.107 and the absorbance value of the serum sample is 0.109, what is the amount of phosphorus in the sample?
The pH probe/meter uses following equations: Ecell = L + 0.0592 log a1 = L - 0.0592 pH Where L = L1 + EAg/AgCI + Easy= constants L1 = - 0.0592 log a2 a1 = activity of analyte solution a2 = activity of internal solution How will measured pH value be affected vs “real” pH if the temperature of the sample is 30C when pH was measured ? a.measured pH is lower than real pH b.impact can not be determined c.measured pH is higher than real pH d.measured pH is same as real pH
What concentration of ethanol is considered optimum for disinfectant? Why not 100%?